IAR-23 | |
---|---|
Role | Light multipurpose aircraft |
National origin | Romania |
Manufacturer | IAR |
First flight | 1934 |
Number built | 1 |
The IAR-23 and IAR-24 were low-wing monoplane light multipurpose aircraft with a conventional undercarriage, built by IAR of Romania.
The IAR-23 was created in 1934 by the Romanian company Industria Aeronautică Română (IAR) as an attempt to design a next-generation fighter [1] for the Royal Romanian Air Force, but because its low power, it was classified only as a civilian touring aircraft. However, it contained many advanced features for its time, including uniquely designed wings. After the installation of additional fuel tanks, it turned into a long-haul touring plane, with a maximum range of 2300 km. [2]
An improved version, the IAR-24, was created in 1935. It used the same airframe, but had a modernized cockpit and a slightly more powerful engine that yielded a higher cruising speed.
The sole IAR-23 built was registered YR-IAR. [3] and delivered to Major Gheorghe Bănciulescu in September 1934, who undertook several cross country flights with the aircraft through Europe (from Bucharest to Warsaw, Prague and Vienna). The next year, the IAR-23 was flown to Tel-Aviv and back. [4]
The sole IAR-24 was registered YR-ACI. The fates of both aircraft are unknown.
Data from I Gudju, G Iacobescu, O Ionescu: Romanian Aeronautical Constructions 1905-1974
General characteristics
Performance
Aircraft of comparable role, configuration, and era
The SET 7 was a military trainer and reconnaissance aircraft that was produced in Romania in the mid-1930s. It was originally designed as a conventional single-bay biplane, with slightly staggered wings, a standard undercarriage with fixed tailskid, and a tandem open-cockpit arrangement for the pilot and instructor or observer. Power was supplied by an Armstrong Siddeley Jaguar radial engine, and from the outset the aircraft was equipped for wireless and photographic reconnaissance duties.
The SET XV was a fighter aircraft developed in Romania in the mid-1930s. It was a conventional single-bay biplane with staggered wings of unequal span braced by N-struts. It was fitted with fixed tailwheel undercarriage with spatted mainwheels. The cockpit was fully enclosed, and the engine was fitted with a NACA cowl. Construction throughout was fabric-covered metal.
The ICAR 36 / ICAR Comercial (sic), variously also known as the ICAR M 36, Messerschmitt M 36 or BFW M.36, was a Messerschmitt design built and tested by the Romanian company ICAR in the mid-1930s. It was a small, single-engine high-wing airliner, the first civil transport aircraft built in Romania.
The ICAR Universal was a 1930s Romanian two seat monoplane trainer, touring and aerobatics aircraft.
The IAR-822 was an agricultural aircraft built in Romania in the 1960s. Based on the IAR-821, it was a conventional low-wing monoplane with fixed, tailwheel undercarriage and differed from its predecessor mainly in the choice of a horizontally opposed engine in place of a radial.
The IAR-823 is a civil and military trainer aircraft built in Romania from 1974 until 1983. It is a conventional low-wing monoplane with retractable tricycle undercarriage. The pilot and instructor sit side-by-side, and two more seats can be fitted behind them. The type was adopted by the Romanian Air Force as a primary trainer, and was also supplied to Romanian and Hungarian aeroclubs and the national flying school of Angola.
The IAR CV 11 was a Romanian fighter prototype in 1930, designed by Elie Carafoli, and it was IAR's first original aircraft.
The IAR-22 was a single engine basic trainer built in Romania in about 1934. It was a low-wing monoplane with two seats in tandem and a fixed conventional undercarriage.
The IAR 27 was a 1930s Romanian two-seat low-wing monoplane primary trainer designed and built by Industria Aeronautică Română.
The IS-2 was an intermediate training glider designed by Iosif Şilimon and built in Romania in the 1950s at the URMV-3 factory at Brașov.
The IS-4 was a high performance glider designed by Iosif Şilimon and built in Romania in the late 1950s at the URMV-3 factory at Braşov.
The RAS-1 Getta was a flying boat produced in Romania during the 1920s.
The IAR-818 was a Romanian multipurpose aircraft based on the IAR-817. It was developed by IAR in both landplane and floatplane forms.
The IAR-817 was a Romanian multipurpose aircraft built in the 1950s.
The IAR-813 was a Romanian trainer aircraft based on the IAR-811. It differed from the IAR 811 in having a bubble canopy and more powerful engine.
The IAR-811 was a Romanian trainer aircraft built in the late 1940s. It was the first aircraft designed and built in Romania following the end of the Second World War.
The IAR-814, aka MR-2, was a Romanian designed and built twin-engined trainer aircraft built in the early 1950s, the first twin-engined aircraft wholly designed and built in Romania.
Arsenalul Aeronautic in Bucharest was the first factory with an aeronautical profile in Romania. Its activity took place between 1919 and 1939. Arsenalul Aeronautic manufactured three models of aircraft: Hansa-Brandenburg C.I, Proto 1 and Aeron and modified De Havilland aircraft for passenger and freight transport. Also, at the Aeronautical Arsenal, research in the field of study and testing of materials was organized.
Proto 1 was a training biplane designed by Major Ștefan Protopopescu in collaboration with Dumitru Baziliu and Gheorghe Ticău at Arsenalul Aeronautic in Bucharest in 1922. It was the first Romanian airplane to be built in a specialized enterprise.
Proto 2 was a training biplane manufactured at the Fabrica de avioane Astra in Arad in 1924.