A Suezmax oil tanker, Seavigour, in 2017 | |
General characteristics | |
---|---|
Tonnage | typically 160,000 DWT |
Length | 400 m (1,300 ft) (maximum) |
Beam | 77.5 metres (254 ft) (maximum); 50 m (164 ft) (at 20.1 m draft) |
Height | 68 m (223 ft) (maximum) |
Draft | 20.1 m (66 ft) (maximum) |
"Suezmax" is a naval architecture term for the largest ship measurements capable of transiting the Suez Canal in a laden condition, and is almost exclusively used in reference to tankers. The limiting factors are beam, draft, height (because of the Suez Canal Bridge), and length [1] (even though the canal has no locks).
The current channel depth of the canal allows for a maximum of 20.1 metres (66 ft) of draft, [2] meaning that a few fully laden supertankers are too deep to fit through, and either have to unload part of their cargo to other ships ("transhipment") or to a pipeline terminal before passing through, or alternatively avoid the Suez Canal and travel around Cape Agulhas instead. The canal was deepened in 2009, increasing the draft from 18 to 20 metres (59 to 66 ft).
The typical deadweight of a Suezmax ship is about 160,000 tons; the typical beam (width) is about 48 m (157.5 ft). Also of note is the maximum head room—"air draft"—limitation of 68 m (223.1 ft), resulting from the 70-metre (230 ft) height above water of the Suez Canal Bridge. Suez Canal Authority produces tables of width and acceptable draft, which are subject to change. [1] From 2010, the wetted surface cross sectional area of the ship is limited by 1,006 m2 (10,830 sq ft), which means 20.1 metres (66 ft) of draft for ships with the beam no wider than 50.0 metres (164.0 ft) or 12.2 metres (40 ft) of draft for ships with maximum allowed beam of 77.5 metres (254 ft). [3]
The similar terms Panamax, Malaccamax, and Seawaymax are used for the largest ships capable of fitting through the Panama Canal, the Strait of Malacca and Saint Lawrence Seaway, respectively. The term "Chinamax" refers to vessels able to use a number of harbours while fully laden. "Capesize" refers to bulk carriers too big to pass through the Suez Canal—and needing to travel the Cape route around the Cape of Good Hope and Cape Agulhas—but recent dredging means many Capesize vessels can use the canal. Plans to deepen the draft to 21 metres (70 ft) could lead to a redefinition of the Suezmax specification, as happened to the Panamax specification after deepening and widening of the Panama Canal.
Aframax is a freight rating, not a geographic routing limiter, for tankers are those with a capacity of 80,000 tonnes deadweight (DWT) to 120,000 DWT.
Vessels longer than 400 metres (1,300 ft) need permission from the Suez Canal Authority to transit the canal. As of 2020, the largest container ships in service all have a length of (close to) 400 metres, and a beam and draft that fit just within the limits of the canal. [4] [5] The ship Ever Given, which ran aground in the Canal in 2021, has Suezmax size being 399.9 metres long and with a 58.8-metre (193 ft) beam. [6]
A container ship is a cargo ship that carries all of its load in truck-size intermodal containers, in a technique called containerization. Container ships are a common means of commercial intermodal freight transport and now carry most seagoing non-bulk cargo.
Panamax and New Panamax are terms for the size limits for ships travelling through the Panama Canal. The limits and requirements are published by the Panama Canal Authority (ACP) in a publication titled "Vessel Requirements". These requirements also describe topics like exceptional dry seasonal limits, propulsion, communications, and detailed ship design.
A cargo ship or freighter is a merchant ship that carries cargo, goods, and materials from one port to another. Thousands of cargo carriers ply the world's seas and oceans each year, handling the bulk of international trade. Cargo ships are usually specially designed for the task, often being equipped with cranes and other mechanisms to load and unload, and come in all sizes. Today, they are almost always built of welded steel, and with some exceptions generally have a life expectancy of 25 to 30 years before being scrapped.
A bulk carrier or bulker is a merchant ship specially designed to transport unpackaged bulk cargo—such as grain, coal, ore, steel coils, and cement—in its cargo holds. Since the first specialized bulk carrier was built in 1852, economic forces have led to increased size and sophistication of these ships. Today's bulk carriers are specially designed to maximize capacity, safety, efficiency, and durability.
Capesize ships are the largest dry cargo ships with ball mark dimension: about 170,000 DWT capacity, 290 m long, 45 m beam (wide), 18m draught. They are too large to transit the Suez Canal or Panama Canal, and so have to pass either Cape Agulhas or Cape Horn to traverse between oceans.
