Thermodynamics |
---|
In thermodynamics, the Onsager reciprocal relations express the equality of certain ratios between flows and forces in thermodynamic systems out of equilibrium, but where a notion of local equilibrium exists.
"Reciprocal relations" occur between different pairs of forces and flows in a variety of physical systems. For example, consider fluid systems described in terms of temperature, matter density, and pressure. In this class of systems, it is known that temperature differences lead to heat flows from the warmer to the colder parts of the system; similarly, pressure differences will lead to matter flow from high-pressure to low-pressure regions. What is remarkable is the observation that, when both pressure and temperature vary, temperature differences at constant pressure can cause matter flow (as in convection) and pressure differences at constant temperature can cause heat flow. Perhaps surprisingly, the heat flow per unit of pressure difference and the density (matter) flow per unit of temperature difference are equal. This equality was shown to be necessary by Lars Onsager using statistical mechanics as a consequence of the time reversibility of microscopic dynamics (microscopic reversibility). The theory developed by Onsager is much more general than this example and capable of treating more than two thermodynamic forces at once, with the limitation that "the principle of dynamical reversibility does not apply when (external) magnetic fields or Coriolis forces are present", in which case "the reciprocal relations break down". [1]
Though the fluid system is perhaps described most intuitively, the high precision of electrical measurements makes experimental realisations of Onsager's reciprocity easier in systems involving electrical phenomena. In fact, Onsager's 1931 paper [1] refers to thermoelectricity and transport phenomena in electrolytes as well known from the 19th century, including "quasi-thermodynamic" theories by Thomson and Helmholtz respectively. Onsager's reciprocity in the thermoelectric effect manifests itself in the equality of the Peltier (heat flow caused by a voltage difference) and Seebeck (electric current caused by a temperature difference) coefficients of a thermoelectric material. Similarly, the so-called "direct piezoelectric" (electric current produced by mechanical stress) and "reverse piezoelectric" (deformation produced by a voltage difference) coefficients are equal. For many kinetic systems, like the Boltzmann equation or chemical kinetics, the Onsager relations are closely connected to the principle of detailed balance [1] and follow from them in the linear approximation near equilibrium.
Experimental verifications of the Onsager reciprocal relations were collected and analyzed by D. G. Miller [2] for many classes of irreversible processes, namely for thermoelectricity, electrokinetics, transference in electrolytic solutions, diffusion, conduction of heat and electricity in anisotropic solids, thermomagnetism and galvanomagnetism. In this classical review, chemical reactions are considered as "cases with meager" and inconclusive evidence. Further theoretical analysis and experiments support the reciprocal relations for chemical kinetics with transport. [3] Kirchhoff's law of thermal radiation is another special case of the Onsager reciprocal relations applied to the wavelength-specific radiative emission and absorption by a material body in thermodynamic equilibrium.
For his discovery of these reciprocal relations, Lars Onsager was awarded the 1968 Nobel Prize in Chemistry. The presentation speech referred to the three laws of thermodynamics and then added "It can be said that Onsager's reciprocal relations represent a further law making a thermodynamic study of irreversible processes possible." [4] Some authors have even described Onsager's relations as the "Fourth law of thermodynamics". [5]
Potential/Flux | Heat | Electric | Diffusion | Deformation |
---|---|---|---|---|
Temperature | Thermal conduction | Seebeck effect | Soret effect (thermophoresis) | Thermoelasticity |
Voltage | Peltier effect | Ohm's law | Electromigration | Piezoelectricity |
Chemical potential | Dufour effect | Galvanic | Fick's law | Osmosis |
Stress | Thermoelasticity | Piezoelectricity | Osmosis | Hooke's law |
The basic thermodynamic potential is internal energy. In a simple fluid system, neglecting the effects of viscosity, the fundamental thermodynamic equation is written: where U is the internal energy, T is temperature, S is entropy, P is the hydrostatic pressure, V is the volume, is the chemical potential, and M mass. In terms of the internal energy density, u, entropy density s, and mass density , the fundamental equation at fixed volume is written:
For non-fluid or more complex systems there will be a different collection of variables describing the work term, but the principle is the same. The above equation may be solved for the entropy density:
The above expression of the first law in terms of entropy change defines the entropic conjugate variables of and , which are and and are intensive quantities analogous to potential energies; their gradients are called thermodynamic forces as they cause flows of the corresponding extensive variables as expressed in the following equations.
The conservation of mass is expressed locally by the fact that the flow of mass density satisfies the continuity equation: where is the mass flux vector. The formulation of energy conservation is generally not in the form of a continuity equation because it includes contributions both from the macroscopic mechanical energy of the fluid flow and of the microscopic internal energy. However, if we assume that the macroscopic velocity of the fluid is negligible, we obtain energy conservation in the following form: where is the internal energy density and is the internal energy flux.
