Bonomi BS.2 Balestruccio

Last updated
BS.2 Balestruccio
RoleHigh performance sailplane
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flight1932
Number built1

The Bonomi BS.2 Balestruccio (English: House Martin) was an Italian sailplane designed to set records. In 1932 it set a new national endurance record with a flight of over 25 minutes.

Contents

Design and development

The Balestruccio was a single seat glider with a high aspect ratio gull wing built in four parts. The two inner panels, straight edged with constant chord and carrying dihedral, joined on top of the fuselage, their extremities braced from the lower fuselage with flat steel V-struts, encased in faired wood to reduce drag and assisted on each side by a pair of jury struts. The upper end of each strut was attached on one of the two wing spars. The outer wing panels were straight tapered, with rounded tips. There were differential ailerons on the outer trailing edges and flaps inboard. [1]

The fuselage of the Balestruccio was hexagonal, with deep, near vertical sides. [1] Its comfortable cockpit [2] was immediately in front of the wing leading edge and was originally provided with a wooden canopy with small side openings, similar to that used on the German DFS Fafnir, but this was later replaced with a more conventional open arrangement which provided better all-round visibility. A single, sprung skid and a tail bumper provided an undercarriage. The fuselage tapered aft to a mid mounted horizontal tail consisting almost entirely of the elevator; although this had straight leading edges, a combination of their slight sweep and the full, rounded trailing edges gave the planform an almost elliptical appearance. There were aerodynamic balances and a large cut-out for rudder movement. As first constructed, the vertical tail was rather similar, with a small fin and a full, deep, curved, balanced rudder which extended slightly below the keel. Later, with the fuselage shortened by one frame or about 700 mm (28 in), the Balestruccio was given a new, angular fin and rudder with straight taper and square tip. Like the old rudder, this was also balanced and deep, though extending only to the keel. The original horizontal tail was retained. [1]

Operational history

The Balesruccio proved to be versatile and efficient and was flown by Vittorio Bonomi and Enrico Rolandi from Mottarone and Campo dei Fiori di Varese. On 18 December 1932 Rolandi flew it for 25.8 minutes, setting a new Italian national endurance record, covering 15.7 km (9.8 mi) and winning the Castiglione Trophy. [1] As late as 1937, it was demonstrating its performance in Asiago. [2]

Specifications

Data from Pedrelli (2011) pp.70-1 [1]

General characteristics

Performance

Related Research Articles

The CVV 2 Asiago is a simple, single seat glider designed and built in Italy in the mid-1930s, the second of a series of gliders from the Milan Polytechnic and the first go into production.

The Bonomi BS.5 Ballerina was a single seat, medium performance training glider designed and built in Italy in the 1930s.

The Bonomi BS.8 Biancone was a single-seat training glider designed and built in Italy in the 1930s. It was developed from the Bonomi BS.7 Allievo Italia primary glider.

The Bonomi BS.9 Bertina II was a single seat glider with a layout somewhere between that of a flying wing and the conventional, tail stabilized arrangement. A single example was designed and built in Italy in the 1930s.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.14 Astore was a two-seat training and aerobatic glider, designed and built in Italy in 1935. Only one was constructed.

The Bonomi BS.15 Bigiarella, originally named the Bonomi BS.6 Bigiarella was a single seat glider, designed and built in Italy in 1934. Only three were constructed.

<span class="mw-page-title-main">Bonomi BS.17 Allievo Cantù</span> Type of aircraft

The Bonomi BS.17 Allievo Cantù was a single seat training glider, designed and built in Italy in 1934 and widely used by flying clubs.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

The Bonomi BS.20 Albanella was a performance sailplane designed and built in Italy in the late-1930s. Rather little is known about it; either one or two were constructed.

The Bonomi BS.22 Alzavola was a training motor glider, intended to acquaint capable glider pilots with the characteristics of powered aircraft. The sole example was designed and built in Italy in the mid-1930s.

The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The Teichfuss Falco was an Italian single-seat, intermediate-performance glider, designed by Luigi Teichfuss and flown in 1931.

The Teichfuss Orione was an Italian high performance single seat glider, designed by Luigi Teichfuss. It made a six-hour record flight and also flew as the Italian representative at the 1936 Olympics.

The Teichfuss Grifo was an Italian training glider designed by Luigi Teichfuss and flown in 1934. It was built in small numbers.

The Teichfuss Supergrifo or Super Grifo was an Italian competition glider designed by Luigi Teichfuss and flown in 1935. Only one was built.

The Teichfuss Astore was an Italian Intermediate single-seat trainer glider designed by Luigi Teichfuss and flown in 1936. Two were built.

The Teichfuss Allievo Pavullo was an Italian single seat open frame primary glider, designed by Luigi Teichfuss of Pavullo and first flown in 1940. It was sold in two versions, strut and cable braced. A single two seat variant was also built.

References

  1. 1 2 3 4 5 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 64–7, 70–1. ISBN   978 39808838 9 4.
  2. 1 2 3 4 Zuerl, Hubert (1941). Segelflug im Wettbewerb der Völker. Berlin: E. S. Mittler & Sohn. pp. 38, 42.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.