Holden EK

Last updated

Holden EK
1961-62 EK Special Sedan==.JPG
Holden Special Sedan
Overview
Manufacturer Holden (General Motors)
Also calledHolden Standard
Holden Special
Holden Utility
Holden Panel Van
ProductionMay 1961 – July 1962
Designer Alf Payze
Body and chassis
Class Mid-size
Body style 4-door sedan
5-door station wagon
2-door coupé utility
2-door panel van
Layout FR layout
Powertrain
Engine 2.3L GMH '138' I6
Transmission 3-speed manual
3-speed automatic
Dimensions
Wheelbase 105.0 inches (2667 mm)
Length181.8 inches (4617 mm)
Width67.0 inches (1703 mm)
Height59.9 inches (1521 mm)
Curb weight Standard Sedan: 2471 lb (1121 kg)
Chronology
Predecessor Holden FB
Successor Holden EJ

The Holden EK series is a motor vehicle produced by Holden in Australia from 1961 to 1962. [1] Introduced on 2 May 1961, the EK series was a facelifted version of the Holden FB, which it replaced. [1]

Contents

Model range

The EK range consisted of four-door sedans in two trim levels, five-door station wagons in two trim levels, [2] a two-door coupe utility and a two-door panel van. [3] The six models were marketed as follows:

Changes

The EK, the first new Holden released in the 1960s, was a minor facelift of the superseded FB series, with obvious changes limited to a new grille of eight vertical bars (instead of six), and body side mouldings. [1] In terms of finish, "Standard" vehicles were painted in a single colour with no additional trimming or fittings, while "Special", the most popular model, came with stainless steel trims along the side and a white roof, as well as chrome Special badges, and two-tone vinyl interiors. Parking lights were incorporated into the top grille bar, and other changes included new exterior badges, a revised interior trim, electric wipers (replacing the old vacuum-type ones), and a new fresh-air unit [4] with a new ventilation air intake located forward of the windscreen.

The only significant mechanical change from the FB was the introduction of the first automatic transmission to be offered on a Holden. [4] Marketed as the Hydra-Matic, it was a well-regarded three-speed unit which was fully imported from the United States. [4] It was offered as an option on only the Holden Special models. [4] Other options included more than 30 approved NASCO Accessories, such as a bonnet lock, a locking tank cap, a car heater, external rear-view mirrors, or a sunshade. [5]

Visually, the two commercial vehicles, the Utility and Panel Van, remained almost identical to the previous model, the FB. In fact, the FB rear quarter panels and tail lights were carried over to the EK commercials. However, the carrying capacity was increased from 8 to 10 long hundredweight (410 to 510 kg) by fitting upgraded springs. [1]

Engines

Like the FB series, all EK models were powered by a 138 cubic inches (2,260 cc) inline six-cylinder engine, commonly referred to (due to its paint colour) as a "grey motor" having been bored out .061 inches (1.5 mm) over the 3-inch (76 mm) bore of earlier models, producing 75 bhp (56 kW). [6]

Production and replacement

Like the FB series, the EK was sold in several overseas markets in both left- and right-hand-drive configurations. Primary markets included New Zealand, South-East Asia, and the Pacific Islands. The EK was also sold in South Africa, where it was marketed as the car "built for a country like ours." Due to its rugged nature, it was very popular with farmers in South Africa. [7]

In 1961, 112,680 units were sold to the public (compared to 140,336 units in 1960) and Holden employed over 18,500 people. [8] However, sales the following year slowed as the effects of the Recession of 1960–61 began to be felt in the Australian economy, coupled with a new 40 per cent sales tax on motor cars. [9] Further, competitors XK Ford Falcon and R Series Chrysler Valiant "compact sixes", which had a squarer less cumbersome look, further ate into Holden's market dominance. [10] After a production run of 150,214 vehicles, [1] the EK was replaced by the Holden EJ series in July 1962. [11]

Related Research Articles

<span class="mw-page-title-main">Holden Gemini</span> Motor vehicle

The Holden Gemini is a compact car that was produced by Holden and sold in Australasia from 1975 to 1987. It was based on the Japanese Isuzu Gemini, one of the many models based on the GM T-car platform.

