| Kondor D 6 | |
|---|---|
 | |
| Role | Fighter aircraft |
| National origin | Germany |
| Manufacturer | Kondor Flugzeugwerke GmbH, Essen |
| Designer | Walter Rethel |
| First flight | Summer 1918 |
| Number built | 1 |
The Kondor D 6 was a prototype German biplane fighter aircraft flown in 1918. In the interests of better upward vision for the pilot, its upper wing was in two halves, separated over the central fuselage. Its development was soon abandoned.
In most respects the D 6 was a conventional biplane fighter; its one distinguishing feature came from an attempt to improve the pilot's upward view, normally limited by the upper wing. The usual approach was to position the cockpit under the wing trailing edge and form a cut-out in its edge but the D 6 took this to the extreme of removing all the centre section. Though it served its immediate purpose, this feature required extra cabane strengthening and much increased the induced drag associated with vortices at wing tips, now six rather than four in number. [1]
The D 6 was a single bay biplane with pairs of parallel, outward leaning interplane struts. There was no stagger on the leading edges, though the lower wing was smaller both in span and chord. Each upper wing tip was supported over the fuselage by a N-form strut, one foot at mid-fuselage and the forward one higher. The lower wing was conventionally attached to the lower fuselage. The half span, broad and horn balanced ailerons were on the upper wing only. [1]
The fuselage of the D 6 used Kondor's usual steel tube structure, though fabric rather than plywood covered. It was flat sided and tapered strongly in plan behind the 145 hp (108 kW) Oberursel Ur.III eleven cylinder rotary engine which was completely cowled, driving a large spinner and two blade propeller. Together, the fin and rudder were oval; the trapezoidal tailplane with rounded balanced elevators was on the top of the fuselage and the deep rudder required a gap between the elevators for its movement. The D 6 had a fixed single axle undercarriage, with mainwheels mounted on cross wire braced V-struts and a tailskid. [1]
The D 6 was test flown in the summer of 1918 but development was soon abandoned. [1]
Data from Green and Swanborough 1994 [1]
General characteristics
Performance
Armament
The Hanriot HD.6 was a French two-seat fighter aircraft prototype, built towards the end of World War I though not flown until after the armistice with Germany. A biplane with an unusually narrow gap between upper and lower wings, powered by a single water-cooled radial engine, it did not enter production.
The Nieuport Nie 31 or Nieuport 31 was a single-engine, single-seat monoplane or sesquiplane fighter aircraft designed and built in France in 1919.
The Siemens-Schuckert D.VI was a single engine, single seat, parasol wing German fighter aircraft flown in 1919.
The Spijker, Spyker V.1 or Spyker-Trompenburg V.1, was a single seat biplane fighter built in the Netherlands during World War I. It was underpowered and did not go into production.
The Kondor E 3, sometimes erroneously known as E.III, was a German single seat, monoplane fighter aircraft designed and built close to the end of World War I. Though successful in the third D-type fighter competition at Aldershof in September 1918, only a few were produced, given the Idflieg designation of Kondor D.I.
The Kondor D 7 was a prototype German single seat biplane fighter built over the winter of 1917-18. It was not a success and its development was soon abandoned.
The Pfalz D.XV was a German single seat fighter aircraft which was approved for production right at the end of World War I, too late to enter service.
The Pfalz D.VII was a German biplane fighter aircraft from World War I. It was not put into production.
The Pfalz D.VI was a German sesquiplane fighter aircraft from World War I. It was not put into production.
The Ponnier L.1 was an early French biplane single seat scout, built just before World War I. It did not reach production.
The Luft-Fahrzeug-Gesellschaft (LFG) Roland D.VII was a German single seat, single engine biplane fighter aircraft built during World War I. Problems with its underdeveloped V-8 engine prevented its production.
The LFG Roland D.IX was a World War I German single seat fighter aircraft, a biplane powered by one of a new generation of powerful rotary engines. Three slightly different prototypes were built but there was no series production.
The LFG Roland D.XV was a World War I German single seat fighter aircraft, ordered as a test-bed for engine comparisons. It was distinguished from earlier Roland biplane designs by the elimination of flying wires. Two later aircraft, also called LFG Roland D.XV, were completely different designs with slab sided fuselages.
The LFG Roland D.XVI, initially designated the LFG Roland E.I, was a single-seat, single-engine, parasol wing German fighter aircraft flown close to the end of World War I. Only two were built.
The Schütte-Lanz D.VII was a single engine, biplane fighter aircraft designed and built in Germany towards the end of World War I.
The Caudron C.21 was a French twin engine biplane built just after World War I, able to carry three passengers in an open cockpit.
The Caudron 02 was a French high altitude single seat fighter that was flown in November 1917.
The Descamps 27 C1 was a single seat biplane fighter aircraft, built in France in 1919. It was unusual in having a forward swept lower wing. After competitive trials, the Nieuport 29 was chosen for production, so only one Descamps was built.
The Kondor D 2 was a German single seat, biplane fighter aircraft designed and built close to the end of World War I.
The Itoh Emi 16 Fuji-go (Fuji), built in 1920, was intended as a cheap and simple general purpose civil biplane but gained publicity with exhibition flights and successful speed and altitude contests against higher-powered fighter aircraft.