Touch-and-go landing

Last updated
A touch-and-go of an Airbus A340-500 of the Royal Thai Air Force at Phuket Airport

In aviation, a touch-and-go landing (TGL) [1] or circuit and bump is a maneuver that is common when learning to fly a fixed-wing aircraft. It involves landing on a runway and taking off again without coming to a full stop. Usually the pilot then circles the airport in a defined pattern known as a circuit and repeats the maneuver. This allows many landings to be practiced in a short time. [2]

Contents

If the pilot brings the aircraft to a full stop before taking off again, it is known as a "stop-and-go". If the aircraft's wheels do not touch the ground, it is known as a "low pass". Both a touch-and-go landing and a low pass are types of go-around. An unplanned touch-and-go landing is also called a "rejected landing" or "balked landing".

Touch-and-go landings can perform a crucial safety role when a plane lands with not enough space to come to a complete stop, but has enough space to accelerate and take off again.

Standard procedure

In a normal landing, the pilot flies the traffic pattern and establishes the aircraft on final approach. As the aircraft crosses the threshold of the runway the pilot executes the landing flare, touches the aircraft down, and immediately applies braking, ground spoilers, and (if available) reverse thrust until the aircraft has decelerated enough to exit onto a taxiway. In a touch-and-go landing, after the wheels are down, the pilot does not apply the brakes but instead increases the engine power to full, partially retracts the flaps, accelerates back to rotation speed, and lifts off again.

At a towered airport, the pilot must receive ATC permission to perform a touch-and-go landing by requesting it by name or as "the option," which allows the pilot to perform a touch-and-go, stop-and-go, low approach, full-stop landing or go-around as desired.

At a non-towered airport, the pilot announces position and intent over the CTAF or UNICOM radio frequency to coordinate the flow of local air traffic with any other pilots.

Debate over role in flight instruction

Some flight instructors believe touch-and-gos should not be heavily used, if at all, with student pilots. They argue that this procedure results in less attention to learning to land properly, and thus creates safety problems. They note that neither the Federal Aviation Administration's Practical Test Standards nor its Airplane Flying Handbook discusses touch-and-gos. [3]

Instructors who favor the use of touch-and-gos contend that it makes it possible to practice more landings per hour of instruction. Students doing touch-and-gos find it easier to master landing, particularly the final stage known as landing flare, which is often difficult to learn. Preparing to take off while landing is a necessary safety skill, they add, because any pilot must be able to do it in order to reject a landing. [3]

Commercial aviation

As a result of the Australian government's Two Airlines Policy, airlines other than Ansett Australia and Trans Australia Airlines were not permitted to operate routes directly between major cities. To circumvent this policy, East-West Airlines would perform touch-and-go landings in smaller cities along the way. For instance, East-West's Melbourne to Sydney route included a touch-and-go landing at Albury Airport, on the border of New South Wales and Victoria. [4]

Carrier aviation

An Argentine Navy Super Etendard commencing a touch-and-go landing on USS Ronald Reagan during Gringo-Gaucho joint US-Argentine manoeuvres. Argentine Navy Dassault Super Etendard jet on USS Ronald Reagan.jpg
An Argentine Navy Super Étendard commencing a touch-and-go landing on USS Ronald Reagan during Gringo-Gaucho joint US-Argentine manoeuvres.

In the United States Navy, touch-and-go landings are part of training for carrier pilots. If they have been away from a carrier for 29 days, they must do practice on a land runway and then do so at sea within 10 days. Before a carrier goes on patrol, pilots will conduct training. For example, before USS Ronald Reagan left on its summer 2016 patrol, it planned to conduct 4200 touch-and-go landings. [5]

Related Research Articles

<span class="mw-page-title-main">Landing</span> Transition from being in flight to being on a surface

Landing is the last part of a flight, where a flying animal, aircraft, or spacecraft returns to the ground. When the flying object returns to water, the process is called alighting, although it is commonly called "landing", "touchdown"a or "splashdown" as well. A normal aircraft flight would include several parts of flight including taxi, takeoff, climb, cruise, descent and landing.

In aviation, a go-around is an aborted landing of an aircraft that is on final approach or has already touched down. A go-around can either be initiated by the pilot flying or requested by air traffic control for various reasons, such as an unstabilized approach or an obstruction on the runway.

