Autobrake

Last updated

An autobrake is a type of automatic wheel-based hydraulic brake system for advanced airplanes. [1] The autobrake is normally enabled during takeoff and landing procedures, when the aircraft's longitudinal deceleration system can be handled by the automated systems of the aircraft itself in order to keep the pilot free to perform other tasks. [2]

Contents

Landing

While landing, the autobrake can help to free up the pilot to allow monitoring other systems (such as the execution of the landing flare). There are usually several settings for the rate of deceleration. The selection of these settings are normally undertaken on the aircraft instrument panel before landing. Aircraft have multiple autobrake settings, with higher settings providing more aggressive braking forces. These are set based on factors such as runway length or desired exit point from the runway.

When the landing feature of the autobrake is engaged, the aircraft automatically engages pressurized wheel braking upon touchdown to the landing surface. During the roll out, application of the brake pedals transfers control back to the pilot.

One of the main advantages of engaging the autobrake as opposed to manually pressing on brake pedals is the uniform deceleration mechanism of the autobrake. The aircraft automatically decelerates at the selected level regardless of other factors, such as aircraft drag and other deceleration methods such as deployment of thrust reversers or spoilers.

Rejected takeoff

While taking off, the aircraft's autobrake can be set to the rejected takeoff mode, commonly indicated on an aircraft instrument panel as RTO. In case of the Airbus A300-600 and A320 family models, "MAX" mode is set. In RTO setting, the aircraft monitors certain variables, depending on the autobrake model. Most autobrakes engage RTO braking if the pilot returns the throttle to the "idle" position, or if reverse thrust is engaged. Other autobrake systems may monitor critical flight controls for failures.

Related Research Articles

<span class="mw-page-title-main">Taxiing</span> Movement of an aircraft on the ground, under its own power

Taxiing is the movement of an aircraft on the ground, under its own power, in contrast to towing or pushback where the aircraft is moved by a tug. The aircraft usually moves on wheels, but the term also includes aircraft with skis or floats.

<span class="mw-page-title-main">Landing</span> Transition from being in flight to being on a surface

Landing is the last part of a flight, where a flying animal, aircraft, or spacecraft returns to the ground. When the flying object returns to water, the process is called alighting, although it is commonly called "landing", "touchdown"a or "splashdown" as well. A normal aircraft flight would include several parts of flight including taxi, takeoff, climb, cruise, descent and landing.

In aviation, a go-around is an aborted landing of an aircraft that is on final approach or has already touched down. A go-around can either be initiated by the pilot flying or requested by air traffic control for various reasons, such as an unstabilized approach or an obstruction on the runway.

<span class="mw-page-title-main">Autopilot</span> System to maintain vehicle trajectory in lieu of direct operator command

An autopilot is a system used to control the path of an aircraft, marine craft or spacecraft without requiring constant manual control by a human operator. Autopilots do not replace human operators. Instead, the autopilot assists the operator's control of the vehicle, allowing the operator to focus on broader aspects of operations.

<span class="mw-page-title-main">Thrust reversal</span> Temporary diversion of an aircraft engines thrust

Thrust reversal, also called reverse thrust, is the temporary diversion of an aircraft engine's thrust for it to act against the forward travel of the aircraft, providing deceleration. Thrust reverser systems are featured on many jet aircraft to help slow down just after touch-down, reducing wear on the brakes and enabling shorter landing distances. Such devices affect the aircraft significantly and are considered important for safe operations by airlines. There have been accidents involving thrust reversal systems, including fatal ones.

<span class="mw-page-title-main">Spoiler (aeronautics)</span> Device for reducing lift and increasing drag on aircraft wings

In aeronautics, a spoiler is a device which intentionally reduces the lift component of an airfoil in a controlled way. Most often, spoilers are plates on the top surface of a wing that can be extended upward into the airflow to spoil the streamline flow. By so doing, the spoiler creates a controlled stall over the portion of the wing behind it, greatly reducing the lift of that wing section. Spoilers differ from airbrakes in that airbrakes are designed to increase drag without disrupting the lift distribution across the wing span, while spoilers disrupt the lift distribution as well as increasing drag.

<span class="mw-page-title-main">Autoland</span> Automated aircraft landing procedure

In aviation, autoland describes a system that fully automates the landing procedure of an aircraft's flight, with the flight crew supervising the process. Such systems enable airliners to land in weather conditions that would otherwise be dangerous or impossible to operate in.

<span class="mw-page-title-main">Learjet 25</span> Type of aircraft

The Learjet 25 is an American ten-seat, twin-engine, high-speed business jet aircraft manufactured by Learjet. It is a stretched version of the Learjet 24.

<span class="mw-page-title-main">Qantas Flight 1</span> 1999 landing in Bangkok with minor injuries

Qantas 1 was a Qantas passenger flight between Sydney and London that was involved in a runway overrun accident at Don Mueang International Airport in Bangkok on 23 September 1999 as it was landing for a stopover.

<span class="mw-page-title-main">USAir Flight 5050</span> 1989 aviation accident

USAir Flight 5050 was a passenger flight that crashed on takeoff from LaGuardia Airport in Queens, New York. As the plane took off from LaGuardia's runway 31, the plane drifted to the left. After hearing a loud bang, the pilots attempted to reject the takeoff, but were unable to stop the plane short of the end of the runway. The plane continued past the end of the runway and plunged into Bowery Bay. Two passengers were killed.

