| Slingsby Type 21 | |
|---|---|
 | |
| Slingsby T.21B | |
| Role | Training glider |
| National origin | United Kingdom |
| Manufacturer | Slingsby Sailplanes Ltd |
| Designer | Fred Slingsby |
| First flight | 1944 |
| Primary user | Royal Air Force (as Sedbergh TX.1) |
| Number built | ca. 226 |
The Slingsby T.21 is an open-cockpit, side-by-side two-seat glider, built by Slingsby Sailplanes Ltd and first flown in 1944. It was widely used by the Royal Air Force, Sri Lanka Air Force and by civilian gliding clubs.
The Type 21 prototype, the T.21P, first flew in 1944. It was of wooden construction covered with fabric, and was in most respects a scaled-up development of the single-seat German Grunau Baby, which Slingsby had built under licence before the war. The strut-braced wings had a span of 50 feet (15 m), and the upper decking section of the nose was removable, in order to expose the crew to the airflow in the same way as a primary glider. It was designed for use by the Air Training Corps, but was rejected by them and put into storage.
After the end of the war it was bought by the London Gliding Club, who found it very useful. Improvements were suggested, and the result was the T.21A, first flown in 1947, which had its wingspan increased to 54 feet (16 m), and dispensed with the removable nose section. Only one was built, but a slightly modified version, initially known as the T.28, was ordered by the Royal Air Force for Air Cadet training. This was the T.21B, which first flew in December 1947 and went into quantity production both for the RAF (named the Sedbergh TX.1 after the public school of that name) and for civilian clubs. Large numbers were exported to India, as well as to Egypt, Jordan, Kenya, Malaya, the Netherlands, Pakistan, Portugal, South Africa and Sweden.
Up to this time most training had been solo, on single-seat primary gliders, but the introduction of the T.21, together with its cousin, the tandem two-seat T.31, meant that virtually all initial training was being carried out in two-seaters by the early 1950s. The T.21 was popularly named "The Barge", after its boat-like hull and sedate flying qualities, while the T.31 was often referred to as "The Brick", again after its flying qualities.
Another one-off version was the T.21C, also known as the T.46, which flew in October 1957. The wings were lowered so they were placed either side of the upper fuselage, rather than on a pylon above the fuselage. This had the effect of increasing the span to 56 feet 6 inches (17.22 m). It also had an enclosed cockpit and redesigned tail surfaces.
Approximately 226 T.21Bs were built, with production ending in 1966. This total included 19 built for the RAF by Martin Hearn Ltd. at Hooton Park in 1950, and about five built by clubs and individuals from kits or spares. [1]
Data fromBritish Gliders and Sailplanes 1922-1970 [3] and The World's Sailplanes:Die Segelflugzeuge der Welt:Les Planeurs du Monde [4]
General characteristics
Performance
Related lists
{{cite book}}: CS1 maint: multiple names: authors list (link)
The Schneider Grunau Baby was a single-seat sailplane first built in Germany in 1931, with some 6,000 examples constructed in some 20 countries. It was relatively easy to build from plans, it flew well, and the aircraft was strong enough to handle mild aerobatics and the occasional hard landing. When the Baby first appeared, it was accepted wisdom that the pilot should feel as much unimpeded airflow as possible, to better sense rising and falling currents of air and temperature changes etc.
Frederick 'Fred' Nicholas Slingsby MM was the founder of Slingsby Sailplanes Ltd.
The Slingsby Type 42 Eagle was a two-seat glider designed in England from 1952.
The PIK-3 was a sailplane produced in Finland in the 1950s and 60s. It was designed to be a cheap and easy-to-build aircraft to equip the country's gliding clubs as their standard single-seat machine. It was a conventional design for its day, with a high wing and conventional empennage. Construction was of wood throughout, skinned in plywood.
The PIK-5 was a training glider produced in Finland in the 1940s, and 1950s, equipping the country's gliding clubs with an aircraft greater in performance than primary gliders but less than competition sailplanes.
The Slingsby T.49 Capstan is a British two-seat glider of the 1960s built by Slingsby Sailplanes as a replacement for their earlier Type 42 Eagle.
The Slingsby T.6/T.23 Kirby Kite was a single-seat sport glider produced from 1935, by Fred Slingsby in Kirbymoorside, Yorkshire.
The Slingsby T.8 Kirby Tutor was a single-seat sport glider produced from 1937, by Fred Slingsby in Kirbymoorside, Yorkshire.
The Slingsby T.12 Gull was a British single-seat glider designed and built by Slingsby Sailplanes and first flown in 1938.
The SZD-24 Foka (Seal) was a single-seat high-performance aerobatic glider designed and built in Poland in 1960.
The Slingsby T.25 Gull 4 is a British glider designed and built by Slingsby that first flew in 1947.
The Slingsby Type 34 Sky is a high performance single seat competition sailplane built in the United Kingdom. It was successful in major events, particularly in the World Gliding Championships of 1952.
The Slingsby T.30 Prefect is a 1948 British modernisation of the 1932 single-seat Grunau Baby glider. About 53 were built for civil and military training purposes.
The Slingsby Type 45 Swallow was designed as a club sailplane of reasonable performance and price. One of the most successful of Slingsby's gliders in sales terms, over 100 had been built when production was ended by a 1968 factory fire.
The Slingsby T.13 Petrel was a British single-seat competition glider built by Slingsby Sailplanes just before World War II.
The Slingsby T.50 Skylark 4 was a British single seat competition glider built by Slingsby Sailplanes in the early 1960s. It sold in numbers and had success at national, though not world level competition.
The Schneider ES-52 Kookaburra is an Australian two-seat training sailplane of the 1950s and 1960s. It was designed by Edmund Schneider, the designer of the Grunau Baby, who had emigrated to Adelaide, South Australia following the end of the Second World War.
The Czerwiński Sparrow, sometimes known as the de Havilland Canada glider, was a single seat glider, designed and built by a group of de Haviiland engineers in Canada in 1942. It was intended to popularise gliding and be suitable for both basic training and thermal soaring.
The Kometa-Standard was a Standard Class glider, designed and built in Bulgaria in the early 1960s. Thirty were flown by local gliding clubs.
The Schleicher Ka-2 Rhönschwalbe is a tandem two-seat training glider designed and built in Germany, in 1952.
{{cite book}}: CS1 maint: multiple names: authors list (link)