The Nernst lamp was an early form of incandescent lamp.
The Nernst lamp was an early form of incandescent lamp.
Nernst lamps did not use a glowing tungsten filament. Instead, they used a ceramic rod that was heated to incandescence. Because the rod (unlike tungsten wire) would not further oxidize when exposed to air, there was no need to enclose it within a vacuum or noble gas environment; the burners in Nernst lamps could operate exposed to the air and were only enclosed in glass to isolate the hot incandescent emitter from its environment. A ceramic of zirconium oxide – yttrium oxide was used as the glowing rod. [1]
Developed by the German physicist and chemist Walther Nernst in 1897 at the University of Göttingen, these lamps were about twice as efficient as carbon-filament lamps and emitted a more "natural" light (more similar in spectrum to daylight). The lamps were quite successfully marketed for a time, although they eventually lost out to the more efficient tungsten-filament incandescent light bulb. One disadvantage of the Nernst design was that the ceramic rod was not electrically conductive at room temperature, so the lamps needed a separate heater filament to heat the ceramic sufficiently to begin conducting electricity.
In the U.S., Nernst sold the patent to George Westinghouse, who founded the Nernst Lamp Company at Pittsburgh in 1901. Minerals for the production of the glowers were extracted from the company's own mines at the legendary Barringer Hill, Texas (since 1937 submerged beneath the waters of Lake Buchanan). By 1904 a total of over 130,000 Nernst lamps had been placed in service throughout the country.
In Europe, the lamps were produced by the German Allgemeine Elektrizitäts-Gesellschaft (AEG, General Electricity Company) at Berlin. At the 1900 World's Fair held in Paris, the pavilion of the AEG was illuminated by 800 Nernst lamps, which was said to be quite spectacular at the time.
In addition to their usage for ordinary electric illumination, Nernst lamps were used in one of the first practical long-distance photoelectric facsimile (fax) systems, designed by professor Arthur Korn in 1902, and in Allvar Gullstrand's original slit lamp (1911) which is used for ophthalmology to allow physicians to view the inside of a patient's eye and contributed to Gullstrand's Nobel Prize award. [2]
Even after Nernst lamps became obsolete as visible lamps, "Nernst glowers" continue to be used as the infrared-emitting source used in IR spectroscopy devices. Their emission of infrared makes them inefficient as visible light sources, but perfect for IR spectroscopy applications. [3] Silicon carbide Globars now compete for this purpose as they are conductive even at room temperature and therefore need no preheating.[ citation needed ]
An electric light, lamp, or light bulb is an electrical component that produces light. It is the most common form of artificial lighting. Lamps usually have a base made of ceramic, metal, glass, or plastic which secures the lamp in the socket of a light fixture, which is often called a "lamp" as well. The electrical connection to the socket may be made with a screw-thread base, two metal pins, two metal caps or a bayonet mount.
An incandescent light bulb, incandescent lamp or incandescent light globe is an electric light with a filament that is heated until it glows. The filament is enclosed in a glass bulb that is either evacuated or filled with inert gas to protect the filament from oxidation. Electric current is supplied to the filament by terminals or wires embedded in the glass. A bulb socket provides mechanical support and electrical connections.
A halogen lamp is an incandescent lamp consisting of a tungsten filament sealed in a compact transparent envelope that is filled with a mixture of an inert gas and a small amount of a halogen, such as iodine or bromine. The combination of the halogen gas and the tungsten filament produces a halogen-cycle chemical reaction, which redeposits evaporated tungsten on the filament, increasing its life and maintaining the clarity of the envelope. This allows the filament to operate at a higher temperature than a standard incandescent lamp of similar power and operating life; this also produces light with higher luminous efficacy and color temperature. The small size of halogen lamps permits their use in compact optical systems for projectors and illumination. The small glass envelope may be enclosed in a much larger outer glass bulb, which has a lower temperature, protects the inner bulb from contamination, and makes the bulb mechanically more similar to a conventional lamp.
Artificial lighting technology began to be developed tens of thousands of years ago and continues to be refined in the present day.
A photoresistor is a passive component that decreases in resistance as a result of increasing luminosity (light) on its sensitive surface, in other words, it exhibits photoconductivity. A photoresistor can be used in light-sensitive detector circuits and light-activated and dark-activated switching circuits acting as a semiconductor resistance. In the dark, a photoresistor can have a resistance as high as several megaohms (MΩ), while in the light, it can have a resistance as low as a few hundred ohms. If incident light on a photoresistor exceeds a certain frequency, photons absorbed by the semiconductor give bound electrons enough energy to jump into the conduction band. The resulting free electrons conduct electricity, thereby lowering resistance. The resistance range and sensitivity of a photoresistor can substantially differ among dissimilar devices. Moreover, unique photoresistors may react substantially differently to photons within certain wavelength bands.
Silicon carbide (SiC), also known as carborundum, is a hard chemical compound containing silicon and carbon. A wide bandgap semiconductor, it occurs in nature as the extremely rare mineral moissanite, but has been mass-produced as a powder and crystal since 1893 for use as an abrasive. Grains of silicon carbide can be bonded together by sintering to form very hard ceramics that are widely used in applications requiring high endurance, such as car brakes, car clutches and ceramic plates in bulletproof vests. Large single crystals of silicon carbide can be grown by the Lely method and they can be cut into gems known as synthetic moissanite.
