This article needs additional citations for verification .(December 2012) |
Glenbrook rail accident | |
---|---|
Details | |
Date | 2 December 1999 8:22 am |
Location | Glenbrook, New South Wales |
Country | Australia |
Line | Blue Mountains railway line |
Operator | Great Southern Rail, CityRail |
Incident type | Collision |
Cause | Signal failure and driver-signalman miscommunication |
Statistics | |
Trains | 2 |
Deaths | 7 |
Injured | 51 |
The Glenbrook rail accident occurred on 2 December 1999 at 8:22 am on a curve east of Glenbrook railway station on the CityRail network between Glenbrook and Lapstone, in the Blue Mountains of New South Wales, Australia. Seven passengers were killed and 51 passengers were taken to hospital with injuries [1] when a CityRail electric interurban train collided with the rear wagon of the long-haul Perth-to-Sydney Indian Pacific.
The Indian Pacific train was authorised to pass a red signal at Glenbrook and stopped at the next signal, also red. The driver alighted to use the lineside signal telephone to call the signaller for authority to pass the signal at danger; as a component of the phone was missing, he incorrectly believed it to be defective. A delay of approximately seven minutes resulted despite the locomotive having a radio (at that time it was not a procedure for the National Rail Corporation to use a radio to contact signal boxes).
The interurban train restarted with authority after stopping at the red signal at Glenbrook and collided shortly after with the rear of the Indian Pacific train waiting at the second failed signal. Several factors were involved, from equipment breakdown to poor phrasing of the safe working rules: the most important was that the interurban picked up too much speed and the driver was not able to see the rear of the Indian Pacific around a sharp curve in a deep cutting in time to avoid a collision. This is essentially equivalent to a blind corner.
The track was curved to the left, the train was using the left-hand track, the driver was sitting on the left side of the train, and the track was in a narrow rock cutting. These four factors contributed to less than average visibility.
A Commission of Inquiry headed by Justice Peter McInerney investigated the accident. [1]
The Commission found that the accident occurred after a power failure disabled two consecutive automatic signals: due to their fail-safe design, both exhibited danger (red).
Both trains obtained permission from the signalman at Penrith to pass the first signal at danger. The driver of the Indian Pacific obeyed the rule requiring him to proceed with "extreme caution", but the driver of the interurban train failed to do so and caught up with the Indian Pacific.
The Commission found fault with a number of procedures, their application by railway employees, and the training those employees had received. Among other factors, it found that:
The seven people who died were in the front compartment of the first carriage of the interurban train. The rear carriage of the Indian Pacific was a car transport wagon that did not convey passengers, and, in absorbing the brunt of the collision, was arguably the reason there were not any fatalities on board the Indian Pacific. [2] The impact of the collision was such that the front six metres of the interurban car were compressed into just one metre, while also causing the first six carriages of the Indian Pacific to separate from the rest of the train. [2] [3] When the driver of the CityRail train saw the stationary Indian Pacific, he ran from the driver's compartment (the dead-man's brake was automatically activated) to the lower deck of the double-decker carriage warning the passengers to brace themselves. He was badly injured, but survived because of this. As he ran through, a man from the front compartment ran to the upper deck to warn the passengers and thereby also survived the crash. [4]
A third train, bound for Lithgow, only narrowly avoided colliding with the wreckage when signallers managed to warn the driver to stop just 60 seconds before it reached the crash site. [5]
The train was a standard four-car V set, labelled V21. The first carriage, DIM8067, received critical damage to its front and lower compartments, but it was repaired. To avoid any reference and insensitivity to the victims, it was re-numbered DIM8020 and remained in service until it was withdrawn in 2005 following many problems. [6]
A signal passed at danger (SPAD), known in the United States as a stop signal overrun (SSO) and in Canada as passing a stop signal, is an event on a railway where a train passes a stop signal without authority. This is also known as running a red.
The Clapham Junction rail crash occurred on the morning of 12 December 1988, when a crowded British Rail passenger train crashed into the rear of another train that had stopped at a signal just south of Clapham Junction railway station in London, England, and subsequently sideswiped an empty train travelling in the opposite direction. A total of 35 people died in the collision, while 484 were injured.
The Southall rail crash occurred on 19 September 1997, on the Great Western Main Line at Southall, West London. An InterCity 125 high speed passenger train (HST) failed to slow down in response to warning signals and collided with a freight train crossing its path, causing seven deaths and 139 injuries.
The Cowan rail accident occurred at 7:20pm on 6 May 1990 when the 3801 Limited special steam passenger train returning from the Morpeth Jazz Festival was struck in the rear by the following CityRail inter-urban passenger service. The steam train had stalled while attempting to climb the steep gradient from the Hawkesbury River to Cowan, New South Wales, and it was found that sand applied to the rails to regain traction had interfered with the signals and given the following train a false clear indication.