<span class="mw-page-title-main">Holden EH</span> Automobile produced by General Motors-Holden in Australia from 1963 to 1965

The Holden EH is an automobile produced by General Motors-Holden in Australia from 1963 to 1965. The EH was released in August 1963 replacing the Holden EJ series, and was the first Holden to incorporate the new "Red" engine, with a seven main bearing crankshaft instead of the four main bearing crankshaft used in the "Grey" engine. At first, a larger capacity 149-cubic-inch (2,440 cc) engine was only sold attached to a three-speed manual gearbox or the "Hydramatic" four-stage automatic transmission with a column shift. The Controlled Coupling Hydramatic used in the EH was actually a four-stage, although it effectively worked as a three-speed unit, except at full throttle. The 179-cubic-inch (2,930 cc) engine was initially sold only with the "Hydramatic" transmission. The first EH with a 179-cubic-inch engine and a manual gear box was called the "EH-S4", and was fitted with an upgraded manual gearbox, having stronger gears than in the 149 gear box, and an upgraded clutch. The three-speed manual column shift gearboxes had no synchromesh on first gear, only on the second and third (top) gear. Mainstream release of the 179 engine mated to the 3 speed manual transmission option occurred on the 10th February 1964.

<span class="mw-page-title-main">Holden (automobile)</span> Motor vehicle

The Holden was a full-sized car produced by the company of the same name across 5 generations from 1948 until 1984. The Holden is also commonly referred to by their model designation and also the H Series. The Holden was introduced to be Australia's car, being the first full scale produced automobile exclusive to the country. Prior to which, General Motors Holden's Ltd. assembled imported CKD kits from overseas General Motors subsidiaries such as Chevrolet, Buick, Vauxhall and more. And the only other cars built in the country being Ford and Chrysler vehicle bodies fitted to imported chassis. The Holden was an instant success among Australians, being the first production car built solely for Australia's unique, rough roads.

<span class="mw-page-title-main">Holden Special</span> Motor vehicle

The Holden Special is a mid-size car that was manufactured by Holden for Australasia. Introduced as the top-level trim in the new Holden FJ range of 1953, the Special was complemented by the entry-level Holden Standard and the mid-range Holden Business. The Business was in fact already available, introduced in July 1953 in the 48 series first seen in 1948. Three months later, the FJ was introduced, therefore forming a three-model lineup based around one car. A "Standard"-type variant also existed in the 48 series, but had been marketed simply as the "Holden".

<span class="mw-page-title-main">Holden FJ</span> Motor vehicle

The Holden FJ series is a range of motor vehicles which was produced in Australia by Holden from 1953 until 1956. The FJ was the second model of an "all Australian car" manufactured by Holden and was based upon the established 48-215 series, commonly referred to as the "FX".

<span class="mw-page-title-main">Ford Falcon (XY)</span> Car produced by Ford Australia

The Ford Falcon (XY) is a full-size car produced by Ford Australia from 1970 to 1972. It was the fourth and last iteration of the second generation of the Falcon and included the Ford Fairmont (XY)—the luxury-oriented version.

<span class="mw-page-title-main">Holden HQ</span> Motor vehicle

The Holden HQ series is a range of automobiles that was produced by Holden in Australia from 1971 to 1974. The HQ was released on 15 July 1971, replacing the Holden HG series. It was the first ground-up redesign of the Holden line since its original release in 1948, and included an all-new body, chassis, and suspension. The HQ was later developed into a series of successor models, finally ending production when the WB series was discontinued in 1985.

<span class="mw-page-title-main">Vauxhall Wyvern</span> Motor vehicle

The Vauxhall Wyvern is a medium-sized family car introduced by Vauxhall in 1948 as a successor to the Vauxhall 12. The name comes from the mythical beast the wyvern, and may be due to a misidentification of the heraldic griffin on the Vauxhall badge.

<span class="mw-page-title-main">Holden FE</span> Motor vehicle

The Holden FE is an automobile produced by Holden in Australia from 1956 until 1958. It was also the first Holden to be assembled in New Zealand, where General Motors New Zealand built their first example on 31 January 1957.

