| Caudron C.68 | |
|---|---|
 | |
| Role | Touring and sport aircraft |
| National origin | France |
| Manufacturer | Caudron |
| Designer | Paul Deville |
| First flight | 1922 |
| Number built | 6 |
| Developed from | Caudron C.67 |
The Caudron C.68 was a two-seat French training and touring aircraft, built in the early 1920s, which attracted interest at the time because of its simple and fast wing folding arrangement. Only a few were produced.
Apart from its folding wings, the C.68 was a conventional single bay biplane with rectangular plan wings of similar span, mounted without stagger. Ailerons were fitted only on the upper wings. The outer interplane struts were in parallel pairs and the upper wing was supported over the fuselage on four upright cabane struts. The forward pair of these were unusual in extending down to the lower fuselage longerons and in being split vertically; the inner halves linked the centre section and fuselage and the outer halves were extra interplane struts. To fold the wings a short section of the centre section trailing edge was folded back to make room for the part of the upper wing aft of its hinge and the lower, outer, normally concealed part of the cabane/interplane strut swung out of its slot in the fuselage. The rear part of the lower wing cleared the fuselage underside. The aileron cables ran within the wing and did not need to be disconnected for folding thanks to wires that prevented them slackening. [1] [2]
The C.68 was powered by a 37 kW (50 hp) Anzani 6-cylinder two row radial engine, mounted without a cowling and driving a two blade propeller. Behind the engine the fuselage was flat sided, though the underside had a curved profile and there was curved upper decking. It had two open cockpits, one under the wing and the second just aft of the trailing edge. The C.68's fin was triangular and broad, carrying a vertical edged unbalanced rudder which extended down to the keel. Its tailplane was mounted on top of the fuselage with its elevators notched to allow rudder movement. It had a tailskid undercarriage with its mainwheels on a single 1.40 m (4 ft 7 in) long axle sprung on two V-form struts from the lower fuselage longerons. [1]
Folding and deploying the wings was straightforward and rapid, taking less than four minutes. Folding began by pinning on a tailskid extension to keep the lower wings off the ground. This extension could also link the folded C.68 behind a car for towing. The C.68's folded width was less than its 2.4 m (7 ft 10 in) height. [1] [2]
The C.68 was first flown in 1922 [1] and was on display at the 1922 Paris Salon, which opened on 15 December. [2] Another C.68 was flown to Paris by Becheler who landed it in front of the Grand Palais on 16 December 1922, then gave a demonstration of its folding wings. [1] [3]
Four C.68s appeared on the French Civil Register. [4] In total six C.68s were built, of which a single example survives ad is in airworthy condition. [5]
Data from Hauet (2001) pp.172-3 [1]
General characteristics
Performance
The Caudron C.251 Et-2 was a French tandem seat, open cockpit biplane designed as an intermediate trainer and built in 1931. It did not go into production.
The Caudron C.220 was a two-seat French biplane trainer. Only two were built, using different engines.
The Caudron C.140 was a French tandem cockpit sesquiplane designed in 1928 as a combination of liaison aircraft and observer and gunnery trainer.
The Caudron C.27 was a French biplane, a two-seat basic trainer which also competed successfully in the 1920s.
The Caudron C.91 was a French single engine biplane with an enclosed passenger cabin seating four. It first flew in 1923.
The Caudron C.74 was a ten-seat, four engine passenger biplane built in France in 1922. It showed promise but the sole prototype crashed fatally in a competition and no more were completed.
The Caudron C.67 was a simple single seat biplane with a low powered engine. It was built and flown in France in 1922.
The Caudron C.65 was a single seat biplane floatplane designed and built in France in 1922. Only one was completed.
The Caudron C.43 was the first French five-engined aircraft, a biplane intended for passenger transport or military use and multi-engined for safety. A development of the three-engined Caudron C.39, it had one tractor configuration engine in the nose and two push-pull pairs between the wings. It was capable of carrying eight passengers but was not developed.
The Caudron C.39 was a French three-engined biplane with a cabin for six passengers when the aircraft was equipped as a landplane or four passengers when on floats. It was flown with some success in competitions in 1920 and 1921.
The Caudron C.37 was a French three-engined biplane passenger transport, built in 1920. It could carry six passengers.
The Caudron C.33 "Landaulet Monsieur-Madame" was a French twin engined biplane with four seats, two in open cockpits and two in an enclosed cabin.
The Caudron C.25 was a large, three-engined, biplane airliner, designed and built in France soon after the end of World War I. Its enclosed cabin could accommodate up to eighteen passengers.
The Caudron C.21 was a French twin engine biplane built just after World War I, able to carry three passengers in an open cockpit.
The Caudron 02 was a French high altitude single seat fighter that was flown in November 1917.
The Caudron Type O was a French single seat air racing biplane first flown in 1914.
The Caudron Type B was a 1911 development of the earliest Caudron type, the Caudron Type A, with a nacelle style fuselage and more powerful engine. Initially an equal span biplane, it was modified into a sesquiplane.
The Caudron Type B Multiplace was a large French biplane designed to carry up to five passengers in a cross country time trial of 1912. It was destroyed early in the event.
The Caudron Type C was a single seat French biplane, intended for military evaluation. Two were built in 1911.
The Caudron Type D was a French pre-World War I single seat, twin-boom tractor biplane, a close but slightly smaller relative of the two seat Caudron Type C. More than a dozen were completed, one exported to the United Kingdom, where they may also have been licence built, and three to China.
 | Wikimedia Commons has media related to Caudron C.68 . |