Bonomi BS.20 Albanella

Last updated
BS.20 Albanella
RolePerformance glider
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flightmid 1930s
Number built1 or 2

The Bonomi BS.20 Albanella (English: Montagu's harrier ) was a performance sailplane designed and built in Italy in the mid-1930s. Rather little is known about it; either one or two were constructed.

Contents

Design and development

The BS.20 Albanella is not well documented and the little that is known about it comes a hand-written note on its general characteristics, a number of photographs taken at Milan in the mid-1930s and a sketch on a postcard. It may have been intended for aerobatics. [1]

The Albanella was a cantilever shoulder wing monoplane with a swept straight tapered wing which ended in rounded tips. All the sweep was on the leading edge. Long ailerons occupied more than half the span. As elsewhere on the BS.20, the wing covering was a mixture of plywood and fabric. Its oval cross-section fuselage was conventional at the front, with the pilot's open cockpit just ahead of the leading edge with an eye-line over the upper wing. The main landing gear was a sprung ventral skid stretching from near the nose to below the wing trailing edge. The dorsal line was straight in elevation but immediately aft of the wings the lower ventral line turned quickly upwards and the fuselage became much finer, almost producing a pod and boom form. Horizontal rear surfaces were elliptical in plan. The vertical tail was straight tapered to a rounded tip with a rudder extending down to the keel and operating in an elevator cut-out. [1]

Photographs suggest there were two somewhat different versions, though whether as a result of modification or the construction of a second prototype is not known. [1]

The Albanella was one of two Italian representatives at the Berlin Olympic games of 1936 (the other was the Teichfuss Orione), part of a successful demonstration to establish gliding as an Olympic sport (Gliding at the 1936 Summer Olympics). [2]

Specifications

Data from Pedrielli (2011) p.101 [1]

General characteristics

Performance


Related Research Articles

The Bonomi BS.2 Balestruccio was an Italian sailplane designed to set records. In 1932 it set a new national endurance record with a flight of over 25 minutes.

The Bonomi BS.4 Basettino was a primary glider designed and built in Italy in the 1930s.

The Bonomi BS.5 Ballerina was a single seat, medium performance training glider designed and built in Italy in the 1930s.

The Bonomi BS.8 Biancone was a single-seat training glider designed and built in Italy in the 1930s. It was developed from the Bonomi BS.7 Allievo Italia primary glider.

The Bonomi BS.9 Bertina II was a single seat glider with a layout somewhere between that of a flying wing and the conventional, tail stabilized arrangement. A single example was designed and built in Italy in the 1930s.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.11 Milano and BS.12 Roma were primary gliders designed and built in Italy in the 1930s. Only about six were produced.

The Bonomi BS.14 Astore was a two-seat training and aerobatic glider, designed and built in Italy in 1935. Only one was constructed.

The Bonomi BS.15 Bigiarella, originally named the Bonomi BS.6 Bigiarella was a single seat glider, designed and built in Italy in 1934. Only three were constructed.

The Bonomi BS.16 Allievo Bonomi was a single seat primary glider, designed and built in Italy in 1930 and widely used by flying clubs.

Bonomi BS.17 Allievo Cantù

The Bonomi BS.17 Allievo Cantù was a single seat training glider, designed and built in Italy in 1934 and widely used by flying clubs.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

The Bonomi BS.22 Alzavola was a training motor glider, intended to acquaint capable glider pilots with the characteristics of powered aircraft. The sole example was designed and built in Italy in the late 1930s.

The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.

The Teichfuss Tenax was an Italian, one-off, single seat glider, designed and built by Luigi Treichfuss in 1926 and influenced by German developments.

The Teichfuss Nibio was an Italian single seat glider, designed by Luigi Teichfuss and flown in two versions around 1930.

The Teichfuss Orione was an Italian high performance single seat glider, designed by Luigi Teichfuss. It made a six-hour record flight and also flew as the Italian representative at the 1936 Olympics.

References

  1. 1 2 3 4 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 100–1. ISBN   9783980883894.
  2. ↑ Zuerl, Hubert; Vittorio Bonomi (1941). Segelflug im Wettbewerb der Völker. Berlin: E. S. Mittler & Sohn. pp. 33–4.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.