A flashlight or electric torch, usually shortened to torch, is a portable hand-held electric lamp. Formerly, the light source typically was a miniature incandescent light bulb, but these have been displaced by light-emitting diodes (LEDs) since the early 2000s. A typical flashlight consists of the light source mounted in a reflector, a transparent cover to protect the light source and reflector, a battery, and a switch, all enclosed in a case.
An incandescent gas mantle, gas mantle or Welsbach mantle is a device for generating incandescent bright white light when heated by a flame. The name refers to its original heat source in gas lights which illuminated the streets of Europe and North America in the late 19th century. Mantle refers to the way it hangs like a cloak above the flame. Gas mantles were also used in portable camping lanterns, pressure lanterns and some oil lamps.
Tungsram was a manufacturing company located in Hungary and known for their light bulbs and electronics. Established in Újpest in 1896, it initially produced telephones, wires and switchboards. The name "Tungsram" is a portmanteau of tungsten and wolfram, the two common names of the metal used for making light bulb filaments. Before becoming nationalized by the Communist government in 1945, the company was the world's third largest manufacturer of light bulbs and radiotubes, after the American General Electric and RCA companies.
In vacuum tubes and gas-filled tubes, a hot cathode or thermionic cathode is a cathode electrode which is heated to make it emit electrons due to thermionic emission. This is in contrast to a cold cathode, which does not have a heating element. The heating element is usually an electrical filament heated by a separate electric current passing through it. Hot cathodes typically achieve much higher power density than cold cathodes, emitting significantly more electrons from the same surface area. Cold cathodes rely on field electron emission or secondary electron emission from positive ion bombardment, and do not require heating. There are two types of hot cathode. In a directly heated cathode, the filament is the cathode and emits the electrons. In an indirectly heated cathode, the filament or heater heats a separate metal cathode electrode which emits the electrons.
A Globar is used as a thermal light source for infrared spectroscopy. The preferred material for making Globar is silicon carbide that is shaped as rods or arches of various sizes. When inserted into a circuit that provides it with electric current, it emits radiation from ~ 2 to 50 micrometres wavelength via the Joule heating phenomenon. Globars are used as infrared sources for spectroscopy because their spectral behavior corresponds approximately to that of a Planck radiator. Alternative infrared sources are Nernst lamps, coils of chrome–nickel alloy or high-pressure mercury lamps.
Solid-state lighting (SSL) is a type of lighting that uses semiconductor light-emitting diodes (LEDs), organic light-emitting diodes (OLED), or polymer light-emitting diodes (PLED) as sources of illumination rather than electrical filaments, plasma, or gas.
Stage lighting instruments are used in stage lighting to illuminate theatrical productions, concerts, and other performances taking place in live performance venues. They are also used to light television studios and sound stages.
A deuterium arc lamp is a low-pressure gas-discharge light source often used in spectroscopy when a continuous spectrum in the ultraviolet region is needed.
Tungsten nitride (W2N, WN, WN2) is an inorganic compound, a nitride of tungsten. It is a hard, solid, brown-colored ceramic material that is electrically conductive and decomposes in water.
An infrared heater or heat lamp is a heating appliance containing a high-temperature emitter that transfers energy to a cooler object through electromagnetic radiation. Depending on the temperature of the emitter, the wavelength of the peak of the infrared radiation ranges from 750 nm to 1 mm. No contact or medium between the emitter and cool object is needed for the energy transfer. Infrared heaters can be operated in vacuum or atmosphere.
Infrared lamps are electrical devices which emit infrared radiation. Infrared lamps are commonly used in radiant heating for industrial processes and building heating. Infrared LEDs are used for communication over optical fibers and in remote control devices. Infrared lamps are also used for some night vision devices where visible light would be objectionable. Infrared lamp sources are used in certain scientific and industrial instrument for chemical analysis of liquids and gases; for example, the pollutant sulfur dioxide in air can be measured using its infrared absorption characteristics. IR radiant energy emitted by lamps cover a wide spectrum of wavelengths, ranging from 0.7 μm (micrometers) to a longer wavelength of 400 μm.
The NIRSpec is one of the four scientific instruments flown on the James Webb Space Telescope (JWST). The JWST is the follow-on mission to the Hubble Space Telescope (HST) and is developed to receive more information about the origins of the universe by observing infrared light from the first stars and galaxies. In comparison to HST, its instruments will allow looking further back in time and will study the so-called Dark Ages during which the universe was opaque, about 150 to 800 million years after the Big Bang.
Edison light bulbs, also known as filament light bulbs and retroactively referred to as antique light bulbs or vintage light bulbs, are either carbon- or early tungsten-filament incandescent light bulbs, or modern bulbs that reproduce their appearance. Most of the bulbs in circulation are reproductions of the wound filament bulbs made popular by Edison Electric Light Company at the turn of the 20th century. They are easily identified by the long and complicated windings of their internal filaments, and by the very warm-yellow glow of the light they produce.