<span class="mw-page-title-main">Holden HK</span> Motor vehicle

The Holden HK series is an automobile which was produced by Holden in Australia from 1968 to 1969. Introduced in January 1968, the HK range progressively replaced the Holden HR series which had been in production since 1966. HK models were both larger and heavier than their predecessors and the range would ultimately include thirteen different models against the eight of the HR range. The Holden HK was marketed under Belmont, Kingswood, Premier, Brougham and Monaro model names.

<span class="mw-page-title-main">Holden HJ</span> Motor vehicle

The Holden HJ is a series of automobiles which were produced by Holden in Australia from 1974 to 1976. The HJ series was released on 4 October 1974 and was an improved and facelifted version of the superseded Holden HQ series which had been in production since 1971.

<span class="mw-page-title-main">Holden EJ</span> Motor vehicle

The Holden EJ is a motor vehicle produced by General Motors-Holden's in Australia from 1962 to 1963. Introduced in July 1962, the EJ replaced the Holden EK series.

<span class="mw-page-title-main">Holden FC</span> Motor vehicle

The Holden FC series is an automobile produced by Holden in Australia from 1958 to 1960. Introduced on 6 May 1958, the FC is a facelifted and improved version of the Holden FE series, which it replaced. Although it is exclusively an Australian design, the styling is reminiscent of a scaled-down North American 1955 Chevrolet.

<span class="mw-page-title-main">Holden HX</span> Motor vehicle

The Holden HX is a range of automobiles which was produced by Holden in Australia from 1976 to 1977.

<span class="mw-page-title-main">Holden HZ</span> Motor vehicle

Holden HZ is a full-sized automobile which was produced in Australia between October 1977 and April 1980 by Holden in a variety of equipment levels and in several different body styles. It was also assembled in New Zealand.

<span class="mw-page-title-main">Holden FB</span> Motor vehicle

The Holden FB is an automobile produced by Holden in Australia from 1960 to 1961. Introduced on 14 January 1960, the FB series replaced the Holden FC range.

<span class="mw-page-title-main">Holden HT</span> Motor vehicle

The Holden HT series is a range of automobiles which was produced by Holden in Australia between 1969 and 1970.

<span class="mw-page-title-main">Holden HG</span> Motor vehicle

The Holden HG is an automobile which was produced by Holden in Australia between 1970 and 1971. It was marketed under Belmont, Kingswood, Premier, Brougham and Monaro model names.

<span class="mw-page-title-main">Holden HD</span> Motor vehicle

The Holden HD series is a range of automobiles which were produced by Holden in Australia from 1965 to 1966.

<span class="mw-page-title-main">Holden HR</span> Motor vehicle

The Holden HR is an automobile that was produced by Holden in Australia from 1966 to 1968.

References

  1. 1 2 3 4 5 Norm Darwin, 100 Years of GM in Australia, 2002, pages 232-233
  2. 1 2 3 4 5 "Holden, Australia’s Own Car" (GMH sales brochure for Holden EK Sedans and Station Sedans)
  3. 1 2 3 "Holden, Australia’s Own Utility, Australia’s Own Panel Van" (GMH sales brochure for Holden EK Utility and Panel Van)
  4. 1 2 3 4 Tony Davis, Aussie Cars, 1987, page 81
  5. "EK Holden NASCO Accessories". www.uniquecarsandparts.com.au. Retrieved 16 August 2009.
  6. Holden EK Technical Specifications Retrieved from www.uniquecarsandparts.com.au on 13 February 2010
  7. Wright, Cedric, ed. (August 1968). "A car owners' report: Holden (1960-66)". CAR (South Africa). Vol. 12, no. 7. Cape Town, South Africa: Central News Agency Ltd. p. 28.
  8. Holden EK http://www.uniquecarsandparts.com.au/car_info_holden_ek.htm Retrieved 2009-08-16
  9. https://web.archive.org/web/20070926214934/http://media.gmcanada.com:8221/aus/holden/en/company/history/HH13Part1.pdf Page 49 Retrieved 2016-12-17
  10. "Holden EK". www.uniquecarsandparts.com.au. Retrieved 16 August 2009.
  11. Norm Darwin, 100 Years of GM in Australia, 2002, pages 234-235

Further reading