This article may be too technical for most readers to understand.(February 2022) |
The vortex ring state (VRS) is a dangerous aerodynamic condition that may arise in helicopter flight, when a vortex ring system engulfs the rotor, causing severe loss of lift. Often the term settling with power is used as a synonym, e.g., in Australia, the UK, and the US, [2] [3] [4] but not in Canada, which uses the latter term for a different phenomenon. [5]
A vortex ring state sets in when the airflow around a helicopter's main rotor assumes a rotationally symmetrical form over the tips of the blades, supported by a laminar flow over the blade tips, and a countering upflow of air outside and away from the rotor. In this condition, the rotor falls into a new topological state of the surrounding flow field, induced by its own downwash, and suddenly loses lift. Since vortex rings are a surprisingly stable fluid dynamical phenomena (a form of topological soliton), the best way to recover from them is to laterally steer clear of them, in order to re-establish lift, and to break them up using maximum engine power, in order to establish turbulence.
This is also why the condition is often mistaken for "settling with insufficient power": high-powered maneuvers can both induce a vortex ring state in free air, and then at low altitude, during landing conditions, possibly break it. If sufficient power is not available to maintain the airfoil of the rotor at a stalled condition, while generating sufficient lift, the aircraft will not be able to stay aloft before the vortex ring state dissipates, and will crash.
This condition also occurs with tiltrotors, and it was responsible for an accident involving a V-22 Osprey in 2000. Vortex ring state caused the loss of a heavily modified MH-60 helicopter during Operation Neptune Spear, the 2011 raid in which Osama bin Laden was killed. [6]
Because the blades are rotating about a central axis, the speed of each airfoil is lowest at the point where it connects to the hub-and-grip assembly. This fundamental physical reality means that the innermost portion of each blade has an inherent vulnerability to stalling.[ citation needed ]
In forward flight with translational lift, there is no upward flow (upflow) of air in the hub area. As forward airspeed decreases and vertical descent rates increase, an upflow begins simply because there are no airfoil surfaces in the area of the hub, mast and blade-grip assembly.[ citation needed ]
Then, as the volume of upflow increases in the central region (i.e. between the hub and the innermost edges of the airfoils), the induced flow (air pulled or "induced" downwards through the rotor system) of the inner blade sections is overcome. This causes the innermost portions of the blades to begin to stall.[ citation needed ]
As the inner blade sections stall, a second set of vortices, similar to the rotor-tip vortices, begins to form in and around the center of the rotor system. This, combined with the outer set of vortices, results in severe loss of lift. The failure of a helicopter pilot to recognize and react to the condition can lead to high descent rates and catastrophic ground impact. [1]
A helicopter normally encounters this condition when attempting to hover out-of-ground-effect (OGE) without maintaining precise altitude control, and while making downwind or steep, powered approaches when the airspeed is below Effective Translational Lift (ETL). [7]
The signs of VRS are a vibration in the main rotor system [8] followed by an increasing sink rate and possibly a decrease of cyclic authority. [9]
In single rotor helicopters, the vortex ring state is traditionally corrected by slightly lowering the collective to regain cyclic authority and using the cyclic control to apply lateral motion, often pitching the nose down to establish forward flight. In tandem-rotor helicopters, recovery is accomplished through lateral cyclic or pedal input or both. The aircraft will fly out of the vortex ring into "clean air", and will be able to regain lift. [1]
Another correction now widely known as the Vuichard Recovery Technique after gaining recent popularity, was taught by Claude Vuichard, a Federal Office for Civil Aviation (FOCA) inspector in Switzerland. This technique uses a combination of all three controls together to reduce altitude loss and recover more quickly: apply cyclic in the direction of tail rotor thrust, increase the collective to climb power, and coordinate with the power pedal to maintain heading (cross controls). Recovery is complete when the rotor disc reaches the upwind part of the vortex. [1] [10] [11] [12]
It is possible to power out of vortex ring state, but this requires having about twice the power it takes to hover. Only one full-scale helicopter, the Sikorsky S-64 Skycrane, is documented as being able to do this, when unladen. [13]