A wrong-side failure describes a failure condition in a piece of railway signalling equipment that results in an unsafe state. A typical example would be a signal showing a 'proceed' aspect when it should be showing a 'stop' or 'danger' aspect, resulting in a "false clear".
The Winwick rail crash took place at Winwick Junction, near Warrington on the London, Midland and Scottish Railway, on 28 September 1934. Two trains collided, resulting in 11 deaths and 19 injured.
The Clayton Tunnel rail crash occurred on Sunday 25 August 1861, five miles (8 km) from Brighton on the south coast of England. At the time it was the worst accident on the British railway system. A train ran into the back of another inside the tunnel, killing 23 and injuring 176 passengers.
The Ais Gill rail accident occurred on the Settle–Carlisle line in Northwest England on 2 September 1913. Two long trains were both ascending a steep gradient with some difficulty, because their engines generated barely enough power to carry the load. When the first train stopped to build up steam pressure, the driver and fireman of the second train were distracted by maintenance routines, and failed to observe the warning signals. The collision wrecked several carriages, which were then engulfed by flammable gas, killing 16 people and injuring 38.
Two rail accidents have occurred near Castlecary, Scotland. One of these was in 1937 and one in 1968. Both events involved rear-end collisions, and caused the deaths of 35 and 2 people respectively.
The Bellgrove rail accident occurred on 6 March 1989 when two passenger trains collided near Bellgrove station, Glasgow, United Kingdom. Two people were killed and 53 were injured. The cause was driver error, with a signal being passed at danger. The layout of a junction was a contributory factor.
There was a rail crash near Welwyn Garden City railway station in Hertfordshire, England, in 1935 which killed fourteen people, and another in 1957 with one fatality.
The 1995 Ais Gill rail accident occurred near Aisgill, Cumbria, UK, at about 18:55 on 31 January 1995, when a class 156 Super-Sprinter was derailed by a landslide on the Settle-Carlisle Railway line, and was subsequently ran into by a similar train travelling in the opposite direction. The Guard of the first train was fatally injured in the collision.
The railways of New South Wales, Australia have had many incidents and accidents since their formation in 1831. There are close to 1000 names associated with rail-related deaths in NSW on the walls of the Australian Railway Monument in Werris Creek. Those killed were all employees of various NSW railways. The details below include deaths of employees and the general public.
The 1984 Eccles rail crash occurred on 4 December 1984 at Eccles, Greater Manchester, when an express passenger train collided at speed with the rear of a freight train of oil tankers. The driver of the express and two passengers were killed, and 68 people were injured. The cause of the accident was determined to be that the driver of the express train had passed a signal at danger.
The Wrawby Junction rail crash was a train crash which occurred on 9 December 1983, at Wrawby Junction, near Barnetby station, North Lincolnshire, England.
The Marden rail crash occurred on 4 January 1969 near Marden, Kent, United Kingdom, when a passenger train ran into the rear of a parcels train, having passed two signals at danger. Four people were killed and 11 were injured. One person was awarded the British Empire Medal for his part in the aftermath of the collision.
The Ballymacarrett rail crash occurred on 10 January 1945 at 7:50am in the Ballymacarrett area of Belfast, County Down, Northern Ireland on the Belfast to Bangor Line of the Belfast and County Down Railway, when a train led by a heavy autotrain driving trailer ran into the back of a stopped passenger train consisting of lightweight wooden coaches. 22 died with 27 injured. It was the worst crash in Northern Ireland since 1889. The cause was found to be carelessness of the driver of the autotrain who was running too fast for conditions. Fog, unsafe railway rules, and possible distraction from passengers all may have contributed to the accident. Old lightweight rolling stock contributed to the great number of injuries and deaths. The accident led to the demise of the railway company which was nationalised three years later.
The Roseville train collision on 29 July 1950 was a railway collision near Roseville, New South Wales in Australia of the "signal at danger tripped past in accordance to the rules" type.
On the evening of 26 December 1962, cold weather and snow in and around Crewe had caused points to become frozen and trains were being detained at signals. About midway between Winsford and Crewe, the 13:30 Glasgow Central to London Euston Mid-Day Scot, hauled by an English Electric type 4 diesel, D215, with 13 coaches and 500 passengers, was stopped at a signal but the driver found the telephone to Coppenhall Junction, the next signal box ahead, out of order. Seeing the next signal ahead he decided to proceed down towards it and use the telephone there, but too fast. In the darkness he failed to notice the 16:45 express from Liverpool Lime Street to Birmingham New Street, hauled by an electric locomotive with eight coaches with 300 passengers, standing on the line ahead and collided with it at about 20 mph (32 km/h).