Distribution in pharmacology is a branch of pharmacokinetics which describes the reversible transfer of a drug from one location to another within the body.
Once a drug enters into systemic circulation by absorption or direct administration, it must be distributed into interstitial and intracellular fluids. Each organ or tissue can receive different doses of the drug and the drug can remain in the different organs or tissues for a varying amount of time. [1] The distribution of a drug between tissues is dependent on vascular permeability, regional blood flow, cardiac output and perfusion rate of the tissue and the ability of the drug to bind tissue and plasma proteins and its lipid solubility. pH partition plays a major role as well. The drug is easily distributed in highly perfused organs such as the liver, heart and kidney. It is distributed in small quantities through less perfused tissues like muscle, fat and peripheral organs. The drug can be moved from the plasma to the tissue until the equilibrium is established (for unbound drug present in plasma).
The concept of compartmentalization of an organism must be considered when discussing a drug’s distribution. This concept is used in pharmacokinetic modelling.
There are many factors that affect a drug's distribution throughout an organism, but Pascuzzo [1] considers that the most important ones are the following: an organism's physical volume, the removal rate and the degree to which a drug binds with plasma proteins and / or tissues.
This concept is related to multi-compartmentalization. Any drugs within an organism will act as a solute and the organism's tissues will act as solvents. The differing specificities of different tissues will give rise to different concentrations of the drug within each group. Therefore, the chemical characteristics of a drug will determine its distribution within an organism. For example, a liposoluble drug will tend to accumulate in body fat and water-soluble drugs will tend to accumulate in extracellular fluids. The volume of distribution (VD) of a drug is a property that quantifies the extent of its distribution. It can be defined as the theoretical volume that a drug would have to occupy (if it were uniformly distributed), to provide the same concentration as it currently is in blood plasma. It can be determined from the following formula: Where: is total amount of the drug in the body and is the drug's plasma concentration.
As the value for is equivalent to the dose of the drug that has been administered the formula shows us that there is an inversely proportional relationship between and . That is, that the greater is the lower will be and vice versa. It therefore follows that the factors that increase will decrease . This gives an indication of the importance of knowledge relating to the drug's plasma concentration and the factors that modify it.
If this formula is applied to the concepts relating to bioavailability, we can calculate the amount of drug to administer in order to obtain a required concentration of the drug in the organism ('loading dose):
This concept is of clinical interest as it is sometimes necessary to reach a certain concentration of a drug that is known to be optimal in order for it to have the required effects on the organism (as occurs if a patient is to be scanned).
A drug's removal rate will be determined by the proportion of the drug that is removed from circulation by each organ once the drug has been delivered to the organ by the circulating blood supply. [1] This new concept builds on earlier ideas and it depends on a number of distinct factors:
Some drugs have the capacity to bind with certain types of proteins that are carried in blood plasma. This is important as only drugs that are present in the plasma in their free form can be transported to the tissues. Drugs that are bound to plasma proteins therefore act as a reservoir of the drug within the organism and this binding reduces the drug's final concentration in the tissues. The binding between a drug and plasma protein is rarely specific and is usually labile and reversible. The binding generally involves ionic bonds, hydrogen bonds, Van der Waals forces and, less often, covalent bonds. This means that the bond between a drug and a protein can be broken and the drug can be replaced by another substance (or another drug) and that, regardless of this, the protein binding is subject to saturation. An equilibrium also exists between the free drug in the blood plasma and that bound to proteins, meaning that the proportion of the drug bound to plasma proteins will be stable, independent of its total concentration in the plasma.
In vitro studies carried out under optimum conditions have shown that the equilibrium between a drug's plasmatic concentration and its tissue concentration is only significantly altered at binding rates to plasma proteins of greater than 90%. Above these levels the drug is "sequestered", which decreases its presence in tissues by up to 50%. This is important when considering pharmacological interactions: the tissue concentration of a drug with a plasma protein binding rate of less than 90% is not going to significantly increase if that drug is displaced from its union with a protein by another substance. On the other hand, at binding rates of greater than 95% small changes can cause important modifications in a drug's tissue concentration. This will, in turn, increase the risk of the drug having a toxic effect on tissues.
Perhaps the most important plasma proteins are the albumins as they are present in relatively high concentrations and they readily bind to other substances. Other important proteins include the glycoproteins, the lipoproteins and to a lesser degree the globulins.