Since we are interested in a general imperfect fluid, entropy is locally not conserved and its local evolution can be given in the form of entropy density as where is the rate of increase in entropy density due to the irreversible processes of equilibration occurring in the fluid and is the entropy flux.
In the absence of matter flows, Fourier's law is usually written: where is the thermal conductivity. However, this law is just a linear approximation, and holds only for the case where , with the thermal conductivity possibly being a function of the thermodynamic state variables, but not their gradients or time rate of change.[ dubious – discuss ] Assuming that this is the case, Fourier's law may just as well be written:
In the absence of heat flows, Fick's law of diffusion is usually written: where D is the coefficient of diffusion. Since this is also a linear approximation and since the chemical potential is monotonically increasing with density at a fixed temperature, Fick's law may just as well be written: where, again, is a function of thermodynamic state parameters, but not their gradients or time rate of change. For the general case in which there are both mass and energy fluxes, the phenomenological equations may be written as: or, more concisely,
where the entropic "thermodynamic forces" conjugate to the "displacements" and are and and is the Onsager matrix of transport coefficients.
From the fundamental equation, it follows that: and
Using the continuity equations, the rate of entropy production may now be written: and, incorporating the phenomenological equations:
It can be seen that, since the entropy production must be non-negative, the Onsager matrix of phenomenological coefficients is a positive semi-definite matrix.
Onsager's contribution was to demonstrate that not only is positive semi-definite, it is also symmetric, except in cases where time-reversal symmetry is broken. In other words, the cross-coefficients and are equal. The fact that they are at least proportional is suggested by simple dimensional analysis (i.e., both coefficients are measured in the same units of temperature times mass density).
The rate of entropy production for the above simple example uses only two entropic forces, and a 2×2 Onsager phenomenological matrix. The expression for the linear approximation to the fluxes and the rate of entropy production can very often be expressed in an analogous way for many more general and complicated systems.
Let denote fluctuations from equilibrium values in several thermodynamic quantities, and let be the entropy. Then, Boltzmann's entropy formula gives for the probability distribution function , where A is a constant, since the probability of a given set of fluctuations is proportional to the number of microstates with that fluctuation. Assuming the fluctuations are small, the probability distribution function can be expressed through the second differential of the entropy [6] where we are using Einstein summation convention and is a positive definite symmetric matrix.
Using the quasi-stationary equilibrium approximation, that is, assuming that the system is only slightly non-equilibrium, we have [6]
Suppose we define thermodynamic conjugate quantities as , which can also be expressed as linear functions (for small fluctuations):
Thus, we can write where are called kinetic coefficients
The principle of symmetry of kinetic coefficients or the Onsager's principle states that is a symmetric matrix, that is [6]
Define mean values and of fluctuating quantities and respectively such that they take given values at . Note that
Symmetry of fluctuations under time reversal implies that
or, with , we have
Differentiating with respect to and substituting, we get
Putting in the above equation,
It can be easily shown from the definition that , and hence, we have the required result.
The stress–energy tensor, sometimes called the stress–energy–momentum tensor or the energy–momentum tensor, is a tensor physical quantity that describes the density and flux of energy and momentum in spacetime, generalizing the stress tensor of Newtonian physics. It is an attribute of matter, radiation, and non-gravitational force fields. This density and flux of energy and momentum are the sources of the gravitational field in the Einstein field equations of general relativity, just as mass density is the source of such a field in Newtonian gravity.
In thermodynamics, the Helmholtz free energy is a thermodynamic potential that measures the useful work obtainable from a closed thermodynamic system at a constant temperature (isothermal). The change in the Helmholtz energy during a process is equal to the maximum amount of work that the system can perform in a thermodynamic process in which temperature is held constant. At constant temperature, the Helmholtz free energy is minimized at equilibrium.
Linear elasticity is a mathematical model as to how solid objects deform and become internally stressed by prescribed loading conditions. It is a simplification of the more general nonlinear theory of elasticity and a branch of continuum mechanics.
In the calculus of variations, a field of mathematical analysis, the functional derivative relates a change in a functional to a change in a function on which the functional depends.
In mathematics, the Hodge star operator or Hodge star is a linear map defined on the exterior algebra of a finite-dimensional oriented vector space endowed with a nondegenerate symmetric bilinear form. Applying the operator to an element of the algebra produces the Hodge dual of the element. This map was introduced by W. V. D. Hodge.
