| Caudron C.25 | |
|---|---|
 | |
| Role | 16–18-passenger airliner |
| National origin | France |
| Manufacturer | Caudron |
| Designer | Paul Deville |
The Caudron C.25 was a large, three-engined, biplane airliner, designed and built in France soon after the end of World War I. Its enclosed cabin could accommodate up to eighteen passengers.
After the end of world War I, some Caudron C.23s, a large trimotor night bomber, were modified to act as passenger aircraft, but the C.25 was the first aircraft Caudron had designed from the beginning to carry passengers. It was large, with a 25 m (82 ft 0 in) span, [1] so Caudron built in hinges to allow the wings to be folded for easier handling on the ground. The wings were rectangular in plan, mounted without stagger and fabric covered. It was a three-bay biplane with unusually thin, wooden, parallel, vertical interplane struts, assisted by flying wires of thicker than usual gauge. The engine mountings, two pairs of parallel struts, defined the inner bay. The outer pair of these struts were doubled since this was where the wing folded, and so the ends of the wing either side of the fold retained their struts. Four vertical cabane struts braced the centre of the upper wing from the upper fuselage. [2] There were ailerons on both lower and lower planes, extending over more than half the span. These were not aerodynamically balanced in the usual way but were connected to each other by three vertical rods which halfway up were hinged to the trailing edge of a narrower and shorter horizontal surface which rotated about an axis well behind its aerodynamic centre. The wires from the cockpit operated these ancillary surfaces, which then moved the ailerons, just as the leading edge of a conventional balanced aileron, extending forward of the hinge, assists the pilot's input. [1] [2]
The Caudron C.23 was powered by three 186 kW (250 hp) Salmson 9Z nine cylinder water-cooled radial engines, each neatly cowled. Two were mounted halfway between the wings in flat-sided nacelles which curved to a point at the rear and the third was nose-mounted. The wing-mounted engines had fuel tanks in the nacelles, and the nose engine was served by a tank behind it. Behind it the fuselage was rectangular in section and plywood covered to the rear of the passenger cabin, after which it was fabric covered. The two crew sat in separate, wide, side-by-side open cockpits in the upper part of the fuselage ahead of the wing leading edge. The protrusion of their cockpits into the lower fuselage divided the passenger space into a main cabin behind and a smaller one forwards, accessed by ducking under the bottom of the cockpits. The interior had large windows and was carefully furnished, with wicker armchairs and tables, lighting and decorated walls; [2] a toilet was provided. [3]
The horizontal tail was a biplane unit with the lower tailplane attached to the bottom of the fuselage and the upper one on top of a small, shallow fin. The rectangular tailplanes were braced together by two interplane struts on each side; both were rectangular and carried elevators. Three rudders occupied the gap between the elevators, the tips cut away for elevator movement. Only the outer rudders were balanced, but these were directly connected to the central one, assisting it. The C.25 had fixed tailskid conventional landing gear with main wheels in pairs under each engine, assisted by another pair under the nose to prevent nose overs. [1] [2]
The C.25 was on display at the Paris Aero Show in 1919, though it may not have flown by then. [2] Little is recorded on its subsequent history.
Data from Hauet (2001) p.142 [1]
General characteristics
Performance
The Latécoère 4 was a three-engined, 15-passenger biplane built in France in the early 1920s. It proved difficult to fly and was discontinued, though a second machine was completed as the Latécoère 5 bomber.
The Potez XVIII was a French airliner from the early 1920s, a three-engine biplane carrying up to twelve passengers.
The Caudron C.27 was a French biplane, a two-seat basic trainer which also competed successfully in the 1920s.
The Caudron C.97 was a two-seat biplane trainer designed and built in France around 1924. A number were used by the Bolivian Air Force.
The Caudron C.91 was a French single engine biplane with an enclosed passenger cabin seating four. It first flew in 1923.
The Caudron C.74 was a ten-seat, four engine passenger biplane built in France in 1922. It showed promise but the sole prototype crashed fatally in a competition and no more were completed.
The Caudron C.68 was a two-seat French training and touring aircraft, built in the early 1920s, which attracted interest at the time because of its simple and fast wing folding arrangement. Only a few were produced.
The Caudron C.67 was a simple single seat biplane with a low powered engine. It was built and flown in France in 1922.
The Caudron C.43 was the first French five-engined aircraft, a biplane intended for passenger transport or military use and multi-engined for safety. A development of the three-engined Caudron C.39, it had one tractor configuration engine in the nose and two push-pull pairs between the wings. It was capable of carrying eight passengers but was not developed.
The Caudron C.39 was a French three-engined biplane with a cabin for six passengers when the aircraft was equipped as a landplane or four passengers when on floats. It was flown with some success in competitions in 1920 and 1921.
The Caudron C.37 was a French three-engined biplane passenger transport, built in 1920. It could carry six passengers.
The Caudron C.33 "Landaulet Monsieur-Madame" was a French twin engined biplane with four seats, two in open cockpits and two in an enclosed cabin.
The Caudron C.23 was a French long range twin engine night bomber, flown in the last year of World War I. Post-war some machines were modified to carry passengers.
The Caudron C.22 was a French twin engine night bomber built in 1917. It did not reach production.
The Caudron C.21 was a French twin engine biplane built just after World War I, able to carry three passengers in an open cockpit.
The Caudron Type H was a collective name for three different Caudron designs of 1912-3. One of these was an amphibious three seat biplane built for the French military. Two were completed, one appearing at the Paris Aero Salon in November 1912.
The Caudron Type L was a two-seat French pusher configuration amphibious biplane, flown around 1913 and intended for naval use.
The Caudron Type B was a 1911 development of the earliest Caudron type, the Caudron Type A, with a nacelle style fuselage and more powerful engine. Initially an equal span biplane, it was modified into a sesquiplane.
The Caudron Type B Multiplace was a large French biplane designed to carry up to five passengers in a cross-country time trial of 1912. It was destroyed early in the event.
The Caudron C.92 was a passenger transport built by Caudron in 1925, powered by a 370 hp (280 kW) Lorraine-Dietrich 12D. Only one was built, and it was discarded in July 1934.