It is therefore easy to see that clinical conditions that modify the levels of plasma proteins (for example, hypoalbuminemias brought on by renal dysfunction) may affect the effect and toxicity of a drug that has a binding rate with plasma proteins of above 90%.
Highly lipid-soluble drugs given by intravenous or inhalation methods are initially distributed to organs with high blood flow. Later, less vascular but more bulky tissues (such as muscle and fat) take up the drug—plasma concentration falls and the drug is withdrawn from these sites. If the site of action of the drug was in one of the highly perfused organs, redistribution results in termination of the drug action. The greater the lipid solubility of the drug, the faster its redistribution will be. For example, the anaesthetic action of thiopentone is terminated in a few minutes due to redistribution. However, when the same drug is given repeatedly or continuously over long periods, the low-perfusion and high-capacity sites are progressively filled up and the drug becomes longer-acting.
A hormone is a class of signaling molecules in multicellular organisms that are sent to distant organs by complex biological processes to regulate physiology and behavior. Hormones are required for the correct development of animals, plants and fungi. Due to the broad definition of a hormone, numerous kinds of molecules can be classified as hormones. Among the substances that can be considered hormones, are eicosanoids, steroids, amino acid derivatives, protein or peptides, and gases.
In cell biology, extracellular fluid (ECF) denotes all body fluid outside the cells of any multicellular organism. Total body water in healthy adults is about 60% of total body weight; women and the obese typically have a lower percentage than lean men. Extracellular fluid makes up about one-third of body fluid, the remaining two-thirds is intracellular fluid within cells. The main component of the extracellular fluid is the interstitial fluid that surrounds cells.
Pharmacodynamics (PD) is the study of the biochemical and physiologic effects of drugs. The effects can include those manifested within animals, microorganisms, or combinations of organisms.
ADME is an abbreviation in pharmacokinetics and pharmacology for "absorption, distribution, metabolism, and excretion", and describes the disposition of a pharmaceutical compound within an organism. The four criteria all influence the drug levels and kinetics of drug exposure to the tissues and hence influence the performance and pharmacological activity of the compound as a drug. Sometimes, liberation and/or toxicity are also considered, yielding LADME, ADMET, or LADMET.
Drug interactions occur when a drug's mechanism of action is affected by the concomitant administration of substances such as foods, beverages, or other drugs. The cause is often inhibition of, or less effective action, of the specific receptors available to the drug. This influences drug molecules to bind to secondary targets, which may result in an array of unwanted side-effects.
In pharmacology, the volume of distribution is the theoretical volume that would be necessary to contain the total amount of an administered drug at the same concentration that it is observed in the blood plasma. In other words, it is the ratio of amount of drug in a body (dose) to concentration of the drug that is measured in blood, plasma, and un-bound in interstitial fluid.
Physiologically based pharmacokinetic (PBPK) modeling is a mathematical modeling technique for predicting the absorption, distribution, metabolism and excretion (ADME) of synthetic or natural chemical substances in humans and other animal species. PBPK modeling is used in pharmaceutical research and drug development, and in health risk assessment for cosmetics or general chemicals.
Microdialysis is a minimally-invasive sampling technique that is used for continuous measurement of free, unbound analyte concentrations in the extracellular fluid of virtually any tissue. Analytes may include endogenous molecules to assess their biochemical functions in the body, or exogenous compounds to determine their distribution within the body. The microdialysis technique requires the insertion of a small microdialysis catheter into the tissue of interest. The microdialysis probe is designed to mimic a blood capillary and consists of a shaft with a semipermeable hollow fiber membrane at its tip, which is connected to inlet and outlet tubing. The probe is continuously perfused with an aqueous solution (perfusate) that closely resembles the (ionic) composition of the surrounding tissue fluid at a low flow rate of approximately 0.1-5μL/min. Once inserted into the tissue or (body)fluid of interest, small solutes can cross the semipermeable membrane by passive diffusion. The direction of the analyte flow is determined by the respective concentration gradient and allows the usage of microdialysis probes as sampling as well as delivery tools. The solution leaving the probe (dialysate) is collected at certain time intervals for analysis.
