 | This article needs additional citations for verification .(January 2022) |
| C&O T-1 class | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
 T-1 locomotive No. 3021 operating in 1941 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
The Chesapeake and Ohio T-1 was a class of forty 2-10-4 steam locomotives built by the Lima Locomotive Works in Lima, Ohio in 1930 and operated until the early 1950s.
The Chesapeake and Ohio tested an Erie Railroad Berkshire locomotive, then stretched the design by adding one more driving axle, creating the 2-10-4. The T-1s were equipped with a trailing truck booster that exerted 15,275 pounds of tractive effort. They could pull the same train as a 2-8-8-2 H-7 and do it faster. The locomotives mainly operated between Russell, Kentucky to Toledo, Ohio, with a few ending up in eastern Virginia. They were rated at 13,500 tons or 160 loaded coal hoppers. They also sported the most heating surface of any two-cylinder steam locomotive, with a combined heating surface of 9,654 square feet (896.9 m2).
Despite their overall success, their long-wheelbase made it difficult to maintain a proper counterbalancing scheme as the drivers wore unevenly in service. Later in their careers, as their built up frames began to work loose, the T-1s rode roughly and pounded the track to the point that a special gang stood by at the bottom of one long grade to repair the damage. [1]
In 1942, the Pennsylvania Railroad based 125 of their J1 class 2-10-4s off of the T-1s with slight modifications.
On May 12, 1948, no. 3020 suffered a boiler explosion due to a low water level near Chillicothe, Ohio. The engineer, fireman and front brakeman were killed. [2]
The C&O began retiring the T-1 locomotives in 1952 in favor of diesel locomotives, and by 1953, all had been retired. None were preserved.
The Shay locomotive is a geared steam locomotive that originated and was primarily used in North America. The locomotives were built to the patents of Ephraim Shay, who has been credited with the popularization of the concept of a geared steam locomotive. Although the design of Ephraim Shay's early locomotives differed from later ones, there is a clear line of development that joins all Shays. Shay locomotives were especially suited to logging, mining and industrial operations and could operate successfully on steep or poor quality track.
The Mallet locomotive is a type of articulated steam railway locomotive, invented by the Swiss engineer Anatole Mallet (1837–1919).
Under the Whyte notation for the classification of steam locomotives, a 2-10-4 locomotive has two leading wheels on one axle, usually in a Bissel truck, ten coupled driving wheels on five axles, and four trailing wheels on two axles, usually in a bogie. These were referred to as the Texas type in most of the United States, the Colorado type on the Burlington Route, and the Selkirk type in Canada.
Under the Whyte notation for the classification of steam locomotives, 4-8-4 represents the wheel arrangement of four leading wheels on two axles, eight powered and coupled driving wheels on four axles and four trailing wheels on two axles. The type was first used by the Northern Pacific Railway, and initially named the Northern Pacific, but railfans and railroad employees have shortened the name since its introduction. It is most-commonly known as a Northern.
Under the Whyte notation for the classification of steam locomotives, 2-10-2 represents the wheel arrangement of two leading wheels, ten powered and coupled driving wheels, and two trailing wheels. In the United States of America and elsewhere the 2-10-2 is known as the Santa Fe type, after the Atchison, Topeka and Santa Fe Railway that first used the type in 1903.
Lima Locomotive Works was an American firm that manufactured railroad locomotives from the 1870s through the 1950s. The company took the most distinctive part of its name from its main shop's location in Lima, Ohio. The shops were located between the Erie Railroad main line, the Baltimore & Ohio's Cincinnati-Toledo main line and the Nickel Plate Road main line and shops.
Under the Whyte notation, a 2-8-4 is a steam locomotive that has two unpowered leading wheels, followed by eight coupled and powered driving wheels, and four trailing wheels. This locomotive type is most often referred to as a Berkshire, though the Chesapeake and Ohio Railway used the name Kanawha for their 2-8-4s. In Europe, this wheel arrangement was mostly seen in mainline passenger express locomotives and, in certain countries, in tank locomotives.
In 1948, 14 railroads in North America owned more than 1,000 steam locomotives each. See also: Historical sizes of railroads
The 2-6-6-6 is an articulated locomotive type with two leading wheels, two sets of six driving wheels and six trailing wheels. Only two classes of the 2-6-6-6 type were built. One was the "Allegheny" class, built by the Lima Locomotive Works. The name comes from the locomotive's first service with the Chesapeake and Ohio Railway beginning in 1941, where it was used to haul loaded coal trains over the Allegheny Mountains. The other was the "Blue Ridge" class for the Virginian Railway. These were some of the most powerful reciprocating steam locomotives ever built, at 7,500 hp, and one of the heaviest at 386 tons for the locomotive itself plus 215 tons for the loaded tender.