In physics, a partition function describes the statistical properties of a system in thermodynamic equilibrium. Partition functions are functions of the thermodynamic state variables, such as the temperature and volume. Most of the aggregate thermodynamic variables of the system, such as the total energy, free energy, entropy, and pressure, can be expressed in terms of the partition function or its derivatives. The partition function is dimensionless.
In fluid mechanics, or more generally continuum mechanics, incompressible flow refers to a flow in which the material density of each fluid parcel — an infinitesimal volume that moves with the flow velocity — is time-invariant. An equivalent statement that implies incompressible flow is that the divergence of the flow velocity is zero.
In special and general relativity, the four-current is the four-dimensional analogue of the current density, with units of charge per unit time per unit area. Also known as vector current, it is used in the geometric context of four-dimensional spacetime, rather than separating time from three-dimensional space. Mathematically it is a four-vector and is Lorentz covariant.
In differential geometry, the four-gradient is the four-vector analogue of the gradient from vector calculus.
In electromagnetism, the electromagnetic tensor or electromagnetic field tensor is a mathematical object that describes the electromagnetic field in spacetime. The field tensor was first used after the four-dimensional tensor formulation of special relativity was introduced by Hermann Minkowski. The tensor allows related physical laws to be written concisely, and allows for the quantization of the electromagnetic field by the Lagrangian formulation described below.
In quantum mechanics, the Hellmann–Feynman theorem relates the derivative of the total energy with respect to a parameter to the expectation value of the derivative of the Hamiltonian with respect to that same parameter. According to the theorem, once the spatial distribution of the electrons has been determined by solving the Schrödinger equation, all the forces in the system can be calculated using classical electrostatics.
A quasiprobability distribution is a mathematical object similar to a probability distribution but which relaxes some of Kolmogorov's axioms of probability theory. Quasiprobability distributions arise naturally in the study of quantum mechanics when treated in phase space formulation, commonly used in quantum optics, time-frequency analysis, and elsewhere.
In relativistic physics, the electromagnetic stress–energy tensor is the contribution to the stress–energy tensor due to the electromagnetic field. The stress–energy tensor describes the flow of energy and momentum in spacetime. The electromagnetic stress–energy tensor contains the negative of the classical Maxwell stress tensor that governs the electromagnetic interactions.
The covariant formulation of classical electromagnetism refers to ways of writing the laws of classical electromagnetism in a form that is manifestly invariant under Lorentz transformations, in the formalism of special relativity using rectilinear inertial coordinate systems. These expressions both make it simple to prove that the laws of classical electromagnetism take the same form in any inertial coordinate system, and also provide a way to translate the fields and forces from one frame to another. However, this is not as general as Maxwell's equations in curved spacetime or non-rectilinear coordinate systems.
In physics, Maxwell's equations in curved spacetime govern the dynamics of the electromagnetic field in curved spacetime or where one uses an arbitrary coordinate system. These equations can be viewed as a generalization of the vacuum Maxwell's equations which are normally formulated in the local coordinates of flat spacetime. But because general relativity dictates that the presence of electromagnetic fields induce curvature in spacetime, Maxwell's equations in flat spacetime should be viewed as a convenient approximation.
The Glauber–Sudarshan P representation is a suggested way of writing down the phase space distribution of a quantum system in the phase space formulation of quantum mechanics. The P representation is the quasiprobability distribution in which observables are expressed in normal order. In quantum optics, this representation, formally equivalent to several other representations, is sometimes preferred over such alternative representations to describe light in optical phase space, because typical optical observables, such as the particle number operator, are naturally expressed in normal order. It is named after George Sudarshan and Roy J. Glauber, who worked on the topic in 1963. Despite many useful applications in laser theory and coherence theory, the Sudarshan–Glauber P representation has the peculiarity that it is not always positive, and is not a bona-fide probability function.
In many-body theory, the term Green's function is sometimes used interchangeably with correlation function, but refers specifically to correlators of field operators or creation and annihilation operators.
There are various mathematical descriptions of the electromagnetic field that are used in the study of electromagnetism, one of the four fundamental interactions of nature. In this article, several approaches are discussed, although the equations are in terms of electric and magnetic fields, potentials, and charges with currents, generally speaking.
In continuum mechanics, a compatible deformation tensor field in a body is that unique tensor field that is obtained when the body is subjected to a continuous, single-valued, displacement field. Compatibility is the study of the conditions under which such a displacement field can be guaranteed. Compatibility conditions are particular cases of integrability conditions and were first derived for linear elasticity by Barré de Saint-Venant in 1864 and proved rigorously by Beltrami in 1886.
This is a glossary for the terminology often encountered in undergraduate quantum mechanics courses.