Malaccamax is a naval architecture term for the largest tonnage of ship capable of fitting through the 25-metre-deep (82 ft) Strait of Malacca. Bulk carriers and supertankers have been built to this tonnage, and the term is chosen for very large crude carriers (VLCC). They can transport oil from Arabia to China. A typical Malaccamax tanker can have a maximum length of 333 m (1,093 ft), beam of 60 m (197 ft), draught of 20.5 m (67.3 ft), and tonnage of 300,000 DWT.
The draft or draught of a ship is a determined depth of the vessel below the waterline, measured vertically to its hull's lowest—its propellers, or keel, or other reference point. Draft varies according to the loaded condition of the ship. A deeper draft means the ship will have greater vertical depth below the waterline. Draft is used in under keel clearance calculations, where the draft is calculated with the available depth of water to ensure the ship can navigate safely, without grounding. Navigators can determine their draught by calculation or by visual observation.
An oil tanker, also known as a petroleum tanker, is a ship designed for the bulk transport of oil or its products. There are two basic types of oil tankers: crude tankers and product tankers. Crude tankers move large quantities of unrefined crude oil from its point of extraction to refineries. Product tankers, generally much smaller, are designed to move refined products from refineries to points near consuming markets.
Portline Transportes Marítimos Internacionais, SA., often simply called Portline is a Portuguese shipping company. The company has diverse business activities, including dry bulk, containerised, and break-bulk cargo shipping, shipping agency, forwarding and logistics services, ship management and manning, ship brokerage and chartering, and a container depot service.
Ship measurements consist of a multitude of terms and definitions specifically related to ships and measuring or defining their characteristics.
Monte Cervantes is a container ship owned by A.P. Moller Singapore Pte. Ltd. and operated by Maersk Line AS. The 272-metre (892 ft) long ship was built at Daewoo Shipbuilding & Marine Engineering in Okpo, South Korea in 2004. Originally owned by Reederei Monte GmbH & Co KG, a subsidiary of Hamburg Süd, she has had two owners and been registered under three flags.
Chinamax is a standard of ship measurements that allow conforming ships to use various harbours when fully laden, the maximum size of such a ship being 24 m (79 ft) draft, 65 m (213 ft) beam and 360 m (1,180 ft) length overall. An example of ships of this size is the Valemax bulk carriers.
Baltimax is a naval architecture term for the largest ship measurements capable of entering and leaving the Baltic Sea in a laden condition.
The European-Asian sea route, commonly known as the sea route to India or the Cape Route, is a shipping route from the European coast of the Atlantic Ocean to Asia's coast of the Indian Ocean passing by the Cape of Good Hope and Cape Agulhas at the southern edge of Africa. The first recorded completion of the route was made in 1498 by Portuguese explorer Vasco da Gama, the admiral of the first Portuguese Armadas bound eastwards to make the discovery. The route was important during the Age of Sail, but became partly obsolete as the Suez Canal opened in 1869.
Sanchi was the final name of a 2008-built Panamanian-flagged Suezmax crude oil tanker that was operated by the National Iranian Tanker Company (NITC) under a variety of ship registries and names. On January 6, 2018, it collided with a cargo ship, CF Crystal in the East China Sea and caught fire with 32 deaths or missing and 130,000 tons of condensate spilled. After drifting for eight days and several explosions Sanchi sank, causing extensive pollution.
Monte Olivia is a container ship owned by A.P. Moller Singapore Pte. Ltd. and operated by Maersk Line AS. The 272-metre long ship was built at Daewoo Shipbuilding & Marine Engineering in Okpo, South Korea in 2004. Originally owned by Reederei Monte GmbH & Co KG, a subsidiary of Hamburg Süd, she has had two owners and been registered under two flags.
Monte Rosa is a container ship owned by A.P. Moller Singapore Pte. Ltd. and operated by Maersk Line AS. The 272-metre (892 ft) long ship was built at Daewoo Shipbuilding & Marine Engineering in Okpo, South Korea in 2004/2005. Originally owned by Monte Rosa GmbH & Co KG, a subsidiary of Hamburg Süd, she has had three owners and been registered under two flags.
Monte Alegre is a container ship owned by A.P. Moller Singapore Pte. Ltd. and operated by Maersk Line AS. The 272-metre (892 ft) long ship was built at Daewoo Mangalia Heavy Industries in Mangalia, Romania in 2007/2008. Originally owned by Monte Alegre GmbH & Co KG, a subsidiary of Hamburg Süd, she has had two owners and been registered under two flags.
Keni Port is a proposed deep-sea port at Keni village in Uttara Kannada district of Karnataka. The Karnataka Maritime Board signed an agreement with JSW Infrastructure in November 2023 to build the port. It is estimated that the port will be constructed at a cost of more than ₹4 thousand crore.