| Model E | |
|---|---|
 | |
| The A-1, the United States Navy's first aircraft | |
| Role | Utility aircraft |
| Manufacturer | Curtiss Aeroplane Company |
| Designer | Glenn Curtiss |
| First flight | 25 February 1911 |
The Curtiss Model E was an early aircraft developed by Glenn Curtiss in the United States in 1911.
Essentially a refined and enlarged version of the later "headless" Model D, variants of the Model E made important steps in pioneering the development of seaplanes and flying boats in America. Like its predecessor, the Model E was an open-framework biplane with two-bay unstaggered wings of equal span. In landplane configuration, it was fitted with tricycle undercarriage, and as a seaplane with a large central pontoon and outriggers under the wings. Most examples of the Model E followed the pattern of the "headless" Model Ds, with elevators and horizontal stabilizer carried together in the cruciform tail unit. The large ailerons were mounted in the interplane gap, their span continuing past the wings themselves, and as before were controlled by a shoulder yoke accommodating sideways "leaning" movements by the pilot to operate them. The Model E was designed and built as a two-seater, although in practice some of the lower-powered versions were converted to single-seaters.
Black pontoons on the wingtips of A-1 slanted diagonally backward toward the water to reduce friction on water and serve to balance aircraft on water. On the bottom of each pontoon is a little hydroplane of wood measuring 3-inch wide (76 mm) by 1⁄4-inch thick (6.4 mm) to further aid in balance and reduce friction. The front elevator on A-1 was at the aviators feet.
Triad could skim the water at 50 miles per hour (80 km/h) and had an endurance of 150 miles (240 km). Glenn Curtiss demonstrated a capability to skim along the surface in two-foot (0.61 m) seas. CAPT Washington Irving Chambers expressed confidence in landing in “moderate seas”, but stated he would not attempt to land in them and further added that they could adapt the movements of the Triad to conform to the seas.
The increased weight and drag of the “amphibian” gear cost the Triad 5 knots (9.3 km/h; 5.8 mph) of airspeed, so the more powerful 75 horsepower (56 kW) v8 was required to maintain the speed of the land plane configuration. Altitude was unaffected. [1]
The Model E achieved fame through examples purchased by the United States Navy. A $4,400 Model E-8-75 floatplane became the Navy's first aircraft when ordered by Captain Washington Irving Chambers on 8 May 1911 and received the designation A-1, as well as the nickname "Triad" hydroaeroplane since it could operate from land and sea and in the air. Theodore Ellyson became the Navy's first pilot when he took off from Keuka Lake near Hammondsport, New York on 30 June. In all, the Navy was to purchase some 14 Model Es, designating their earliest examples from A-1 to A-4, then redesignating these together with new purchases in the AH-1 to AH-18 block of serials. These aircraft achieved a number of firsts for the Navy, including the first cross-country flight in a seaplane, a world seaplane altitude record of 900 ft (274 m) a much later national seaplane altitude record of 6,200 ft (1,890 m), and, significantly for later naval operations, the first catapult launch of a seaplane.
The aircraft originally designated A-2 had an especially interesting career. Purchased by the Navy in landplane configuration on 13 July 1911, by August it was fitted with two long, cigar-shaped sheet metal cylinder pontoons beneath the bottom frame, about four feet from each aviator. [1] A-2 was converted into a floatplane the following June. In this configuration it set a seaplane flight endurance record of 6 hours 10 minutes on 6 October 1912. Later that month, it was extensively rebuilt along the lines of the Curtiss Tadpole hull, thus becoming the Navy's first flying boat. Later still, retractable wheels were added to create an amphibian that became known as the OWL (standing for "Over Water and Land"). This machine was redesignated E-1 and then AX-1 by the Navy and was finally destroyed on 27 November 1915.
In addition to their naval service, the type was operated by the Aeronautical Division, U.S. Signal Corps, which purchased two examples of the Model E-4 (Signal Corps numbers S.C. 6 and 8), built a third entirely from spare parts (S.C. 23), and later acquired one of the Navy's seaplanes (AH-8). Poor safety and reliability records of pusher aircraft led to all examples being grounded on February 24, 1914, although the AH-8 was flown briefly in 1928 following a refurbishment.
An original Model E-8-75 is preserved at the EAA AirVenture Museum and flew as recently as 1984. A replica of the A-1 was started in 1956, and built by employees of Convair, Ryan and Rohr for the San Diego Air & Space Museum. [2] It flew a number of times in 1984 before being retired for static display. Another replica was built by the Glenn H. Curtiss Museum and flown in 2004, notable for its use of Curtiss' original flight control system.
United States 
Data from Aerofiles : Curtiss [3]
General characteristics
Performance
Related development
A flying boat is a type of fixed-winged seaplane with a hull, allowing it to land on water. It differs from a floatplane in that a flying boat's fuselage is purpose-designed for floatation and contains a hull, while floatplanes rely on fuselage-mounted floats for buoyancy. Though the fuselage provides buoyancy, flying boats may also utilize under-wing floats or wing-like projections extending from the fuselage for additional stability. Flying boats often lack landing gear which would allow them to land on the ground, though many modern designs are convertible amphibious aircraft which may switch between landing gear and flotation mode for water or ground takeoff and landing.
A seaplane is a powered fixed-wing aircraft capable of taking off and landing (alighting) on water. Seaplanes are usually divided into two categories based on their technological characteristics: floatplanes and flying boats; the latter are generally far larger and can carry far more. Seaplanes that can also take off and land on airfields are in a subclass called amphibious aircraft, or amphibians. Seaplanes were sometimes called hydroplanes, but currently this term applies instead to motor-powered watercraft that use the technique of hydrodynamic lift to skim the surface of water when running at speed.