<span class="mw-page-title-main">Akron–Canton Airport</span> Airport in Green, Ohio, United States

Akron–Canton Airport is a commercial airport in the city of Green, in southern Summit County, Ohio. The airport is located about 14 miles (23 km) southeast of Akron and 10 miles (16 km) northwest of Canton. It is jointly operated by Summit County and Stark County. The airport is a "reliever" airport for Northeast Ohio and markets itself as "A better way to go", emphasizing the ease of travel in comparison to Cleveland Hopkins International Airport. Just under 90% of its traffic is general aviation. It is included in the Federal Aviation Administration (FAA) National Plan of Integrated Airport Systems for 2019–2023, in which it is categorized as a small-hub primary commercial service facility.

<span class="mw-page-title-main">Slip (aerodynamics)</span> Aerobatic maneuver

A slip is an aerodynamic state where an aircraft is moving somewhat sideways as well as forward relative to the oncoming airflow or relative wind. In other words, for a conventional aircraft, the nose will be pointing in the opposite direction to the bank of the wing(s). The aircraft is not in coordinated flight and therefore is flying inefficiently.

<span class="mw-page-title-main">Autoland</span> Automated aircraft landing procedure

In aviation, autoland describes a system that fully automates the landing procedure of an aircraft's flight, with the flight crew supervising the process. Such systems enable airliners to land in weather conditions that would otherwise be dangerous or impossible to operate in.

<span class="mw-page-title-main">American Airlines Flight 625</span> 1976 aviation accident

American Airlines Flight 625, a Boeing 727-100, crashed at St. Thomas, U.S. Virgin Islands on April 27, 1976, while on a domestic scheduled passenger flight originating at T. F. Green Airport in Rhode Island and ending at Saint Thomas, United States Virgin Islands, with an intermediate stop at John F. Kennedy International Airport. 37 out of the 88 passengers on board died in the accident.

<span class="mw-page-title-main">Fort Worth Meacham International Airport</span> General aviation airport in Fort Worth, Texas

Fort Worth Meacham International Airport is a general aviation airport located near the intersection of Interstate 820 and Business U.S. Highway 287 in Fort Worth, Texas, United States. It is named after former Fort Worth Mayor Henry C. Meacham. The airport covers 745 acres.

<span class="mw-page-title-main">Southwest Airlines Flight 1248</span> 2005 aviation accident

Southwest Airlines Flight 1248 was a scheduled passenger flight from Baltimore, Maryland, to Chicago, Illinois, continuing on to Salt Lake City, Utah, and then to Las Vegas, Nevada. On December 8, 2005, the airplane slid off a runway at Chicago-Midway while landing in a snowstorm and crashed into automobile traffic, killing a six-year-old boy.

<span class="mw-page-title-main">Jackson County Airport (Michigan)</span> Airport

Jackson County Airport, also known as Reynolds Field, is a county-owned, public-use airport located two nautical miles (3.7 km) west of the central business district of Jackson, in Jackson County, Michigan, United States. It is a class D airport with operating control tower. It is included in the Federal Aviation Administration (FAA) National Plan of Integrated Airport Systems for 2017–2021, in which it is categorized as a regional general aviation facility.

<span class="mw-page-title-main">Ohio State University Airport</span> Airport in Columbus, United States of America

Ohio State University Airport is a public airport six miles (10 km) northwest of downtown Columbus, in Franklin County, Ohio, United States. It is owned and operated by Ohio State University in Columbus. It is also known as the OSU Don Scott Airport, named after Donald E. Scott, an OSU alumnus who died during his training as a pilot in the United Kingdom during World War II. The airport's main entrance is located on Case Road, and is easily accessible from OH-315 and Interstate 270.

<span class="mw-page-title-main">S7 Airlines Flight 778</span> 2006 aviation accident

S7 Airlines Flight 778(S7778/SBI778) was a scheduled domestic passenger flight from Moscow to Irkutsk, Russia. On 9 July 2006, at 06:44 local time, the Airbus A310-324 aircraft operating the route overran the runway during its landing in Irkutsk. The aircraft failed to stop and crashed through the airport's concrete perimeter fence, struck rows of private garages and burst into flames, killing 125 people.

