Bonomi BS.15 Bigiarella

Last updated
BS.15 Bigiarella
RoleSingle seat glider
National origin Italy
Manufacturer Aeronautica Bonomi
Designer Camillo Silva
First flight1934
Number built3

The Bonomi BS.15 Bigiarella (Italian for 'lesser whitethroat'), originally named the Bonomi BS.6 Bigiarella was a single seat glider, designed and built in Italy in 1934. Only three were constructed.

Contents

Design and development

The Bigiarella was a single seat high wing braced monoplane, constructed from wood and fabric. Its fuselage, though conventional, was a new design but otherwise the Bigiarella was very similar to the BS.8 Biancone, using the same wings and support structure. The Biancone, though it had a nacelle housing the cockpit had retained the fuselage boom of its predecessor, the BS.7 Allievo Italia. In contrast, the Bigiarella had a full, rectangular cross section fuselage which was only slightly tapered, the deepest section containing the pilot's open, unscreened cockpit in front of and below the wing's high leading edge. The fuselage was largely fabric covered but the central part containing the wing support structure was plywood skinned. In some photographs the three sloping struts that connected wing and fuselage, a distorted N arrangement most easily visible on the BS.7, were faired in as on the Biancone, but others show them exposed. The new fuselage, deeper at the tail than the Biancone's tailboom, required a less tall fin to maintain the tailplane's position with respect to the rudder but otherwise the empennage was unchanged. A wooden landing skid with rubber springing, deep like the one on the BS.11 Milano and assisted by a small tail bumper served as its undercarriage. [1]

Only three Bigiarellas were built. [1]

Operational history

In July 1934 a Bigiarella set an endurance record of 2 hrs 50 min, flying at Vigne di Valle near Rome. [1]

Specifications

Data from Pedrielli (2011) p.93 [1]

General characteristics

Performance

Related Research Articles

The Bonomi BS.2 Balestruccio was an Italian sailplane designed to set records. In 1932 it set a new national endurance record with a flight of over 25 minutes.

The Bonomi BS.4 Basettino was a primary glider designed and built in Italy in the 1930s.

The Bonomi BS.5 Ballerina was a single seat, medium performance training glider designed and built in Italy in the 1930s.

Bonomi BS.7 Allievo Italia

The Bonomi BS.7 Allievo Italia was a single seat, primary glider designed and built in Italy in the 1920s.

The Bonomi BS.8 Biancone was a single-seat training glider designed and built in Italy in the 1930s. It was developed from the Bonomi BS.7 Allievo Italia primary glider.

The Bonomi BS.9 Bertina II was a single seat glider with a layout somewhere between that of a flying wing and the conventional, tail stabilized arrangement. A single example was designed and built in Italy in the 1930s.

The Bonomi BS.10 Ardea was an Italian single seat high performance glider, designed and built in the mid-1930s. Only one was built.

The Bonomi BS.11 Milano and BS.12 Roma were primary gliders designed and built in Italy in the 1930s. Only about six were produced.

The Bonomi BS.14 Astore was a two-seat training and aerobatic glider, designed and built in Italy in 1935. Only one was constructed.

The Bonomi BS.16 Allievo Bonomi was a single seat primary glider, designed and built in Italy in 1930 and widely used by flying clubs.

Bonomi BS.17 Allievo Cantù

The Bonomi BS.17 Allievo Cantù was a single seat training glider, designed and built in Italy in 1934 and widely used by flying clubs.

The Bonomi BS.18 Airone was a single seat training glider, designed in Italy in 1936. Only one was built.

The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.

The Bonomi BS.20 Albanella was a performance sailplane designed and built in Italy in the mid-1930s. Rather little is known about it; either one or two were constructed.

The Bonomi BS.22 Alzavola was a training motor glider, intended to acquaint capable glider pilots with the characteristics of powered aircraft. The sole example was designed and built in Italy in the late 1930s.

The Bonomi BS.24 Biposto Rome was an Italian dual control trainer designed for club use. Six were built in the mid-1930s.

The Bonomi BS.28 Alcione, sometimes known as the Lombarda BS.28 Alcione, was a single seat competition sailplane designed and built in Italy in 1937-8. About four were completed, with two more or less refined fuselages.

The GP1 was an Italian glider constructed by university students in Pavia in 1925. Only one was built.

The Teichfuss Orione was an Italian high performance single seat glider, designed by Luigi Teichfuss. It made a six-hour record flight and also flew as the Italian representative at the 1936 Olympics.

The Teichfuss Grifo was an Italian training glider designed by Luigi Teichfuss and flown in 1934. It was built in small numbers.

References

  1. 1 2 3 4 Pedrielli, Vincenzo; Camastra, Francesco (2011). Italian Vintage Sailplanes. Königswinter: EQIP Werbung & Verlag GmbH. pp. 92–93. ISBN   9783980883894.
  2. ↑ Zuerl, Hubert (1941). Segelflug im Wettbewerb der Völker. Berlin: E. S. Mittler & Sohn. pp. 38, 42.
This page is based on this Wikipedia article
Text is available under the CC BY-SA 4.0 license; additional terms may apply.
Images, videos and audio are available under their respective licenses.