W.19 | |
---|---|
Role | Fighter-reconnaissance seaplane |
Manufacturer | Hansa und Brandenburgische Flugzeug-Werke |
Designer | Ernst Heinkel |
Introduction | 1918 |
Retired | 1918 |
Primary user | Germany |
Number built | 55 |
The Hansa-Brandenburg W.19 was a German fighter-reconnaissance aircraft of World War I. It was a single-engined two-seat biplane floatplane, and was a larger development of the successful W.12. It served with the Kaiserliche Marine (Imperial German Navy) during 1918.
Operational experience with the W.12 showed that, while it was an extremely successful design - showing excellent performance and manoeuvrability - there was a requirement for a floatplane fighter with greater endurance. To meet this requirement, Ernst Heinkel, chief designer of the Hansa und Brandenburgische Flugzeug-Werke, designed the W.19. [1]
The W.19 was of similar layout to the W.12, but considerably larger (i.e. with a 2.6 m/8.5 ft greater wingspan and a 1 m/3.3 ft greater length). It was a single-engined tractor biplane, with two bay wings. The aircraft was fitted with a similar inverted tailplane to the W.12 in order to give unobstructed fields of fire to the observer, who was seated in a rear cockpit, immediately behind the pilot. In order to compensate for the increased size and weight over the W.12, the W.19 was fitted with a more powerful Maybach Mb.IV engine.
Production aircraft were armed with one or two synchronised 7.92 mm (.312 in) LMG 08/15 machine guns firing forward and a single 7.92 mm (.312) LMG 08/15 machine gun for the observer. One aircraft was fitted with a 20 mm Becker cannon for tests. [2]
The W.19 entered service with the German Navy in January 1918, [1] operating from bases at Borkum and Zeebrugge for operations over the North Sea. It was used in support of the smaller W.19 or W.29 fighters, often scouting ahead for targets while the smaller aircraft waited on the sea. Combats often occurred between the various Hansa-Brandenburg fighters and large British flying boats such as Felixstowe F.2s and Curtiss Americas.
The W.19 continued in service until the Armistice, 55 being produced. [3] While it had been planned to supplement it with the W.33 monoplane, only a few had been delivered by the time the war ended.
Data fromGerman Aircraft of the First World War [3]
General characteristics
Performance
Armament
Related development
Related lists
The Rumpler 6B was a German single-engine floatplane fighter with a biplane wing structure, designed and built by Rumpler Flugzeugwerke, in Berlin Johannisthal and introduced in 1916.
The Hansa-Brandenburg KDW was a German single-engine, single-seat, fighter floatplane of World War I. The KDW – Kampf Doppeldecker, Wasser – was adapted from the Hansa-Brandenburg D.I landplane to provide coastal defence over the North Sea.
The Hansa-Brandenburg W.12 was a German biplane fighter floatplane of World War I. It was a development of Ernst Heinkel's previous KDW, adding a rear cockpit for an observer/gunner, and had an unusual inverted tailfin/rudder in order to give an uninterrupted field of fire.
The Hansa-Brandenburg W.29 was a German two-seat fighter floatplane which served in the closing months of World War I with the Imperial German Navy's Naval Air Service from bases on the North Sea coast. In concept the aircraft was a monoplane version of the biplane Hansa-Brandenburg W.12, although there were many structural differences between the two.
The Friedrichshafen FF.43 was a German single-seat floatplane fighter of the 1910s produced by Flugzeugbau Friedrichshafen.
The Friedrichshafen FF.48 was a German two-seat floatplane fighter of the 1910s produced by Flugzeugbau Friedrichshafen.
The Daimler D.I was a German fighter aircraft of World War I. It was a conventional biplane design with a very small interplane gap - the top wing nearly touched the top of the fuselage. Power was provided by a Daimler D.IIIb water-cooled V-8 engine.
The Hansa-Brandenburg CC was a single-seat German fighter flying boat of World War I. It was used by both the Kaiserliche Marine and the Austro-Hungarian Navy.
The Hansa-Brandenburg W.11 was a fighter floatplane built in Germany in 1917 as a more powerful version of the KDW. Similar in general configuration to its predecessor, the W.11 shared the same unusual interplane strut arrangement, and featured fins above and below the fuselage. Only three examples were built.
The Hansa Brandenburg W.27 and W.32 were prototype fighter floatplanes developed in parallel in Germany during World War I. They were developments of and intended replacements for the W.12 then in service and differed from each other principally in the choice of powerplant, the W.27 with a Benz Bz.IIIb and the W.32 with the same Mercedes D.III that the original W.12 used.
The Zeppelin-Lindau CS.I was a German single-engined reconnaissance seaplane with a low-wing monoplane layout.
The Kondor D 1, given the unofficial name Kondorlaus, was a German single seat, biplane fighter aircraft designed and built close to the end of WWI.
The Kondor D 2 was a German single seat, biplane fighter aircraft designed and built close to the end of World War I.
The Märkische D.I was a prototype single-seat fighter biplane built in the last months of World War I.
The Hansa-Brandenburg GDW was a floatplane torpedo bomber built in Germany during World War I for the Imperial German Navy.
The Hansa-Brandenburg W.16 was a floatplane fighter built in Germany during World War I for the Imperial German Navy.
Hansa-Brandenburg W.34 was a prototype German two-seat, single-engined floatplane, which had been designed by Hansa und Brandenburgische Flugzeugwerke during World War I.
The Hansa-Brandenburg W.18 was a single-seat German fighter flying boat of World War I. It was used by both the Kaiserliche Marine and the Austro-Hungarian Navy.
The Hansa-Brandenburg W.25 was a German floatplane fighter of the World War I era, designed and built by Hansa-Brandenburg.
The Hansa-Brandenburg W.23 was a German flying-boat fighter of World War I.