Caudron Type B Multiplace

Last updated
Type B Multiplace
RoleMulti-seat biplane
National origin France
Manufacturer Caudron
First flight9 or 10 June 1912
Number built1

The Caudron Type B Multiplace was a large French biplane designed to carry up to five passengers in a cross-country time trial of 1912. It was destroyed early in the event.

Contents

Design and development

After the publication in April 1912 of the rules for the Circuit of Anjou time trial, to be held as part of the Grand Prix d'Aviation de l'Aéro-club de France contest in mid-June that year, the Caudron brothers began the design of a competitor that could carry four or five passengers. The emphasis on passenger carrying capacity was determined by the rules: for each passenger weighing over 75 kg (165 lb), the flight time for the required seven circuits of the 163 km (101 mi) course would be reduced by 16. With five passengers, competition times would be more than halved to 40% of the flight times. More weight required more power and the rules limited the engine displacement to 12 L (730 cu in). Early Caudron aircraft, like the Type A had used Anzani engines, and a new 10.69 L (652 cu in), 75 kW (100 hp) 14-cylinder Anzani radial engine, essentially two Anzani seven-cylinder engines slightly displaced on a common crankshaft, was chosen. [1] [2]

The passenger load required the Multiplace to have a larger wing area than any of their earlier aircraft, though the wing maintained the general features established previously. Both the upper and lower wings had the same plan, rectangular apart from their tips, though the upper span was 27% greater than the lower. They were fabric covered and built around twin spars, both of which were ahead of mid-chord, leaving most of the length of each rib unsupported and free to warp for roll control. Because of the large span they were three bay wings, the bays separated by three pairs of parallel, vertical interplane struts; there was no stagger. On each wing another pair of parallel masts leaned outwards from the bases of the outer interplane struts to support the overhang of the upper wing and at the wing roots two more pairs of vertical interplane struts supported both the wing centre section and, just above the lower wing, the fuselage, an arrangement also used to support the short nacelle of the Type B. [1]

Instead of the nacelle and the twin booms that supported the empennage on the Type B, the Multiplace had a rectangular section, full length fuselage with the engine in the nose, built around four longerons and fabric covered. There was a long, open cockpit for passengers and pilot, the latter sitting at the back under a little cut-out in the wing trailing edge for better upward vision. The single, roughly rectangular rudder was entirely above the fuselage and was cut away on its underside to allow the deflection of the horizontal tail's trailing edge. The tailplane was mounted on top of the fuselage. The Multiplace had two pairs of mainwheels; each pair was mounted on a long skid with an upturned nose which extended beyond the wing both forward and aft. These held the aircraft close to a take-off attitude on the ground and in this way replaced the lower members of the tailbooms used on other Caudron types of the time. The rear fuselage was protected though by a very tall tailskid. The under-wing skids were placed on longitudinally splayed extensions of the inner interplane struts and transversely braced by pairs of lighter struts to the bases of the centre section struts. [1]

The Multiplace was completed only a few days before the competition began, leaving little time for testing. It flew to Anjou with four passengers. Bad weather on the first day made the intended programme impossible but the next day (17 June) was somewhat better, and the organisers improvised a one-day event. René Caudron decided to take part, though only carrying three passengers in the Multiplace to reduce risks. Flown by Allard and with the engine running roughly, the aircraft climbed to perhaps 12 m (39 ft) before, as an onlooker described, "rearing up" (se cobra), turning rapidly, catching a wingtip on the ground and nosediving in. Three of the occupants escaped without major injury but one, a Caudron mechanic, broke a leg. The Multiplace was not rebuilt and Caudron did not use the fourteen cylinder Anzani engine again, though they frequently used other models. [1] [3]

Specifications

Data from Hauet (2001) pp.24-5 [1]

General characteristics

Related Research Articles

<span class="mw-page-title-main">Caudron C.27</span> French biplane

The Caudron C.27 was a French biplane, a two-seat basic trainer which also competed successfully in the 1920s.

The Caudron C.91 was a French single engine biplane with an enclosed passenger cabin seating four. It first flew in 1923.

<span class="mw-page-title-main">Caudron C.74</span> Type of aircraft

The Caudron C.74 was a ten-seat, four engine passenger biplane built in France in 1922. It showed promise but the sole prototype crashed fatally in a competition and no more were completed.

