Bonomi BS.24 Biposto Roma

Last updated
BS.24 Biposto Roma
RoleDual control trainer glider
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flight1935
Number built6

The Bonomi BS.24 Biposto Rome (English: Rome two-seater) was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

Contents

Design and development

Camillo Silva designed numerous gliders for Aeronautica Bonomi, but only two of them, the BS.14 Astore and the Biposto Roma were two seaters. [1] When the company started out in 1931, [2] early glider training used single seat primary gliders and the absence of an experienced pilot on board resulted, in England at least, in many injuries and closure of gliding clubs. [3] By 1935 Italian gliding clubs felt a need for dual control aircraft, with good enough performance to take pupils to their C certificates. They were the Biposto Roma's target market. [1]

Despite the partial overlap in names between the Biposto Roma and the earlier BS.12 Roma they had little else in common. In plan, about half of the span of the BS.24's wing was unswept and had constant chord; the outer panels were straight tapered to rounded tips. Ailerons occupied all the trailing edges of these outer panels. There was no dihedral. The wing centre was mounted high above the fuselage on steel struts; in several of his designs Silva had used a cross braced trapezoidal frame for this purpose but the second cockpit, placed at the centre of gravity (c.g.) under the wing, precluded this and instead there were vertical struts behind each cockpit, one to each wing spar and a third, leaning strut from the rear spar. The ends of the spars of the central, constant chord panels were braced to the lower fuselage longerons, directly under the forward wing spar, by asymmetric V-form, faired steel struts. [1]

The Biposto Roma's fuselage was a wooden, rectangular cross section structure, skinned with plywood. Its two cockpits, both open and unscreened, were in tandem. If the aircraft was flown solo it was piloted from the font seat; the occupation or otherwise of the rear cockpit left the trim little changed as it was on the c.g. Under the fuselage a rubber sprung wooden landing skid ran from forward of the cockpits to well aft of the wing trailing edge. The tailplane was triangular, mounted on top of a short, trapezoidal fin and braced to the top of the fuselage. Its elevators had parallel chord and a central cut-out for the rudder, as this, hinged on the fin's trailing edge, was about twice as high as the tailplane. The rudder was straight edged and reached down to the keel; above the tailplane, it had an aerodynamic balance on its upper leading edge. [1]

Operational history

At least five Biposto Romas were used by the Poggio Renatico gliding school. [1]

Specifications

Data from Pedrielli (2011) p.105 [1]

General characteristics

Performance


Related Research Articles

The Bonomi BS.4 Basettino was a primary glider designed and built in Italy in the 1930s.

The Bonomi BS.5 Ballerina was a single seat, medium performance training glider designed and built in Italy in the 1930s.

Bonomi BS.7 Allievo Italia

The Bonomi BS.7 Allievo Italia was a single seat, primary glider designed and built in Italy in the 1920s.

The Bonomi BS.8 Biancone was a single-seat training glider designed and built in Italy in the 1930s. It was developed from the Bonomi BS.7 Allievo Italia primary glider.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.11 Milano and BS.12 Roma were primary gliders designed and built in Italy in the 1930s. Only about six were produced.

The Bonomi BS.14 Astore was a two-seat training and aerobatic glider, designed and built in Italy in 1935. Only one was constructed.

The Bonomi BS.15 Bigiarella, originally named the Bonomi BS.6 Bigiarella was a single seat glider, designed and built in Italy in 1934. Only three were constructed.

The Bonomi BS.16 Allievo Bonomi was a single seat primary glider, designed and built in Italy in 1930 and widely used by flying clubs.

Bonomi BS.17 Allievo Cantù

The Bonomi BS.17 Allievo Cantù was a single seat training glider, designed and built in Italy in 1934 and widely used by flying clubs.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

The Bonomi BS.22 Alzavola was a training motor glider, intended to acquaint capable glider pilots with the characteristics of powered aircraft. The sole example was designed and built in Italy in the late 1930s.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The CAT 15 was a single-seat primary glider built in Italy just before the Second World War. Only one was constructed.

The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.

The GVV Dal Molin MD.1 Anfibio Varese,, was a single-seat, amphibious flying boat glider built in Italy in 1933. Eight were constructed.

The Teichfuss LT.12 Biposto was an Italian tandem seat primary glider designed by Luigi Teichfuss and flown in 1933.

The Teichfuss Astore was an Italian Intermediate single-seat trainer glider designed by Luigi Teichfuss and flown in 1936. Two were built.

The Teichfuss Condor II was designed to compete in the first Italian glider contest, held at Asiago in 1924. It was bought on arrival by the official Italian organization as the FIDA TIPO LT N2 but was lost in a mid-contest crash.

References

  1. 1 2 3 4 5 6 7 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 72–107, 104–5. ISBN   9783980883894.
  2. ↑ Thompson, Jonathan (1963). Italian Civil and Military Aircraft 1930-1945. Fallbrook, California: Aero Publishers, Inc. p. 293.
  3. ↑ Simons, Martin (2006). Sailplanes 1920-1945 (2nd revised ed.). Königswinter: EQIP Werbung & Verlag GmbH. pp. 47–9. ISBN   3 9806773 4 6.
  4. 1 2 Zuerl, Hubert (1941). Segelflug im Wettbewerb der Völker. Berlin: E. S. Mittler & Sohn. p. 42.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.