Chesapeake & Ohio 614 is a class "J-3-A" 4-8-4 "Greenbrier" (Northern) type steam locomotive built in June 1948 by the Lima Locomotive Works in Lima, Ohio for the Chesapeake and Ohio Railway (C&O) as a member of the J-3-A class. As one of the last commercially built steam locomotives in the United States, the locomotive was built with the primary purpose of hauling long, heavy, high speed express passenger trains for the Chesapeake & Ohio Railway such as the George Washington and the Fast Flying Virginian. Retired from active service in the late 1950s, the 614 was preserved and placed on display at the B&O Railroad Museum in Baltimore, Maryland. Between 1979 and 1980, restoration work on the locomotive to operating condition took place and it was used for extensive mainline excursion service from the early 1980s until the late 1990s. Since 2011, the locomotive has been on display at the C&O Railway Heritage Center in Clifton Forge, Virginia.
The Norfolk and Western Railway's M, M1 and M2 classes were a series of 4-8-0 steam locomotives owned and operated by the Norfolk and Western Railway.
Canadian Pacific 1278 is a class "G5d" 4-6-2 "Pacific" type steam locomotive built by the Canadian Locomotive Company for the Canadian Pacific Railway. After being retired from revenue service, the locomotive was purchased in 1965 by F. Nelson Blount for excursion trains at his Steamtown USA museum. The locomotive was sold to Gettysburg Railroad and operated excursion trains there. The No. 1278 was retired from excursion service in 1995 after a boiler explosion. As of 2023, the locomotive is on static display at the Age of Steam Roundhouse in Sugarcreek, Ohio.
The Fort Wayne Railroad Historical Society (FWRHS) is a non-profit group in New Haven, Indiana that is dedicated to the restoration and operation of the ex-Nickel Plate Railroad's steam locomotive no. 765 and other vintage railroad equipment. Since restoration, the 765 was added to the National Register of Historic Places as no. 96001010 on September 12, 1996 and has operated excursion trains across the Eastern United States. In 2012, the FWRHS's steam locomotive no. 765 was added to the Norfolk Southern's 21st Century Steam program.
The General Electric steam turbine locomotives were two steam turbine locomotives built by General Electric (GE) for Union Pacific (UP) in 1938. The two units were streamlined, 90 feet 10 inches (27.69 m) in length, capable of producing 2,500 horsepower (1,900 kW), and reputedly able to attain speeds of 125 miles per hour (201 km/h). Stylistically, they resembled UP's Pullman-designed M-10003 through M-10006 power units and contemporary Electro-Motive Corporation (EMC) diesel designs.
The Chesapeake and Ohio Railway's K-4 class were a group of ninety 2-8-4 steam locomotives purchased during and shortly after World War II. Unlike many other railroads in the United States, the C&O chose to nickname this class "Kanawha", after the river in West Virginia, rather than "Berkshire", after the region in New England.
Western Maryland Scenic Railroad 1309 is a compound articulated class "H-6" "Mallet" type steam locomotive with a 2-6-6-2 wheel arrangement. It was the very last steam locomotive built by the Baldwin Locomotive Works in 1949 and originally operated by the Chesapeake and Ohio Railway (C&O) where it pulled coal trains until its retirement in 1956. In 1972, No. 1309 was moved to the B&O Railroad Museum for static display until 2014 when it was purchased by the Western Maryland Scenic Railroad (WMSR), who undertook a multi-year effort to restore it to operating condition. The restoration was completed on December 31, 2020, and the locomotive entered tourist excursion service for the WMSR on December 17, 2021. This was the first time an articulated locomotive operated in the eastern United States since the retirement of Norfolk and Western 1218 in late 1991.
The Chesapeake and Ohio H-8 was a class of 60 2-6-6-6 steam locomotives built by the Lima Locomotive Works in Lima, Ohio between 1941 and 1948, operating until the mid 1950s. The locomotives were among the most powerful steam locomotives ever built and hauled fast, heavy freight trains for the railroad. Only two were preserved; Nos. 1601 and 1604.
The Louisville and Nashville M-1 was a class of forty-two 2-8-4 steam locomotives built during and after World War II as dual-service locomotives. They were nicknamed "Big Emmas" by crews and were built in three batches between 1942 and 1949.
The Chesapeake and Ohio Greenbrier was a class of 12 4-8-4 "Greenbrier" type steam locomotives built by the Lima Locomotive Works between 1935 and 1948 and operated by the C&O. Like a handful of railroads, the C&O didn't name their 4-8-4s "Northerns", and instead went with the name "Greenbrier" after the Greenbrier Hotel in White Sulphur Springs, West Virginia, a major resort on the C&O mainline.