Akaflieg Braunschweig SB-11

Last updated
SB-11
Role Experimental single seat sailplane
National originGermany
Manufacturer Akaflieg Braunschweig
First flight1978
Number built1

The Akaflieg Braunschweig SB-11 is an experimental, single seat, variable geometry sailplane designed by aeronautical students in Germany. It won the 15 m span class at the World Gliding Championships of 1978 but its advances over the best, more conventional, opposition were not sufficient to lead to widespread imitation.

Contents

Design and development

The Akaflieg Braunschweig or Akademische Fliegergruppe Braunschweig (English: The Brunswick Academic Flying Group) is one of some fourteen German student flying groups attached to and supported by their home Technical University. Several have designed and built aircraft, often technically advanced and leading the development of gliders in particular. [1] The announcement, in 1975, of a new, unrestricted 15 m glider class led the Brunswick group to the design of the SB-11, a variable geometry aircraft. [2]

A long-standing challenge for the designers of competition sailplanes were the conflicting requirements posed by the need to gain height in sometimes weak and narrow thermals, calling for low stalling speeds for small radius turns, and the need for rapid penetration of the cool, sinking air between thermals. In thermals, wings should ideally be of high camber and be lightly loaded; between thermals, low camber wings with high wing loading would fly faster. Large area, camber-changing flaps were one solution but vortexes generated at their extremities added significantly to the drag, decreasing climb rates. [3] [4] Akaflieg Brunswick decided to follow the example of the disappointing British Sigma by providing the SB-11 with Wortmann flaps along the whole of the trailing edge of the wing, including the ailerons. This avoided the flap-associated vortexes, though any increase in wing area, however implemented, will lower the aspect ratio and raise the induced drag caused by wingtip vortexes. [2]

The SB-11 is almost entirely built of weight-saving CRP. In order to concentrate design effort on the wing, the Brunswick students blended together the front fuselage of the Schleicher ASW 20 with the rear fuselage and empennage of the Schempp-Hirth Janus. This gave the SB-11 a conventional fuselage, deeper forward of the shoulder wing, with a long, single piece, forward hinged canopy and a monowheel undercarriage under the wing. There is provision for water ballast. The rear fuselage is slender, with a T-tail with straight edged fin, rudder and swept, all moving tailplane. [2]

The wings of the SB-11 have 2.3° of dihedral and are unswept. The inner 60% of span has constant chord. The outer panels, carrying the ailerons, are straight tapered with a taper ratio of 0.4. Manually driven full-span Fowler type Wortmann flaps emerge from the trailing edge between rollers, increasing the chord by 200 mm (7.9 in) over the untapered inner wing and by 80 mm (3.2 in) at the tip. Overall the flaps produce a 25% increase in wing area. Their trailing edges carry ailerons outboard and plain camber-changing flaps inboard. Mid-chord Schempp-Hirth airbrakes are placed at about mid span on the upper surface of the wing. [2] [5]

Operational history

The SB-11 first flew in 1978. The flaps worked well, with low operating loads [2] and deploying "at the flick of a lever". [6] It was entered into the 16th World Gliding Championships held at Châteauroux in France in July 1978, piloted by Helmut Reichmann. He won the 15 m class, followed by an ASW-20 not far behind. [6]

The SB-11 provided a useful test of the advantages of variable geometry gliders. Thoroughly examined at the Competition and in later tests, it outperformed the other 15 m class gliders of its day in the climb but, crucially, not by much. Its stalling speeds and turn radius was smaller than that of the ASW 20, good for weak thermals, but was perhaps rather poorer than the ASW in the fast glide. [2] Whilst Reichmann was pleased with the SB-11 at the meeting, saying it was the best aircraft there, he later noted that cross-country pilots had plenty to do already and that finding strong lift was more important than exploiting weak thermals. [6] Experience with the SB-11 and with later variable geometry gliders from the Akafliegs of Munich, Darmstadt and Stuttgart (the Mü27, D-40 and FS-29 respectively) showed that, whilst there were performance gains, these were not enough to compensate for the extra expense, complexity and pilot workload that accompanied them; variable geometry did not, in the end, prove a useful way forward. [2] [7]

Specifications

Data from Sailplanes 1965-2000 [2]

General characteristics

Performance

Notes

  1. ↑ The Official website describes the profile as Wortmann FX-62-K-144/21 VG 1,25

Related Research Articles

Schleicher ASW 20

The ASW 20 is an FAI 15 metre Class glider designed by Gerhard Waibel and built by Alexander Schleicher GmbH & Co. Its fuselage is nearly identical to that of the ASW 19, mated to newly designed flapped wings for the 15 metre Class. The prototype first flew in 1977. It proved to be a highly successful glider, winning several World Championships, and was still being flown at this level up to 1995. Developments along its production life included winglets, pneumatic turbulators, and wingtip extensions. It remained in production until 1990, when it was superseded by the ASW 27. 765 were built by Schleicher and a further 140 were made under license by Centrair in France.

Schleicher ASW 12 German glider, 1965

The ASW 12, initially known as the AS 12, is a single-seat Sailplane of glass composite construction. The wing is shoulder mounted and it has a T-tail. It is essentially a developed production version of the Akaflieg Darmstadt D-36.