In pharmacology, clearance is a pharmacokinetic measurement of the volume of plasma from which a substance is completely removed per unit time. Usually, clearance is measured in L/h or mL/min. The quantity reflects the rate of drug elimination divided by plasma concentration. Excretion, on the other hand, is a measurement of the amount of a substance removed from the body per unit time. While clearance and excretion of a substance are related, they are not the same thing. The concept of clearance was described by Thomas Addis, a graduate of the University of Edinburgh Medical School.
Biological half-life is the time taken for concentration of a biological substance to decrease from its maximum concentration (Cmax) to half of Cmax in the blood plasma. It is denoted by the abbreviation .
Cinnarizine is an antihistamine and calcium channel blocker of the diphenylmethylpiperazine group. It is prescribed for nausea and vomiting due to motion sickness or other sources such as chemotherapy, vertigo, or Ménière's disease.
The initial volume of distribution (Vi) is a pharmacological term used to quantify the distribution of a drug throughout the body relatively soon after oral or intravenous dosing of a drug and prior to the drug reaching a steady state equilibrium. Following distribution of the drug, measurement of blood levels indicate the apparent volume of distribution. Calculation of the initial volume of distribution is the same calculation as that for the apparent volume of distribution, given by the equation:
Context-sensitive half-life or context sensitive half-time is defined as the time taken for blood plasma concentration of a drug to decline by one half after an infusion designed to maintain a steady state has been stopped. The "context" is the duration of infusion.
Plasma protein binding refers to the degree to which medications attach to blood proteins within the blood plasma. A drug's efficacy may be affected by the degree to which it binds. The less bound a drug is, the more efficiently it can traverse or diffuse through cell membranes. Common blood proteins that drugs bind to are human serum albumin, lipoprotein, glycoprotein, and α, β‚ and γ globulins.
In pharmacokinetics and receptor-ligand kinetics the binding potential (BP) is a combined measure of the density of "available" neuroreceptors and the affinity of a drug to that neuroreceptor.
Pharmacokinetics, sometimes abbreviated as PK, is a branch of pharmacology dedicated to determining the fate of substances administered to a living organism. The substances of interest include any chemical xenobiotic such as: pharmaceutical drugs, pesticides, food additives, cosmetics, etc. It attempts to analyze chemical metabolism and to discover the fate of a chemical from the moment that it is administered up to the point at which it is completely eliminated from the body. Pharmacokinetics is the study of how an organism affects a drug, whereas pharmacodynamics (PD) is the study of how the drug affects the organism. Both together influence dosing, benefit, and adverse effects, as seen in PK/PD models.
In pharmacokinetics, a compartment is a defined volume of body fluids, typically of the human body, but also those of other animals with multiple organ systems. The meaning in this area of study is different from the concept of anatomic compartments, which are bounded by fasciae, the sheath of fibrous tissue that enclose mammalian organs. Instead, the concept focuses on broad types of fluidic systems. This analysis is used in attempts to mathematically describe distribution of small molecules throughout organisms with multiple compartments. Various multi-compartment models can be used in the areas of pharmacokinetics and pharmacology, in the support of efforts in drug discovery, and in environmental science.
Blood–gas partition coefficient, also known as Ostwald coefficient for blood–gas, is a term used in pharmacology to describe the solubility of inhaled general anesthetics in blood. According to Henry's law, the ratio of the concentration in blood to the concentration in gas that is in contact with that blood, when the partial pressure in both compartments is equal, is nearly constant at sufficiently low concentrations. The partition coefficient is defined as this ratio and, therefore, has no units. The concentration of the anesthetic in blood includes the portion that is undissolved in plasma and the portion that is dissolved. The more soluble the inhaled anesthetic is in blood compared to in air, the more it binds to plasma proteins in the blood and the higher the blood–gas partition coefficient.
In pharmacology the elimination or excretion of a drug is understood to be any one of a number of processes by which a drug is eliminated from an organism either in an unaltered form or modified as a metabolite. The kidney is the main excretory organ although others exist such as the liver, the skin, the lungs or glandular structures, such as the salivary glands and the lacrimal glands. These organs or structures use specific routes to expel a drug from the body, these are termed elimination pathways:
A ligand binding assay (LBA) is an assay, or an analytic procedure, which relies on the binding of ligand molecules to receptors, antibodies or other macromolecules. A detection method is used to determine the presence and extent of the ligand-receptor complexes formed, and this is usually determined electrochemically or through a fluorescence detection method. This type of analytic test can be used to test for the presence of target molecules in a sample that are known to bind to the receptor.