<span class="mw-page-title-main">Southwest Airlines Flight 1248</span> 2005 aviation accident

Southwest Airlines Flight 1248 was a scheduled passenger flight from Baltimore, Maryland, to Chicago, Illinois, continuing on to Salt Lake City, Utah, and then to Las Vegas, Nevada. On December 8, 2005, the airplane slid off a runway at Midway Airport in Chicago while landing in a snowstorm and crashed into automobile traffic, killing a six-year-old boy.

A takeoff/go-around switch is a switch on the autothrottle of modern large aircraft, with two modes: takeoff (TO) and go-around (GA). The mode is dependent on the phase of flight; usually, on approach to land, the autopilot will be set to approach mode, therefore if the TO/GA switch is pressed it will activate the go-around mode of the autothrottle (about 90–92% N1, if pressed again, go around thrust will increase to full ; conversely, when takeoff is set on the autopilot, the switch activates takeoff mode of the autothrottle. On Boeing aircraft TO/GA modes are selected by a separate button near the throttle levers, but on Airbus aircraft it is activated by advancing the thrust levers forward to the TO/GA detent.

In aviation, a rejected takeoff (RTO) or aborted takeoff is the situation in which the pilot decides to abort the takeoff of an airplane after initiating the takeoff roll but before the airplane leaves the ground.

<span class="mw-page-title-main">S7 Airlines Flight 778</span> 2006 aviation accident

S7 Airlines Flight 778(S7778/SBI778) was a scheduled domestic passenger flight from Moscow to Irkutsk, Russia. On 9 July 2006, at 06:44 local time, the Airbus A310-324 aircraft operating the route overran the runway during its landing in Irkutsk. The aircraft failed to stop and crashed through the airport's concrete perimeter fence, struck rows of private garages and burst into flames, killing 125 people.

<span class="mw-page-title-main">Lufthansa Flight 2904</span> 1993 passenger plane crash in Warsaw, Poland

Lufthansa Flight 2904 was an Airbus A320-200 flying from Frankfurt, Germany to Warsaw, Poland that overran the runway at Okęcie International Airport on 14 September 1993.

<span class="mw-page-title-main">Britannia Airways Flight 226A</span> 1999 aviation accident

Britannia Airways Flight 226A was an international passenger flight from Cardiff, Wales to Girona, Spain, operated by charter airliner Britannia Airways. On 14 September 1999, the Boeing 757-204 aircraft suffered a crash landing and broke apart during a thunderstorm in Girona-Costa Brava Airport. Of the 236 passengers and nine crew on board, two were seriously injured and 41 sustained minor injuries. One of the passengers who had apparently sustained only minor injuries died five days later of unsuspected internal injuries. The aircraft involved in the crash, Boeing 757-204 registration G-BYAG, was damaged beyond economical repair and scrapped.

<span class="mw-page-title-main">Sudan Airways Flight 109</span> 2008 aviation accident

Sudan Airways Flight 109 was a scheduled international Amman–Damascus–Khartoum passenger flight, operated with an Airbus A310 by the flag carrier of Sudan, Sudan Airways. On 10 June 2008, at approximately 17:26 UTC, the Airbus A310 crashed on landing at Khartoum International Airport, killing 30 of the 214 occupants on board.

Brake to Vacate (BTV) is additional software planned by Airbus for incorporation on its line of airliners, intended to reduce runway overruns. A more tangible benefit is the increased ability to exit the runway at a specified turnoff point. The European Aviation Safety Agency certified the system, initially for use on the Airbus A380, in 2009. The second Airbus product to incorporate BTV will be the Airbus A320 family, which is much more widely used around the world than the A380. However, an A320 BTV system would be more modest, since its flight computer does not incorporate the extensive electronic architecture of the A380. The BTV is a very important part in the plane.

<span class="mw-page-title-main">Flight control modes</span> Aircraft control computer software

A flight control mode or flight control law is a computer software algorithm that transforms the movement of the yoke or joystick, made by an aircraft pilot, into movements of the aircraft control surfaces. The control surface movements depend on which of several modes the flight computer is in. In aircraft in which the flight control system is fly-by-wire, the movements the pilot makes to the yoke or joystick in the cockpit, to control the flight, are converted to electronic signals, which are transmitted to the flight control computers that determine how to move each control surface to provide the aircraft movement the pilot ordered.

<span class="mw-page-title-main">Delta Air Lines Flight 1086</span> 2015 aviation incident

Delta Air Lines Flight 1086 was a scheduled Delta Air Lines domestic passenger flight between Atlanta and New York's LaGuardia Airport. On March 5, 2015, the McDonnell Douglas MD-88 aircraft veered off the runway shortly after landing at LaGuardia Airport in New York City. The plane ran up the seawall berm and struck the perimeter fence, sliding along it for approximately 940 feet (290 m) before coming to rest with the nose of the aircraft hanging over the berm above Flushing Bay. There were no fatalities, although 29 people suffered minor injuries. The aircraft was seriously damaged and written off.

References

  1. "Landing Systems: Autobrake Systems". www.craneae.com/.
  2. Villaume, Fabrice. "Brake-to-Vacate system" (PDF). Fast 44 (July, 2009). Airbus, an EADS Company: 17–25. ISSN   1293-5476. Archived from the original (PDF) on 2009-09-20. Retrieved 2009-11-06.