Glasflügel 303 German single-seat glider, 1976

The Glasflügel 303 Mosquito is a composite 15 metre Class single-seat sailplane manufactured by Glasflügel between 1976 and 1980.

Glasflügel H-301 German single-seat glider, 1964

The Glasflügel H-301 Libelle is an early composite single-seat sailplane produced by Glasflügel from 1964 to 1969. The H-301 had camber-changing wing flaps so was required to compete in the Open Class because the Standard Class excluded wing flaps. It was often known as the Open Class Libelle.

The Schleicher ASW 17 is a single-seat Open Class sailplane that was built by the German manufacturer Alexander Schleicher GmbH & Co and first flew in 1971. It replaced the ASW 12, and was replaced in 1981 by the ASW 22.

The Sigma is an experimental glider developed in Britain from 1966 by a team led by Nicholas Goodhart. After disappointing performance during flight testing the Sigma was passed on to a Canadian group which carried out modifications, making the Sigma more competitive.

Akaflieg München Mü27 German prototype research glider, 1979

The Mü-27 is a research glider aircraft that designed and built in Germany in 1979. Only one example was constructed.

The SZD-40x Halny is an experimental two-seat glider designed and built in Poland in 1971.

Akaflieg Berlin B12 German two-seat glider, 1977

The Akaflieg Berlin B12 is a high performance two-place glider aircraft that was designed and built in Germany. Conceived as a research vehicle, only one unit was constructed.

The Marsden Gemini is a Canadian mid-wing, T-tailed, two-seats in side-by-side configuration, experimental research glider that was designed and constructed by David Marsden at the University of Alberta, first flying in 1973.

The Akaflieg Darmstadt D-28 Windspiel was a single-seat, high-performance sailplane designed in Germany in the early 1930s. Intended to exploit a growing understanding of thermal soaring, it was small and manoeuvrable, with a 12 m span; silk-covered for lightness, it weighed less (empty) than its pilots. It held the world straight-line distance record for a time in 1934.

The Akaflieg Darmstadt D-40 is an experimental variable geometry single seat sailplane, fitted with almost full span, camber changing flaps for optimum aerodynamics in weak thermals and integrated into the wing so as to minimise flap tip drag. One flew successfully but the D-40, like other variable geometry sailplanes, was not commercialised.

The Akaflieg Braunschweig SB-12 is a single seat, Standard Class sailplane designed around 1980 by German technical university students to test out a new wing profile from the German Aerospace Centre. It was not intended for production, but the sole SB-12 remains active in 2010.

The Beatty-Johl BJ-2 Assegai was a single seat, high performance competition glider built in South Africa in the early 1960s. Only one was built; it was optimised for South African conditions and performed well there, winning two nationals and setting several records, but was less successful under European conditions at the 1965 World Gliding Championships.

The Akaflieg Braunschweig SB-7 Nimbus is a Standard class glider designed and built in Germany in the 1960s. It was one of a series of mixed glass fibre and wood designs from the students of Akaflieg Braunschweig.

The Akaflieg Braunschweig SB-8 is an experimental, single-seat, high performance glider built in Germany in the 1960s, constructed largely from glass fibre skin over built up balsa wood structure. Two were built; the second of which was later fitted with a high aspect ratio (30:1) wing, becoming the Akaflieg Braunschweig SB-9 Stratus.

Akaflieg Braunschweig SB-13 Arcus German single-seat glider, 1988

The Akaflieg Braunschweig SB-13 Arcus was an experimental tailless, single seat, Standard Class glider designed and built in Germany in the early 1990s. Though it performed as well as its conventional contemporaries, it did not offer sufficiently improved performance to compensate for its difficult handling characteristics.

The Ciani EC.37/53 Spillo or SSVV EC.37/53 Spillo was a single seat competition glider designed and built in Italy in the 1950s. It had the highest aspect ratio wing of any wooden glider. Only one was built.

The Akaflieg Braunschweig SB-6 Nixope was an early (1961) GRP high performance single seat glider designed and built in Germany by aeronautical students from Brunswick University. It competed in the 1961 German National gliding competition, coming sixth, and led directly to two further GRP aircraft.

Akaflieg Braunschweig SB-14 German single-seat glider, 2003

The Akaflieg Braunschweig SB 14 is an 18 m (59 ft) Open-class sailplane designed and built in Germany in the early 2000s.

References

  1. ↑ Simons, Martin (2005). Sailplanes 1965-2000 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. p.  41. ISBN   3-9808838-1-7.
  2. 1 2 3 4 5 6 7 8 Simons (2005) pp.47-9
  3. ↑ Simons, Martin (2006). Sailplanes 1945-1965 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. pp.  8–9. ISBN   3-9807977-4-0.
  4. ↑ Simons (2005), pp.21, 58
  5. 1 2 3 4 5 6 "Akaflug Braunschweig SB-11" . Retrieved 1 February 2012.
  6. 1 2 3 "16th World Gliding Championships - Chateauroux!" (PDF). Soaring . October 1978. pp. 14–33. Archived from the original (PDF) on 2 October 2006. Retrieved 2 February 2012.
  7. ↑ Simons (2005), pp.51-, 53-4, 58-59
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.