Grey Eagle (sternwheeler)

Last updated
Grey Eagle (sternwheeler left) at Salem.jpg
Grey Eagle (on left) at Salem, Oregon.
History
NameGrey Eagle
Route Willamette and Yamhill rivers.
In service1894
Out of service1930
IdentificationUS registry #86300 (1894-1907); #204891 (1907-1930)
FateAbandoned
General characteristics
Tonnage218 grt; 162 rt (1894-1907); 154 grt; 141 rt (1907-1930)
Length111 ft (34 m)
Beam21 ft (6 m)
Depth4.7 ft (1 m) depth of hold
Installed powertwin horizontally mounted high-pressure single-cylinder steam engines.
Propulsionsternwheel

Grey Eagle was a wooden sternwheel-driven steamboat that operated on the Willamette and Yamhill rivers in the United States from 1894 to 1930. In 1903 Grey Eagle became the last commercial steamboat to run upriver to Junction City, Oregon.

Contents

Design and construction

Grey Eagle (also seen spelled Gray Eagle) was built on the Yamhill River at Newberg, Oregon in 1894 for the shipping firm of Fuller, Kemp & Cook. The vessel's dimensions were 111 feet (34 m) long, with a 21-foot (6.4 m) beam, 4.7-foot (1.4 m) depth of hold, 218 gross and 162 registered tons. The steamboat was driven by a sternwheel which was turned by two twin horizontally mounted high-pressure steam engines. Each engine had a cylinder diameter of 10 inches (250 mm) and a bore stroke of 36 inches (910 mm), generating 6 nominal horsepower. Grey Eagle's original steamboat registry number was 86300. [1]

Operations

Grey Eagle was used to tow logs in the Salem area in the late 1890s. [2] In 1903, under Capt. Arthur Riggs, Grey Eagle became the last commercial steamboat to run up the Willamette River to the landing at Junction City, Oregon. [3] After this, aside from an occasional log tow, no steamboat operated any further upriver than Corvallis. [3]

In 1907, Grey Eagle was rebuilt into a towboat at Salem by M. J. Jones for Salem Towing & Transportation Co. [4] The vessel was smaller following the rebuild, at 154 gross and 141 registered tons. The post-rebuild official registry number was 204891. [1] In the late 1920s, the vessel was operated by the Charles K. Spaulding Logging Co. in towing work on the Willamette in the Salem area. [4]

Disposition

Grey Eagle was abandoned in 1930. [1] [4]

Notes

  1. 1 2 3 Affleck, Century of Paddlewheelers, at page 14.
  2. Timmen, Blow for the Landing, at page 138.
  3. 1 2 Corning, Howard McKinley (1973). Willamette Landings -- Ghost Towns of the River (2nd ed.). Portland, OR: Oregon Historical Society. p.190. ISBN   0875950426.
  4. 1 2 3 Newell, ed., McCurdy Marine History, at pages 140 and 404.

Related Research Articles

<i>Altona</i> (sternwheeler)

The steamship Altona operated from 1890 to 1907 on the Willamette River in the U.S. state of Oregon. In 1907, she was transferred to Alaska.

<i>Enterprise</i> (1855)

The Enterprise was an early steamboat operating on the Willamette River in Oregon and also one of the first to operate on the Fraser River in British Columbia. This vessel should not be confused with the many other vessels, some of similar design, also named Enterprise. In earlier times, this vessel was sometimes called Tom Wright's Enterprise after one of her captains, the famous Tom Wright.

James D. Miller

James D. Miller was a steamboat captain in the Pacific Northwest from 1851 to 1903. He became well known for his long length of service, the large number of vessels he commanded, and the many different geographical areas in which he served.

<i>Ruth</i> (sternwheeler 1895)

The steamboat Ruth operated from 1896 to 1917 on the Willamette River in the U.S. state of Oregon. Ruth played an important role in the transport of goods and agricultural products in Oregon, and was one of the fastest steamboats ever to operate on the upper Willamette. This vessel should not be confused with the sternwheeler Ruth built at Libby, Montana in 1896.

<i>Ramona</i> (1892 sternwheeler)

The river sternwheeler Ramona operated from 1892 to 1908 on the Willamette River in Oregon, on the Stikine River running from Wrangell, Alaska into British Columbia, and the Fraser River, in British Columbia. This vessel should not be confused with the coastal steamship Ramona which also ran in Alaskan waters.

<i>Multnomah</i> (1851 sidewheeler)

The Multnomah was one of the first steamboats to operate on the Willamette and Yamhill rivers. This vessel should not be confused with the Multnomah, a steamboat built in Portland, Oregon in 1885, which was larger and of a much different design.

<i>Shoalwater</i> (sidewheeler 1852)

The steamboat Shoalwater was the sixth steamer to operate on the upper Willamette River, which refers to the part of the river above Willamette Falls at Oregon City. In a short career of six years, Shoalwater was renamedFenix, Franklin, and Minnie Holmes. Shoalwater was the first steamboat in Oregon to suffer a boiler explosion, although no fatalities resulted.