Helicopter pilots are most commonly taught to avoid VRS by monitoring their rates of descent at lower airspeeds. When encountering VRS, pilots are taught to apply forward cyclic to fly out of the condition and/or lowering collective pitch. [9] While transitioning to forward or lateral flight will alleviate the condition by itself, lowering the collective to reduce the power demand decreases the size of the vortices and reduces the amount of time required to be free of the condition. However, since the condition often occurs near the ground, lowering the collective may not be an option; a loss of altitude will occur proportional to the rate of descent developed before beginning the recovery. In some cases, vortex ring state is encountered and allowed to advance to the point that the pilot may severely lose cyclic authority due to the disrupted airflow. In these cases, the pilot's only recourse may be to enter an autorotation to break the rotor system free of its vortex ring state. [1]
In a tandem rotor helicopter, forward cyclic will not arrest the rate of descent caused by VRS. In such a helicopter, which utilizes differential collective pitch in order to gain airspeed, lateral cyclic inputs must be made accompanied by pedal inputs in order to slide horizontally out of the vortex ring state's disturbed air.[ citation needed ]
Radio controlled multirotors (common on drones) are subject to normal rotorcraft aerodynamics, including vortex ring state. Frame design, size and power affect the likelihood of entering the state and recovering from it. Multirotors that do not have altitude hold are also more likely to succumb to operator error, where the pilot drops the craft too fast resulting in the upwash at the rotor hubs that can lead to vortex ring state. Those that are equipped with that feature, on the other hand, tend to control their descent automatically and can usually (but not always) escape the dangerous condition. [14]
A tiltrotor is an aircraft that generates lift and propulsion by way of one or more powered rotors mounted on rotating shafts or nacelles usually at the ends of a fixed wing. Almost all tiltrotors use a transverse rotor design, with a few exceptions that use other multirotor layouts.
For fixed-wing aircraft, ground effect is the reduced aerodynamic drag that an aircraft's wings generate when they are close to a fixed surface. During takeoff, ground effect can cause the aircraft to "float" while below the recommended climb speed. The pilot can then fly just above the runway while the aircraft accelerates in ground effect until a safe climb speed is reached.
In fluid dynamics, a stall is a reduction in the lift coefficient generated by a foil as angle of attack exceeds its critical value. The critical angle of attack is typically about 15°, but it may vary significantly depending on the fluid, foil – including its shape, size, and finish – and Reynolds number.
Aviation is the design, development, production, operation, and use of aircraft, especially heavier-than-air aircraft. Articles related to aviation include:
Wake turbulence is a disturbance in the atmosphere that forms behind an aircraft as it passes through the air. It includes several components, the most significant of which are wingtip vortices and jet-wash, the rapidly moving gases expelled from a jet engine.
Retreating blade stall is a hazardous flight condition in helicopters and other rotary wing aircraft, where the retreating rotor blade has a lower relative blade speed, combined with an increased angle of attack, causing a stall and loss of lift. Retreating blade stall is the primary limiting factor of a helicopter's never exceed speed, VNE.
Helicopter flight controls are used to achieve and maintain controlled aerodynamic helicopter flight. Changes to the aircraft flight control system transmit mechanically to the rotor, producing aerodynamic effects on the rotor blades that make the helicopter move in a desired way. To tilt forward and back (pitch) or sideways (roll) requires that the controls alter the angle of attack of the main rotor blades cyclically during rotation, creating differing amounts of lift at different points in the cycle. To increase or decrease overall lift requires that the controls alter the angle of attack for all blades collectively by equal amounts at the same time, resulting in ascent, descent, acceleration and deceleration.
The tail rotor is a smaller rotor mounted vertically or near-vertically at the tail of a traditional single-rotor helicopter, where it rotates to generate a propeller-like horizontal thrust in the same direction as the main rotor's rotation. The tail rotor's position and distance from the helicopter's center of mass allow it to develop enough thrust leverage to counter the reactional torque exerted on the fuselage by the spinning of the main rotor. Without the tail rotor or other anti-torque mechanisms, the helicopter would be constantly spinning in the opposite direction of the main rotor when flying.
On a helicopter, the main rotor or rotor system is the combination of several rotary wings with a control system, that generates the aerodynamic lift force that supports the weight of the helicopter, and the thrust that counteracts aerodynamic drag in forward flight. Each main rotor is mounted on a vertical mast over the top of the helicopter, as opposed to a helicopter tail rotor, which connects through a combination of drive shaft(s) and gearboxes along the tail boom. The blade pitch is typically controlled by the pilot using the helicopter flight controls. Helicopters are one example of rotary-wing aircraft (rotorcraft). The name is derived from the Greek words helix, helik-, meaning spiral; and pteron meaning wing.