<span class="mw-page-title-main">Lufthansa Flight 2904</span> 1993 passenger plane crash in Warsaw, Poland

Lufthansa Flight 2904 was an Airbus A320-200 flying from Frankfurt, Germany to Warsaw, Poland that overran the runway at Okęcie International Airport on 14 September 1993.

<span class="mw-page-title-main">Southwest Airlines Flight 1455</span> Aviation accident in California, USA

Southwest Airlines Flight 1455 was a scheduled passenger flight from McCarran International Airport, Las Vegas, Nevada, to Burbank-Glendale-Pasadena Airport, Burbank, California, that overran the runway during landing on March 5, 2000. The aircraft, a Boeing 737-3T5, registration N668SW, came to rest on a city street adjacent to a gas station. The National Transportation Safety Board found that the incident was due to the pilots attempting to land with excessive speed. They also found that the air traffic controller placed them in a position from which their only option was a go around. Two of the passengers were seriously injured, and there were many minor injuries. As a result of the incident, the airport installed an Engineered Materials Arrestor System at the east end of the incident runway. The aircraft was written off, making the incident the 10th hull loss of a Boeing 737-300. This was the first major accident in the airline's 29-year history.

<span class="mw-page-title-main">Continental Airlines Flight 12</span> 1965 aviation accident

On July 1, 1965 Continental Airlines Flight 12 overran the runway while attempting to land at Kansas City Municipal Airport. No one was killed or seriously injured, but the accident forced discussions about runway safety in Kansas City and resulted in construction of a new airport, Kansas City International Airport, which opened in 1972. The accident also led to widespread implementation of runway grooving, which improves braking in wet landing conditions.

<span class="mw-page-title-main">FedEx Express Flight 14</span> 1997 plane crash in Newark, New Jersey, U.S.

FedEx Express Flight 14 was a scheduled cargo flight from Singapore to Newark, New Jersey, via Malaysia, Taiwan, and Alaska. On July 31, 1997, the aircraft flying this route crashed during landing on its final segment at Newark International Airport (EWR), inverting and catching fire, injuring all five people on board.

<span class="mw-page-title-main">Malév Flight 262</span> 2000 aviation accident in Greece

Malév Hungarian Airlines Flight 262 was a flight from Budapest Ferihegy International Airport to Thessaloniki International Airport. On 4 July 2000, a Tupolev Tu-154, belonging to Malév Hungarian Airlines, used on this flight performed a gear-up touchdown during the landing at Thessaloniki, skidded on the runway, but was able to take off and land normally after a go-around. No injuries were reported.

<span class="mw-page-title-main">SmartLynx Airlines Estonia</span> Estonian airline

SmartLynx Airlines Estonia is an Estonian charter airline and a wholly owned subsidiary of the Latvian SmartLynx Airlines.

<span class="mw-page-title-main">East Coast Jets Flight 81</span> 2008 aviation accident

East Coast Jets Flight 81 was a business jet flight operated by East Coast Jets that crashed on July 31, 2008 while attempting a go-around at Owatonna Degner Regional Airport near Owatonna, Minnesota, killing all eight occupants on board. The flight originated in Atlantic City International Airport, and was scheduled to land in Owatonna. The crew made a go-around attempt after the aircraft touched down, but it overran the runway, hit the Instrument Landing System localizer antenna at an altitude of approximately 5 ft (1.5 m), stalled and crashed, with the main wreckage coming to rest 2,400 ft (730 m) from the runway end.

References

  1. International Civil Aviation Organization (2010). "DOC 8400 (ICAO Abbreviations and Codes)" (PDF). Procedures for Air Navigation Services. pp. 1–15, 1–33. Retrieved 2017-04-10.
  2. Teaching Touch And Goes (sic)
  3. 1 2 Bergqvist, Pia (August 2011). "The Touch-and-go: Are touch-and-goes [sic] a good idea during flight training?". Flying . 138 (8): 36.
  4. TBT (Throwback Thursday) in Aviation History: East-West Airlines, Airline Geeks, 20 April 2016. Retrieved 11 August 2018.
  5. Moriyasu, Ken US Navy needs touch-and-go practice strip May 13, 2016 The Nikkei Retrieved September 1, 2016