This article needs additional citations for verification .(November 2024) |
Tatra 111 | |
---|---|
Overview | |
Manufacturer | Tatra |
Production | 1942-1962 |
Designer | Hans Ledwinka |
Body and chassis | |
Class | Heavy truck |
Body style | Conventional |
Related | |
Powertrain | |
Engine | See below |
Transmission | 4-speed manual x 2-speed transfer case |
Chronology | |
Predecessor | Tatra 81 |
Successor | Tatra 138 |
Engine V910 | |
---|---|
Overview | |
Manufacturer | Tatra |
Also called | V910 |
Layout | |
Configuration | 75° V12 |
Displacement | 14.8 L (903 cu in) |
Cylinder bore | 110 mm (4.3 in) |
Piston stroke | 130 mm (5.1 in) |
Cylinder block material | Cast iron |
Valvetrain | OHV |
Compression ratio | 16.5:1 |
Combustion | |
Fuel system | Direct injection 2x inline injection pumps 6 elements each |
Fuel type | Diesel |
Cooling system | Air-cooled |
Output | |
Power output | 180–210 hp (132.5 kW-158kW) @ 1800–2250 rpm |
Torque output | 726 N⋅m (535 ft⋅lbf) @ 1400–1600 rpm |
The Tatra 111 was a truck produced in Czechoslovakia by the Tatra company.
The T111 was developed and manufactured during World War II as a heavy truck for use by the Wehrmacht. Production started in 1942 and continued for twenty years, ending in 1962 when it was replaced by the Tatra 138 [1] . Despite being built for the Nazi war machine [2] , the vehicle ultimately played an important role after the war ended. The Tatra 111 contributed significantly to the rebuilding effort during the postwar era, mainly in Eastern Europe and the USSR. To its chief designer, however, it brought charges of treason and collaboration with the Nazi regime after the communist takeover of Czechoslovakia and contributed to the imprisonment of Tatra's design guru Hans Ledwinka.
The design was based on the proven Tatra concept of a backbone tube chassis construction with swing half axles, a modular gearbox and differential assemblies. The main advantages of the central load carrying backbone tube are its high torsion and bend strength, which protects the truck body against load stresses. The secondary advantage is that it houses all important parts of the drivetrain. Due to its torsional stiffness and use of differentials locks the vehicle had exceptional offroad capabilities. Of note was the ability to use a cranking handle to start the engine.
Model V910 - the first Tatra air-cooled powerplant V12 75-degree V developed from Tatra V850 engine intended for use in Tatra 103 (Sd.Kfz. 234 Puma). The engines had power output of 210 horsepower at 2250 rpm mainly for war use (An average life expectancy during combat for Wehrmacht was 6 hours.) which was later reduced to 180 hp at 1800 rpm to increase reliability. The engine has three camshafts and originally was cooled by two covered chain-driven cooling fans and later belt drive (marked T111A).
Central backbone tube, front and rear axles with independent swing half axles. Front axle suspended on quarter elliptic leaf springs, rear axles suspended on half elliptic longitudinal leaf spring. The service brakes were air all-round drums, parking brake had mechanical actuation on the rear end of backbone tube output shaft via a rotating drum.
The cab originally used wood for its construction due to strategic unavailability of steel during the war, in later years the wooden frame was steel plated and the last models used an all-steel cabin. The vehicle was capable of a top speed of approximately 65 km/h (40 mph). The maximum cargo capacity was 10.3 tonnes and it had the ability to tow up to 22 tonnes trailer.
The Tatra 111 was in production for 20 years, with a total of approximately 34,000 units built. The T111 engine was widely used in the variety of other vehicles such as a heavy tractor T141, a railway car M 131, airport tugs and pontoon bridges used by the army. The engine was also "halved" to create an inline 6-cylinder version for the Praga V3S 6x6 light utility military truck and civilian Praga S5T light truck. Based on the T111 V12 engine, a V8 version was created for the T128 4x4 truck for the Czechoslovak armed forces, designed mostly from T111 parts. T111 main product range was in flatbed, tipper, tanker and crane configuration.
Model | Type |
---|---|
T111 R | Flatbed |
T111 NR | Flatbed with auxiliary gearbox powered winch |
T111 N Special | Flatbed with foldable sides, winch military specs |
T111 S | Three-way tipper with wooden sides |
T111 S2 | All-steel three-way tipper heavy duty |
T111 C | Tanker |
T111 D | Bodybuilders chassis |
The Tatra T111's exploits in Siberia had earned its reputation, and its legendary reliability contributed to its iconic status among those who drove and lived in those conditions. The T111 concept and technology continued its evolution in following years with subsequent Tatra truck models.
Tatra is a Czech vehicle manufacturer from Kopřivnice. It is owned by the TATRA TRUCKS a.s. company, and it is the third oldest company in the world producing motor vehicles with an unbroken history. The company was founded in 1850 as Ignatz Schustala & Cie. In 1890 the company became a joint-stock company and was renamed the Nesselsdorfer Wagenbau-Fabriksgesellschaft. In 1897, the Nesselsdorfer Wagenbau-Fabriksgesellschaft produced the Präsident, which was the first factory-produced automobile with a petrol engine to be made in Central and Eastern Europe. The First Truck was made a year later, in 1898. In 1918, the company was renamed Kopřivnická vozovka a.s., and in 1919 it changed from the Nesselsdorfer marque to the Tatra badge, named after the nearby Tatra Mountains on the Czechoslovak-Polish border.
The Tatra 815 is a truck family, produced by Czech company Tatra. It uses the traditional Tatra concept of rigid backbone tube and swinging half-axles giving independent suspension. The vehicles are available in 4x4, 6x6, 8x8, 10x8, 10x10, 12x8 and 12x12 variants. There are both air-cooled and liquid-cooled engines available with power ranging from 230–440 kilowatts (310–590 hp). As a successor to Tatra 813 it was originally designed for extreme off-road conditions, while nowadays there are also variants designated for mixed use. The gross weight is up to 35,500 kg (78,264 lb).
