| Sauro-1 | |
|---|---|
 | |
| Role | Two seat touring aircraft |
| National origin | Italy |
| Manufacturer | Società Italiana Caproni |
| Designer | Emmanuale Trigona |
| First flight | 1933 |
| Number built | 1 |
The Caproni Sauro-1 (English: Sorrel), or Caproni Tricap, was a light, single-engine cantilever monoplane, seating two in tandem, built in Italy in the early 1930s for touring. Despite good performance and favourable test reports, only one was built.
The Caproni Sauro-1 was not a Caproni design, but was built by them to a design from Emmanuele Trigona, leading to the alternative name Tricap (Trigone Caproni). It was an aerodynamically clean cantilever monoplane with a low inverted gull wing. The wing was thick with a wide chord at the root, tapering both in plan and in thickness along the span to rounded wing tips. Structurally the Sauro was a mixture of wood and chrome steel frames, covered with plywood and fabric. On the wings the plywood was stress bearing. Camber changing gear linked the neutral position of the ailerons and the angle of incidence of the tailplane; the ailerons maintained their normal opposing deflections for lateral control. The fixed, conventional undercarriage took advantage of the inverted gull wing by placing the main legs at the lowest points of the wings, keeping the legs short and the track wide. Shallow, full chord fairings enclosed the legs and part of the mainwheels, which had rubber shock absorbers and brakes. [1] [2]
The Sauro was powered by a 97 kW (130 hp) Farina T-58 radial engine within a domed cowling that left its five cylinders individually exposed. Behind the engine the fuselage was ovoidal in cross-section and tapered only slowly to the tail. It had a chrome steel frame, covered with plywood and fabric. The two tandem cockpits, the forward one over the wing and the other just behind its trailing edge, had long headrest deckings behind them that extended to the tail. The cockpits were equipped with dual controls; those of the forward position could be disconnected in flight. Both seats had room for a parachute. The tail surfaces were conventional, steel-framed and covered with a mixture of aluminium and fabric, with the tapered tailplane set at mid-fuselage with an angular fin and rudder above. The rudder ended above the fuselage, angled to allow for elevator movement. A steel shod, rubber-sprung tailskid was mounted at the end of the fuselage. [1] [2]
The Sauro was built at Caproni's main Taliedo works, then tested at Guidonia Montecelio under military markings. The aircraft was judged a success, with good performance and handling, but there was no development or production. Trigona carried over some features of the Sauro into a fighter design but this was abandoned in 1943. [1]
Data fromItalian Civil and Military Aircraft 1930-1945 [1]
General characteristics
Performance
VL Viima, constructed by the State Aircraft Factory is a Finnish two-seat, biplane trainer used by the Finnish Air Force from the late 1930s to the early 1960s. After military service, several were released into civil use.
The Gordon Dove was a British low powered, low wing single seat monoplane, built for the ultralight sports market in competition with aircraft like the Belgian designed Tipsy S. There was little enthusiasm for such machines in England in the late 1930s and only three were constructed.
The Koolhoven F.K.57 was a twin-engined, gull-winged monoplane built in the Netherlands as a personal transport for the Director General of Royal Dutch Shell. Only one was made, flying chiefly in Europe in the year before World War II, but destroyed when Germany invaded the Netherlands in May 1940.
The IAR-22 was a single engine basic trainer built in Romania in about 1934. It was a low-wing monoplane with two seats in tandem and a fixed conventional undercarriage.
The Caproni Bergamaschi PL.3 was designed and built in Italy to compete in the 1934 London-to-Melbourne air race. It was a single-engine cantilever monoplane with clean lines, retractable undercarriage and side-by-side seating for two. Though it was registered as a race entrant, late delays prevented it from competing.
The CVV1 Pinguino was a single seat, high performance glider designed and built in Italy in the mid-1930s, the first of a series of gliders from the Milan Polytechnic. It did not go into production.
The Bonomi BS.19 Alca was a single seat, tractor configuration motor glider, designed and built in Italy shortly before World War II. It had an unusual retractable undercarriage used only for take-offs. Only one was built.
The Aviomilano CPV1, also known as the Arlecchino, was an Italian high performance sailplane built in the early 1960s. Only one was built.
The Caproni Vizzola MF and 2 were single-seat gliders built in Italy just before World War II. Intended as training aircraft capable of aerobatics, the two variants differed only in their fuselages. Only one of each was built, but they were both successful in Italian competitions.
The Romeo Ro.35, a.k.a.IMAM Ro.35 was a single-seat glider built in Italy in 1933.
The CVT1 Zigilo was a single-seat, 12-metre-span (39 ft) Italian training glider designed and built in Italy in the 1950s. Only one was completed.
The Teichfuss Gabbiano was an Italian, one-off, single seat, high performance glider, designed by Luigi Teichfuss and flown in 1928.
The Teichfuss Borea or LT.35 Borea was an Italian high performance glider designed by Luigi Teichfuss. It was completed by 1943 but never flew and the sole example was destroyed during the German occupation of Italy.
The CAT 28BP was an Italian development of the licence built Dittmar Condor II into a high performance tandem two seat glider. Built in 1938, it anticipated the post-war, two seat Dittmar Condor IV and held the Italian national distance record for many years.
The IFIL-Reghin RG-5 Pescăruș or CIL Reghin RG-5 Pescăruș was a Romanian single seat sailplane built in the 1950s. Twenty six were constructed for gliding clubs.
The Gribovsky G-22 was a low powered, single seat sports cantilever monoplane, designed and built in the USSR in the mid-1930s. It set at least one class record and flew from 1936 to at least 1940, though only one was completed.
The Gribovsky G-28 was an advanced trainer for trainee fighter pilots, built in the USSR just before the German invasion in 1941. It satisfied VVS testing but changing priorities led to the abandonment of production plans.
The Caproni Ca.95 was a large, three engine, long range, heavy bomber prototype built in Italy in 1929. It could carry a 1,600 kg (3,500 lb) bomb load and had three defensive gun positions. Only one was built.
The Raab-Katzenstein RK.25 was a two-seat, low wing cantilever monoplane aircraft designed and built in Germany in the 1920s for fast touring. Three were built and one had some success in a 1928 international contest. Another was later re-engined and provided with cabin accommodation.
The Nowotny N-y 4bis was a tandem two-seat light aircraft, built in Poland, as a step towards a very light, low-powered training aircraft for flying clubs. Its designer was killed in a glider soon after the first flight of his trainer and its development was abandoned.
