Bonomi BS.19 Alca

Last updated
BS.19 Alca
Role Motor glider
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flight1936
Number built1

The Bonomi BS.19 Alca (English: Auk ) was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

Contents

Design and development

In the mid-1930s some glider designers were beginning to think about incorporating an engine, to form a self-launching aircraft. One of the first of these, the Carden-Baynes Auxiliary flew in 1935. It was very clearly primarily a glider, particularly when its engine and propeller were folded away into the fuselage, an operation possible in flight. [1] The BS.19 Alca of 1936 was closer to a high aspect ratio light aircraft, with no provision of a foldaway propeller. It was the first powered aircraft designed by Camillo Silva for Aeronautica Bonomi. The Alca, a single seater, was powered by a small flat twin engine of unknown make but producing between 15 kW (20 hp) and 19 kW (25 hp). [2]

The Alca's cantilever mid-mounted monoplane wing was built in three parts around a box front spar and a second rear spar. There was a short centre section, only about 10% of the span and integrated into the fuselage, plus two outer panels. The wing plan was strongly straight tapered, largely on the trailing edge, ending in elliptical tips; there was also strong taper in thickness. Covering was a mixture of plywood and fabric. Long ailerons occupied more than half the span. [2]

The Alca's flat sided fuselage was deep from the nose to behind the wing trailing edge where the underside swept upwards, producing an almost boom like rear fuselage. The pilot's open cockpit, fitted with a small windscreen, was placed just ahead of mid chord between the spars. The upper fuselage line was almost flat and the little twin cylinder engine was high in the nose with its cylinder heads exposed for cooling. At the rear the empennage was conventional, though in glider fashion the straight edged fixed surfaces were small in area compared with the control surfaces. A tailplane braced from both above and below was mounted on the fin just above the fuselage; together with its balanced elevator it had a tapered, round tipped plan, with a cut-out for movement of the straight edged, though rounded, balanced rudder which extended to the keel. The Alca had a conventional glider type, rubber sprung landing skid plus tail bumper but it also had an unusual wheeled undercarriage for take-off. This featured a wheel on each side mounted on a half axle attached to the lower fuselage longeron and a vertical shock absorbing leg to the wing. After take-off, this was retracted and not used again until the next departure. [2]

Data on the Alca's performance under power have survived, but not on its gliding characteristics beyond a comment that they were excellent, as was the handling. Only the prototype was built. [2]

Specifications

Data from Pedrielli (2011) p.99 [2]

General characteristics

Performance

Related Research Articles

<span class="mw-page-title-main">SZD-45 Ogar</span> Polish two-seat motor-glider, 1973

The SZD-45 Ogar (Hound) is a T-tailed cantilever high-wing monoplane of wooden, aluminium and fibreglass construction designed and manufactured in Poland.

The TeST TST-13 Junior is a single-seat touring motor glider with a nose-mounted engine, built by TeST in Czech Republic. It is an all composite design which succeeded the TeST TST-9 Junior motor glider in production, incorporating some features of the TeST TST-10 Atlas sailplane, including its wing.

<span class="mw-page-title-main">IAR-22</span> Type of aircraft

The IAR-22 was a single engine basic trainer built in Romania in about 1934. It was a low-wing monoplane with two seats in tandem and a fixed conventional undercarriage.

<span class="mw-page-title-main">Cyclone AX2000</span> Type of aircraft

The Cyclone AX2000 is a British built three axis microlight, first flown in the 1990s. It seats two in side-by-side configuration.

The Corcoran 65-1 was a motor glider of very unusual configuration, a twin engine biplane. It was designed and built in the United States in the 1960s; only two were completed.

The Bonomi BS.2 Balestruccio was an Italian sailplane designed to set records. In 1932 it set a new national endurance record with a flight of over 25 minutes.

The Bonomi BS.4 Basettino was a primary glider designed and built in Italy in the 1930s.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.14 Astore was a two-seat training and aerobatic glider, designed and built in Italy in 1935. Only one was constructed.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Bonomi BS.22 Alzavola was a training motor glider, intended to acquaint capable glider pilots with the characteristics of powered aircraft. The sole example was designed and built in Italy in the mid-1930s.

The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.

The Romeo Ro.35, a.k.a.IMAM Ro.35 was a single-seat glider built in Italy in 1933.

The Teichfuss Cicogna was an Italian tailless single-seat motor glider designed by Luigi Teichfuss and flown in 1936.

The Kortenbach & Rauh Kora 1 was an unusual twin boom, pusher configuration motor glider, designed and built in Germany in the 1970s and intended as a training aircraft.

The VFW-Fokker FK-3 is a single seat competition glider, built in Germany in the late 1960s. It had success at the Italian and Austrian national contests of 1968, resulting in a short production run the following year.

The IIL IS-9 was a low powered, experimental pod and boom style motor glider, designed and built in Romania in the late 1950s.

The MIP Smyk, MIP from the initials of its Polish designers with Smyk meaning Brat or Kid, was an aerodynamically refined motor glider designed and built at Warsaw Technical University from 1935.

References

  1. ↑ Ellison, Norman (1971). British Gliders and Sailplanes. London: A & C Black Ltd. pp. 24–7, 76. ISBN   0 7136 1189 8.
  2. 1 2 3 4 5 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 98–9. ISBN   9783980883894.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.