A portal axle is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. It gives two advantages: ground clearance is increased, particularly beneath the low-slung differential housing of the main axles — and secondly, any hub reduction gearing allows the axle half shafts to drive the same power but at reduced torque. This reduces load on the axle crown wheel and differential.
Backbone tube chassis is a type of automobile construction chassis that is similar to the body-on-frame design. Instead of a two-dimensional ladder-type structure, it consists of a strong tubular backbone that connects the front and rear suspension attachment areas. A body is then placed on this structure. It was first used in the English Rover 8hp of 1904 and then the French Simplicia automobile in 1909.
The TatraT813 was a truck produced in Czechoslovakia by the Tatra company. It was produced from 1967 to 1982. The basic representative of this series was a military version of the 8×8 Kolos (Colossus), which was able to pull trailers up to a total weight of 100 tons. Tatra also produced a civilian version in either 6×6 or 4×4. After fifteen years of production, 11,751 vehicles were built in all modifications. Many units were exported to the USSR, East Germany, Romania and India.
The Tatra 148 was a truck produced in Czechoslovakia by the Tatra company.
The Tatra T11 is an automobile that was produced from 1923 through 1927. It was the first Tatra model to use backbone tube chassis, swinging half-axles and air-cooled engine, the development of which is still in use on the trucks produced by Tatra to this day.
The Tatra 138 was a truck produced in Czechoslovakia by the Tatra company. The immediate successor to the Tatra 111, the model introduced a number of new features while continuing the evolution of Tatra concept. The truck was produced from 1959 to 1971.
FAP 2026 is a general purpose off-road lorry made by Serbian vehicle manufacturer Fabrika automobila Priboj (FAP). The six-wheel drive lorry is designed for transport of personnel, weapons and material up to 6 t of total weight, as for traction of weapons and trailer up to 7.2 t of weight for the needs of the Yugoslav People's Army.
The Tatra 54 is an automobile launched by Tatra in 1931. An economy version of the Tatra 52, it was replaced in 1933 by the Tatra 75.
The Tatra 12 is an automobile produced by Czech manufacturer Tatra between 1926 and 1933. It was replaced by the Tatra 57 in 1932.
The Tatra 26 is a vintage 6x4 automobile produced by the Czech manufacturer Tatra in the late 1920s and early 1930s. It was developed on the basis of the T 12. However, tests showed that the engine from T 12 did not have enough power, and it was replaced by the Tatra 30 engine. The car had extreme off-road abilities - reportedly it was even able to climb staircases.
The Tatra 17 is an automobile produced by the Czech manufacturer Tatra between 1925 and 1929. It was the company's top-end model, and was sold alongside the Tatra 12 economy car and the Tatra 30 executive car.
The Tatra T 810 (Tactic) is a medium truck made by Czech company Tatra; it replaced the popular Praga V3S which was introduced in the 1950s and served in the Army of the Czech Republic until 2008. Unlike other Tatra trucks, it does not use classic Tatra air-cooled engine and the traditional Tatra conception of backbone chassis and swinging half-axles, but the customary truck architecture with conventional frame. It is mainly intended for difficult terrain conditions. The civilian version T 810-C was introduced in 2010.
The Tatra T 163 Jamal is a heavy truck made by the Czech company Tatra. It uses the traditional Tatra concept of a rigid backbone tube and swinging half-axles giving independent suspension. The vehicles are available primarily in 6x6 and alternatively also 4x4 variants. It is marketed either as a road-legal heavy truck or as a working machine. The T163 is a continuation of the tradition started with the Tatra T 111, which played a crucial role in the effort to rebuild Central and Eastern Europe after the Second World War as well as in conquering the Russian Far East.
The Tatra T816 is a truck family, produced by Czech company Tatra. It uses the traditional tatra concept of rigid backbone tube and swinging half-axles giving independent suspension. The vehicles are available in 4x4, 6x6, 8x8, 10x8, 10x10, 12x8 and 12x12 variants. The truck was developed from the model T815 to comply with the most demanding off-road conditions. Originally the T816 range was developed for the purposes of military, however today also civilian applications are available (notably as heavy off-road firefighting trucks.
The original Škoda Superb is a full size luxury car that was made by the Czechoslovak car manufacturer ASAP, later AZNP from 1934 to 1949. It was the company's first car with a V8 engine and all-wheel drive.
An H-drive drivetrain is a system used for heavy off-road vehicles with 6×6 or 8×8 drive to supply power to each wheel station.
The Volkswagen Typ 87, also known as the Kommandeurswagen, is a World War II, four-wheel-drive version of the Volkswagen Beetle. It was produced from 1941 to 1944 by the Volkswagen plant, primarily for high officers of the Wehrmacht. The Wehrmacht classified the Kommandeurswagen as leichter geländegängiger PKW, 4-sitziger, 4-radgetriebener Geländewagen Typ 87..
The Unimog 404, also called the Unimog S and Unimog 404 S, is a vehicle of the Unimog-series by Mercedes-Benz, produced in the Unimog plant in Gaggenau from 1955 to 1980. Marketed as Unimog U82, and later Unimog U110, 64,242 units of the two Unimog 404 types 404.0 and 404.1 were built, which makes the 404 the Unimog model with the highest production figure of all Unimogs. Unlike the Unimog 401, the 404 is rather a small 1.5-tonne-offroad-truck than an agricultural vehicle. In Germany, it was a common military vehicle and fire engine, 36,000 Unimog 404 were made for the Bundeswehr.