The Curtiss SOC Seagull was an American single-engined scout observation seaplane, designed by Alexander Solla of the Curtiss-Wright Corporation for the United States Navy. The aircraft served on battleships and cruisers in a seaplane configuration, being launched by catapult and recovered from a sea landing. The wings folded back against the fuselage for storage aboard ship. When based ashore or on carriers the single float was replaced by fixed wheeled landing gear.
The Curtiss Model N was a military trainer used primarily by the United States Navy during World War I.
The Boeing Model 2, also referred to as the Boeing Model C and its derivatives were United States two-place training seaplanes, the first "all-Boeing" design and the company's first financial success.
The Curtiss 18T, unofficially known as the Wasp and by the United States Navy as the Kirkham, was an early American triplane fighter aircraft designed by Curtiss for the US Navy.
The Breda A.4 was a biplane trainer produced in Italy in the mid-1920s. It was of conventional configuration with a two-bay unstaggered wing cellule and seating for the pilot and instructor in tandem open cockpits. Apart from civil use, the A.4 was also adopted by the Regia Aeronautica as a trainer. At least some examples were produced in floatplane configuration as the A.4idro.
The Curtiss Models F made up a family of early flying boats developed in the United States in the years leading up to World War I. Widely produced, Model Fs saw service with the United States Navy under the designations C-2 through C-5, later reclassified to AB-2 through AB-5. Several examples were exported to Russia, and the type was built under license in Italy.
The Curtiss Model H was a family of classes of early long-range flying boats, the first two of which were developed directly on commission in the United States in response to the £10,000 prize challenge issued in 1913 by the London newspaper, the Daily Mail, for the first non-stop aerial crossing of the Atlantic. As the first aircraft having transatlantic range and cargo-carrying capacity, it became the grandfather development leading to early international commercial air travel, and by extension, to the modern world of commercial aviation. The last widely produced class, the Model H-12, was retrospectively designated Model 6 by Curtiss' company in the 1930s, and various classes have variants with suffixed letters indicating differences.
The Curtiss R3C is an American racing aircraft built in landplane and floatplane form. It was a single-seat biplane built by the Curtiss Aeroplane and Motor Company.
The Curtiss R2C was a racing aircraft designed for the United States Navy in 1923 by Curtiss. It was a single-seater biplane with a monocoque fuselage and staggered single-bay wings of unequal span braced with I-struts. The aircraft's advanced streamlining featured a top wing mounted directly to the top of the fuselage and surface-mounted radiators for cooling the engine. The aircraft was originally designed and built as a landplane under the Navy designation R2C-1, of which two examples were produced. One was converted into a seaplane version known as the R2C-2 the following year.
The Curtiss CS was a reconnaissance and torpedo bomber aircraft used by the United States Navy during the 1920s. It was a large single-engine biplane with single-bay unstaggered wings, the design conventional in all respects other than that the lower wing was of greater span than the upper. The CS was built to allow its undercarriage to be quickly and easily interchangeable between wheeled, tailskid undercarriage, and twin pontoons for operation from water. Provision for the carriage of a torpedo was semi-recessed into the underside of the fuselage, blended in behind an aerodynamic fairing. The pilot and gunner sat in tandem open cockpits, while accommodation inside the fuselage was provided for a third crewmember who served as bombardier and radio operator. This station was also provided with a dorsal hatch aft of the gunner's position, and a ventral blister aft of the torpedo recess, which was used for aiming bombs or torpedoes.
The Curtiss Model R was a utility aircraft produced for the United States Army and Navy during World War I. It was a conventional, two-bay biplane with slightly staggered wings of unequal span. The aircraft was provided with two open cockpits in tandem and fixed tailskid undercarriage, but many were built for the Navy with twin floats replacing the wheels. During the course of the war, Model Rs were used for general liaison and communication duties, as well for observation, training, and as air ambulances. In practice, the Curtiss powerplants supplied with these aircraft proved insufficient and were mostly replaced with Liberty engines. The Navy's Model R-3 floatplane had extended-span, three-bay wings, and was intended for use as a torpedo bomber. Some of these were later fitted with wheeled undercarriage and transferred to the Army as bombers under the designation Model R-9.
The Keystone K-55 Pronto was a mail plane developed in the United States in the late 1920s.
The Norman Thompson N.1B was a prototype British flying boat fighter aircraft of the First World War. A two-seat single-engined pusher biplane, a single example was built in 1917, but no production followed.
The Sopwith Gunbus was a British fighter aircraft of the First World War. It was a single-engined pusher biplane based on a floatplane built by Sopwith before the war for Greece. Small numbers were built and used by the British Royal Naval Air Service, mainly as a trainer.
The Wanamaker Triplane or Curtiss Model T, retroactively renamed Curtiss Model 3 was a large experimental four-engined triplane patrol flying boat of World War I. It was the first four-engined aircraft built in the United States. Only a single example (No.3073) was completed. At the time, the Triplane was the largest seaplane in the world.
The Vought XSO2U was an American observation floatplane developed by Vought-Sikorsky for the United States Navy during the late 1930s. Intended to replace the Curtiss SOC Seagull in service as a scout aboard cruisers, it proved superior to the Curtiss SO3C in evaluation, but failed to win a production contract due to Vought's lack of manufacturing capacity.
The Curtiss Model K, also known as the Model 4, was an American single-engined flying boat of World War I. It was an enlarged derivative of Curtiss's Model F and about 50 were built for export to the Imperial Russian Navy.
Naval Aircraft Factory NO was an American short-range reconnaissance/gun spotting aircraft of the 1920s. A single-engined three-seat biplane with alternative floats or wheels, six were built for the U.S. Navy.
Media related to Curtiss Model E at Wikimedia Commons