| Ca.4 | |
|---|---|
 | |
| Caproni Ca.40 heavy bomber prototype | |
| Role | Heavy bomber; later variants included airliners |
| Manufacturer | Caproni |
| First flight | 1917 |
| Introduction | 1918 |
| Status | Retired |
| Primary users | Italian Army United Kingdom (Royal Naval Air Service) United States |
| Number built | 44 to 53 |
The Caproni Ca.4 was an Italian heavy bomber of the World War I era.
After designing the successful Ca.3, Gianni Caproni of the Caproni works designed a much bigger aircraft. It shared the unusual layout of the Caproni Ca.3, being a twin-boom aircraft with one pusher engine at the rear of a central nacelle and two tractor engines in front of twin booms, providing a push-pull configuration. The twin booms carried a single elevator and three fins. [1] The main landing gear was fixed and consisted of two sets of four wheels each. [1]
The huge new bomber was accepted by the Italian Army under the military designation Ca.4, but it was produced in several variants, differing in factory designations.
The Ca.4 was a three-engine, twin-fuselage [2] triplane of wooden construction with a fabric-covered frame. An open central nacelle was attached to the undersurface of the center wing. It contained a single pusher engine, pilot, and forward gunner. The remaining engines were tractor mounted at the front of each fuselage. At least one variation of the central nacelle seated the crew in a two-seat tandem format with the forward position for a gunner/pilot and the rear position for the pilot. Others used a forward gunner with side-by-side pilot positions to the rear of the gunner. Two rear gunners were positioned, one in each boom behind the center wing. An engineer or second pilot could also be accommodated there.
Armament consisted of four (but up to eight) Revelli 6.5 mm or 7.7 mm machine guns in front ring mounts and two boom ring mounts. Bombs were suspended in a bomb bay, which was a long and narrow container fixed to a lower wing. Photographs show at least four different arrangements with regard to the bombing nacelle.
Note: during the war, all these aircraft were designated Ca.4 by the Italian Army. At the time, Caproni referred to the various designs by the total power of their engines. After the war, Caproni devised a new designation scheme for their own designs—these are used below.
Production figures differ in publications. The most likely number is 38 of all Ca.4 variants (other quoted figures are: 38 of Ca.40 and Ca.41 and 6 Ca.42 or 32 Ca.42 and 21 of other variants). Numerous publications incorrectly refer to all variants as the Ca.42.
Ca.4s were tested by the Italian Air Force in 1917 and began operations in 1918. They were used for attacking targets in Austria-Hungary. In April 1918, six Ca.42s were issued to the British RNAS (No. 227 Sqn) but were never used operationally and were returned to Italy after the war. [5] At least three CA.42s were sent to the United States for evaluation. After the war, the Ca. 4 was replaced in Italy by the Ca.36.
Despite its unstable and fragile appearance, the Ca.4 was well designed. Its size, without regard to its height, was not any larger than that of other foreign heavy bombers. With Liberty engines, it had a fast speed, similar to other heavy bombers, while its bombload had one of the largest capacities of that era, surpassed only by that of the Imperial German Zeppelin-Staaken R.VI. If it had been flown with other engines, its performance would have suffered.
On 2 August 1919, after its wings apparently collapsed in mid-flight at an altitude of 3,000 feet (910 meters), a Ca.48 airliner crashed at Verona, Italy, during a flight from Venice to Taliedo, Milan. [6] All on board died. [Note 1] It was Italy's first commercial aviation disaster and one of the earliest heavier-than-air airliner disasters.
Kingdom of Italy 
United Kingdom 
United States General characteristics
Performance
Armament
Related lists
The Caproni Ca.3 is an Italian heavy bomber of World War I and the postwar era. It was the most produced version of the series of aircraft that began with the 1914 Caproni Ca.1 and continued until the more powerful 1917 Caproni Ca.5 variant.
The Caproni Ca.1 was an Italian heavy bomber of the World War I era.
The Caproni Ca.2 was an Italian heavy bomber of the World War I era.
The Caproni Ca.5 was an Italian heavy bomber of World War I and the postwar era. It was the final version of the series of aircraft that began with the Caproni Ca.1 in 1914.
The Caproni Ca.37 was a ground attack aircraft designed and built in Italy by Caproni around 1916.
Between 1911 and 1914, the Royal Aircraft Factory used the F.E.2 designation for three quite different aircraft that shared only a common "Farman" pusher biplane layout.
The Caproni Ca.60 Transaereo, often referred to as the Noviplano (nine-wing) or Capronissimo, was the prototype of a large nine-wing flying boat intended to become a 100-passenger transatlantic airliner. It featured eight engines and three sets of triple wings.
The Boeing GA-1 was an armored triplane. Designed in 1919, it was powered by a pair of modified Liberty engines driving pusher propellers. The first of the Engineering Division's heavily armored GAX series aircraft, the ponderous airplane was intended to strafe ground troops while remaining immune to attack from the ground as well as from other enemy aircraft. It was so well armored that its five-ton weight proved excessive.
The Caproni Ca.135 was an Italian medium bomber designed in Bergamo in Italy by Cesare Pallavicino. It flew for the first time in 1935, and entered service with the Peruvian Air Force in 1937, and with the Regia Aeronautica in January 1938.
The Caproni Ca.101 was a three-engine Italian airliner which later saw military use as a transport and bomber. It was designed in 1927 and first flown in 1928.
The Caproni Ca.73 was an Italian airliner produced during the 1920s which went on to serve as a light bomber in the newly independent Regia Aeronautica.
The Grahame-White Ganymede was a prototype British heavy night bomber intended to serve with the Royal Air Force in the First World War. A large, three-engined, twin-boom biplane, the sole prototype Ganymede did not fly until after the war had ended, and although an attempt was made to convert the aircraft to an airliner, it was unsuccessful.
The Caproni Ca.355 Tuffo was a low-wing single-engine dive bomber, designed and built by the Italian Caproni company in 1941, which never proceeded beyond a single prototype. Derived from Ca.335 Mistral, the Ca.355 was proposed to equip the Regia Aeronautica, but it was found to offer little advantage over the German Junkers Ju 87 "Stuka" and the project was abandoned.
The Caproni Ca.49 was a proposed Italian seaplane airliner of 1919.
The Zeppelin-Staaken Riesenflugzeuge were a series of very large bomber aircraft - Riesenflugzeuge, usually powered by four or more engines, designed and built in Germany from 1915 to 1919.
The Siemens-Schuckert L.I was a large, three-engined biplane bomber aircraft, built in Germany towards the end of World War I. It was a twin boom design, strongly influenced by the successful Caproni Ca.3. Three were built but not used operationally.
The Lloyd 40.08 Luftkreuzer was a three engine triplane bomber type built during World War I. The design was proven to be ineffective and development did not proceed past the prototype stage.
The Caproni Ca.61 was an Italian heavy day bomber aircraft of 1922. It was the final development of the Caproni three engine, twin boom biplane types developed during World War I, but it was not put into production.
The Caproni Ca.66 was an Italian night bomber designed to reequip the post-World War I Italian Air Force. Only two examples of the four-engined biplane were built.
The Caproni Ca.66 and Caproni Ca.67 were Italian night bomber aircraft designed to re-equip the post-World War I Regia Aeronautica.
| Authority control databases: National |
|---|