<i>Governor Grover</i> (sternwheeler) Willamette River sternwheel steamboat

Governor Grover was a sternwheel steamboat that ran on the Willamette River during the 1870s. Because of the completion of the Willamette Locks in late 1872, it was possible for vessels such as Governor Grover to be built in Portland, Oregon and then readily navigate the Willamette above Willamette Falls.

<i>Elk</i> (sternwheeler 1857)

Elk was a stern-wheel driven steamboat built on the Willamette River in 1857 at Canemah, Oregon. This steamboat is chiefly remembered for its destruction by a boiler explosion in which by good fortune no one was seriously hurt. A folklore tale later arose about this disaster.

<i>Oregona</i> (sternwheeler)

The steamboat Oregona operated on the Willamette River, the Columbia River and the Yamhill River from 1904 to 1936. From 1924 to 1936 this vessel was known as the Interstate.

<i>Pomona</i> (sternwheeler) American steamboat

Pomona was a steamboat which operated on the Willamette, Columbia and Cowlitz rivers from 1898 to 1940. Pomona was specially designed to operate in low water conditions such as typically prevailed in the summer months in Oregon. Pomona was one of the few steamers that could regularly navigate to Corvallis, Oregon which was the practical head of navigation on the Willamette. In 1926, Pomona was substantially rebuilt, and served afterwards as a towboat. In 1940, Pomona was converted into an unpowered floating storehouse.

<i>Elwood</i> (sternwheeler)

Elwood was a sternwheel steamboat which was built to operate on the Willamette River, in Oregon, but which later operated on the Lewis River in Washington, the Stikine River in Canada, and on Puget Sound. The name of this vessel is sometimes seen spelled "Ellwood". Elwood is probably best known for an incident in 1893, when it was approaching the Madison Street Bridge over the Willamette River in Portland, Oregon. The bridge swung open to allow the steamer to pass. However, a streetcar coming in from the east end of the bridge failed to notice the bridge was open, and ran off into the river in the Madison Street Bridge disaster.

Upper Willamette Transportation Line

The Upper Willamette Transportation Line was a line of four inland steamboats that operated from the fall of 1859 to the summer of 1860 on the upper Willamette River in the state of Oregon, United States.

<i>James Clinton</i> (sternwheeler)

James Clinton was a steamboat which operated on the upper Willamette River from 1856 to 1861. Although the Clinton was said to have been "not a very good boat.", it was the first steamer ever to reach Eugene, Oregon. James Clinton was destroyed in April 1861, when a large fire broke out at Linn City, Oregon in a shoreside structure near to where the vessel was moored.

<i>Oregon</i> (sidewheeler 1852)

Oregon was a side-wheel driven steamboat that operated on the Willamette River in the state of Oregon from 1852 to 1854. The steamer was not economically successful and became a total loss by sinking after a short career.

<i>Bonita</i> (1900 sternwheeler)

Bonita was a steamboat which operated on the Willamette and Yamhill rivers. This boat was renamed Metlako in 1902, and operated under that name until 1924 on the Columbia River and its tributaries, the Cowlitz, Lewis and Lake rivers. In 1924, Metlako was renamed B. H. Smith Jr., operating under that name until 1931, when the steamer was abandoned. As Bonita, in September 1900, this vessel was the first steamer to pass through the Yamhill locks.

<i>Alice</i> (sternwheeler)

Alice was a stern-wheel driven steamboat that operated on the Willamette and Columbia rivers in the 1870s and 1880s. Alice was the largest vessel built above Willamette Falls and was considered in its day to be the "Queen of the River". This steamer was rebuilt after near-destruction in a fire at Oregon City, Oregon in May 1873. In 1876, it was withdrawn from the upper Willamette River and transferred to the Columbia River, where it was worked as a towboat moving ocean-going ships to and from Portland and Astoria, Oregon, near the mouth of the Columbia River.

<i>Minnehaha</i> (sternwheeler) Sternwheeler steamboat

Minnehaha was a sternwheel-driven steamboat which was built in 1866 on Oswego Lake, then known as Sucker Lake, in Oregon, United States. Minnehaha was later transferred to the Willamette and Columbia rivers where it operated for the first part of the 1870s.

<i>Albany</i> (1868 sternwheeler)

Albany was a stern-wheel driven steamboat that operated on the Willamette River from 1868 to 1875. This vessel should not be confused with the later sternwheeler Albany, which ran, also on the Willamette River, from 1896 to 1906, when it was rebuilt and renamed Georgie Burton.

George Anson Pease

George Anson Pease was a well-known steamboat captain in the Pacific Northwest region on the United States, who was active from the earliest days of steamboat navigation on the Willamette River in the 1850s. He worked in various roles until the early 1900s, commanding numerous vessels during that time. During a flood in 1861, while in command of the sternwheeler Onward, Pease rescued 40 people from a flood in the area of Salem, Oregon.

References