Translational lift is improved rotor efficiency resulting from directional flight in a helicopter. Translation is the conversion from the hover to forward flight. As undisturbed air enters the rotor system horizontally, turbulence and vortices created by hovering flight are left behind and the flow of air becomes more horizontal. The efficiency of the hovering rotor system is greatly improved with each knot of airspeed gained by horizontal movement of the aircraft or wind speed.
Dissymmetry of lift in rotorcraft aerodynamics refers to an unequal amount of lift on opposite sides of the rotor disc. It is a phenomenon that affects single-rotor helicopters and autogyros in forward flight.
A helicopter is a type of rotorcraft in which lift and thrust are supplied by horizontally spinning rotors. This allows the helicopter to take off and land vertically, to hover, and to fly forward, backward and laterally. These attributes allow helicopters to be used in congested or isolated areas where fixed-wing aircraft and many forms of short take-off and landing (STOL) or short take-off and vertical landing (STOVL) aircraft cannot perform without a runway.
Flapback or blowback is the tilting of a helicopter rotor disc, usually aft (backwards), which occurs in several circumstances.
Autorotation is a state of flight in which the main rotor system of a helicopter or other rotary-wing aircraft turns by the action of air moving up through the rotor, as with an autogyro, rather than engine power driving the rotor. The term autorotation dates to a period of early helicopter development between 1915 and 1920, and refers to the rotors turning without the engine. It is analogous to the gliding flight of a fixed-wing aircraft. Some trees have seeds that have evolved wing-like structures that enable the seed to spin to the ground in autorotation, which helps the seeds to disseminate over a wider area.
The Fairey FB-1 Gyrodyne is an experimental British rotorcraft that used single lifting rotor and a tractor propeller mounted on the tip of the starboard stub wing to provide both propulsion and anti-torque reaction.
A helicopter is susceptible to a rolling tendency, called dynamic rollover, when close to the ground, especially when taking off or landing. For dynamic rollover to occur, some factor has to first cause the helicopter to roll or pivot around a skid, or landing gear wheel, until its critical rollover angle is reached. Then, beyond this point, main rotor thrust continues the roll and recovery is impossible. If the critical rollover angle is exceeded, the helicopter rolls on its side regardless of the cyclic control corrections made.
Loss of tail-rotor effectiveness (LTE) occurs when the tail rotor of a helicopter is exposed to wind forces that prevent it from carrying out its function—that of cancelling the torque of the engine and transmission. Any low-airspeed high-power environment provides an opportunity for it to occur.
On 8 April 2000, a V-22 Osprey aircraft operated by the United States Marine Corps crashed during a night training exercise at Marana Regional Airport near Tucson, Arizona. The crash killed all 19 U.S. Marines on board and intensified debate about the reliability of the Osprey.
The 2016 Bell 525 Relentless prototype crash occurred during a test flight on July 6, 2016, near Italy, Texas, destroying the prototype Bell 525 Relentless helicopter and killing the two occupants. The helicopter broke up in flight while traveling about 229 mph (199 kn) at an altitude of about 2,000 feet (610 m); the main rotor contacted and severed the tail boom due to severe vertical oscillations. The crew were performing one engine inoperative (OEI) recovery testing; the test induced a scissors-mode vibration in the main rotor, which resulted in involuntary collective control input. The unintended biomechanical feedback loop exacerbated the vibration, until the rotor contacted the tail-boom.
In aviation, and in particular in helicopters, servo transparency, is a phenomenon affecting the servomechanisms that assist a helicopter's flight controls, which, in certain flight conditions, can result in a significant stiffening of the controls handled by the pilot. The effect, if not promptly recognised by the pilot, can be hazardous as it can lead to partial or total loss of control, which, if encountered at low altitude, could result in impact with terrain.
recognition and avoidance of settling with power/vortex ring state
Settling with power (vortex ring)
Vortex ring state (formerly referenced as settling-with- power) describes an aerodynamic condition in which a helicopter may be in a vertical descent with between 20 and 100 percent power applied, and little or no climb performance. The previously used term settling-with-power came from the fact that the helicopter keeps settling even though full engine power is applied.
{{citation}}
: CS1 maint: location missing publisher (link)