<span class="mw-page-title-main">Caudron C.68</span> Type of aircraft

The Caudron C.68 was a two-seat French training and touring aircraft, built in the early 1920s, which attracted interest at the time because of its simple and fast wing folding arrangement. Only a few were produced.

<span class="mw-page-title-main">Caudron C.67</span> French single-seat airplane

The Caudron C.67 was a simple single seat biplane with a low powered engine. It was built and flown in France in 1922.

<span class="mw-page-title-main">Caudron C.43</span> Type of aircraft

The Caudron C.43 was the first French five-engined aircraft, a biplane intended for passenger transport or military use and multi-engined for safety. A development of the three-engined Caudron C.39, it had one tractor configuration engine in the nose and two push-pull pairs between the wings. It was capable of carrying eight passengers but was not developed.

<span class="mw-page-title-main">Caudron C.39</span> Type of aircraft

The Caudron C.39 was a French three-engined biplane with a cabin for six passengers when the aircraft was equipped as a landplane or four passengers when on floats. It was flown with some success in competitions in 1920 and 1921.

The Caudron C.37 was a French three-engined biplane passenger transport, built in 1920. It could carry six passengers.

<span class="mw-page-title-main">Caudron C.25</span> Type of aircraft

The Caudron C.25 was a large, three-engined, biplane airliner, designed and built in France soon after the end of World War I. Its enclosed cabin could accommodate up to eighteen passengers.

<span class="mw-page-title-main">Caudron Type O</span> Type of aircraft

The Caudron Type O was a French single seat air racing biplane first flown in 1914.

<span class="mw-page-title-main">Caudron Types M and N</span> Type of aircraft

The Caudron Types M and N were small, fast French sports monoplanes, flown 1911–13 under a wide range of engine powers. There was also a military version.

<span class="mw-page-title-main">Hydroaéroplane Caudron-Fabre</span> Type of aircraft

The Hydroaéroplane Caudron-Fabre, (Caudron-Fabre), was a French amphibious seaplane that competed in the 1912 Monaco event. It was one of the first true amphibians, able to take-off from water and touch down on land.

The Caudron Type H was a collective name for three different Caudron designs of 1912-3. One of these was an amphibious three seat biplane built for the French military. Two were completed, one appearing at the Paris Aero Salon in November 1912.

<span class="mw-page-title-main">Caudron Type L</span> Type of aircraft

The Caudron Type L was a two-seat French pusher configuration amphibious biplane, flown around 1913 and intended for naval use.

The Caudron Type B was a 1911 development of the earliest Caudron type, the Caudron Type A, with a nacelle style fuselage and more powerful engine. Initially an equal span biplane, it was modified into a sesquiplane.

The Caudron Type K was a French floatplane with a very powerful, twenty cylinder radial engine in pusher configuration. It took part in a French seaplane competition in 1913, but was lost in a take-off accident during the competition.

The Caudron Type C was a single seat French biplane, intended for military evaluation. Two were built in 1911.

<span class="mw-page-title-main">Caudron Type F</span> Type of aircraft

The Caudron Type F was a French single seat biplane produced just before World War I. A dozen were bought by China and at least two other examples, with different engines, competed in 1913, coming first and second in the biplane category of the cross-country race at Reims. Flown by Pierre Chanteloup, one was the first biplane to loop-the-loop.

<span class="mw-page-title-main">Caudron Type D</span> Type of aircraft

The Caudron Type D was a French pre-World War I single seat, twin-boom tractor biplane, a close but slightly smaller relative of the two seat Caudron Type C. More than a dozen were completed, one exported to the United Kingdom, where they may also have been licence built, and three to China.

The Caudron Type E two seat trainer was a larger and more powerful development of the Type C. Two or three were bought by the French military and one by the Royal Navy just before World War I but its sales were overtaken by the superior Type G.

References

  1. 1 2 3 4 5 Hauet, André (2001). Les Avions Caudrons. Vol. 1. Outreau: Lela Presse. ISBN   2 914017-08-1.
  2. "Grand Prix d'Aviation de l'Aéro-club de France". L'Aérophile. Vol. 20, no. 7. 1 April 1912. p. 160.
  3. "Prix d'Anjou (Epreuve Special)". L'Aérophile. Vol. 20, no. 13. 1 July 1912. p. 294.