Waco F series | |
---|---|
ex US Civilian Pilot Training Program 1941 Waco UPF-7 | |
Role | open-cockpit biplane |
National origin | United States |
Manufacturer | Waco Aircraft Company |
Introduction | 1930 |
Status | YMF-5 in production (2013) |
Primary user | private pilot owners and training schools |
The Waco F series is a series of American-built general aviation and military biplane trainers of the 1930s from the Waco Aircraft Company.
The Waco 'F' series of biplanes supplanted and then replaced the earlier 'O' series of 1927/33. The 'F' series had an airframe which was smaller and about 450 pounds (200 kg) lighter than the 'O' series, while continuing to provide accommodation for three persons in tandem open cockpits. A similar performance to the earlier model was obtained on the power of smaller and more economical engines. [1]
The initial models were the INF (125 hp (93 kW) Kinner engine), KNF (100 hp (75 kW) Kinner) and the RNF (110 hp (82 kW) Warner Scarab), all of which had externally braced tailwheel undercarriages. Many further sub-models followed with more powerful engines of up to 225 hp (168 kW). The most powerful in the range was the ZPF of 1936/37, intended for executive use.
The 'F' series was popular with private owner pilots for sporting and other uses and continued in production through the late 1930s. The tandem cockpit UPF-7 was adopted by the Civilian Pilot Training Program and continued in production until 1942 by which time over 600 had been built. [2]
The 1934 model YMF was substantially redesigned with a longer and wider fuselage, larger rudder and other structural changes, and put into production in March 1986 by WACO Classic Aircraft of Lansing, Michigan as the YMF-5. [1] Over 150 YMF-5s were completed as of 2017 with new examples being built to specific orders. [3] [ failed verification ]
The WACO Aircraft Company of Ohio Inc had built three replicas by December 2011, which they designated MF. [4]
Considerable numbers of 'F' series biplanes, both original and newly built, remain in service.
Listed in approximate chronological order (per Simpson, 2001, p. 573) First letter of designation refers to engine installed. From 1936 Waco added year suffixes to designations—e.g. YPF-6, YPF-7, with the numeral being the last digit of the model year.
Data from The Aircraft of the World [2]
General characteristics
Performance
The Grumman F2F was a single-engine, biplane fighter aircraft with retractable undercarriage, serving as the standard fighter for the United States Navy between 1936 and 1940. It was designed for both carrier- and land-based operations.
The Boeing YB-9 was the first all-metal monoplane bomber aircraft designed for the United States Army Air Corps. The YB-9 was a much enlarged twin-engine development of Boeing's single-engine Model 200 Monomail commercial transport.
The Waco Custom Cabins were a series of up-market single-engined four-to-five-seat cabin sesquiplanes of the late 1930s produced by the Waco Aircraft Company of the United States. "Custom Cabin" was Waco's own description of the aircraft which despite minor differences, were all fabric-covered biplanes.
The Continental R-670 was a seven-cylinder four-stroke radial aircraft engine produced by Continental displacing 668 cubic inches and a dry weight of 465 lb (211 kg). Horsepower varied from 210 to 240 at 2,200 rpm. The engine was the successor to Continental's first radial engine, the 170 hp Continental A-70. This engine was used on many aircraft in the 1930s and 1940s. The R-670 was widely used in the PT-17 Stearman primary training aircraft of the U.S. military.
The WACO Classic Aircraft Corporation is an American aircraft manufacturer, located in Battle Creek, Michigan. It was founded in 1983 as the Classic Aircraft Corporation and is now called the WACO Aircraft Corporation.
The Waco Aircraft Company (WACO) was an aircraft manufacturer located in Troy, Ohio, United States. Between 1920 and 1947, the company produced a wide range of civilian biplanes.
The Kinner C-7 Envoy was an American four-seat cabin monoplane built by Kinner Airplane & Motor Corporation in the 1930s.
The Curtiss CS was a reconnaissance and torpedo bomber aircraft used by the United States Navy during the 1920s. It was a large single-engine biplane with single-bay unstaggered wings, the design conventional in all respects other than that the lower wing was of greater span than the upper. The CS was built to allow its undercarriage to be quickly and easily interchangeable between wheeled, tailskid undercarriage, and twin pontoons for operation from water. Provision for the carriage of a torpedo was semi-recessed into the underside of the fuselage, blended in behind an aerodynamic fairing. The pilot and gunner sat in tandem open cockpits, while accommodation inside the fuselage was provided for a third crewmember who served as bombardier and radio operator. This station was also provided with a dorsal hatch aft of the gunner's position, and a ventral blister aft of the torpedo recess, which was used for aiming bombs or torpedoes.
The Kreider-Reisner Challenger is an American utility biplane aircraft designed and produced by the Kreider-Reisner Aircraft Company, which was later taken over by the Fairchild Aircraft Company.
The Martin T3M was an American torpedo bomber of the 1920s. A single-engined three-seat biplane, it became a standard torpedo bomber of the U.S. Navy, operating from both land bases and from aircraft carriers from 1926 to 1932.
The Martin T4M was an American torpedo bomber of the 1920s. A development by the Glenn L. Martin Company of their earlier Martin T3M, and, like it a single-engined biplane, the T4M served as the standard torpedo bomber aboard the aircraft carriers of the United States Navy through much of the 1930s.
The Waco A series is a range of light American-built twin side-by-side seater sporting biplanes of the early 1930s.
The Waco N series is a range of 1930s American-built cabin biplanes with a fixed tricycle undercarriage produced by the Waco Aircraft Company.
The Waco Standard Cabin series is a range of American single-engine 4–5 seat fabric covered cabin biplanes produced by the Waco Aircraft Company beginning in 1931 with the QDC and continuing until 1942 when production ended for the VKS-7F. They were used as light passenger and utility transports, navigational trainers, bushplanes and briefly as maritime reconnaissance aircraft during World War 2.
The Waco S Series is a family of American cabin biplanes produced by the Waco Aircraft Company starting in 1935.
The Handley Page Type S, or HPS-1 was a prototype British carrier-based fighter developed for the United States Navy in the early 1920s. A low-wing monoplane, it was unsuccessful, only two being built and flown.
The Swallow New Swallow, also known as the Swallow Commercial Three-Seater is an American-built general purpose biplane of the mid- to late 1920s. The New Swallow name was to distinguish it from the aircraft from which it was derived, the Laird Swallow.
The Aeronca K series, Aeronca Chief, Aeronca Super Chief, Aeronca Tandem, Aeronca Scout, Aeronca Sea Scout, Aeronca Champion and Aeronca Defender were a family of American high-winged light touring aircraft, designed and built starting in the late 1930s by Aeronca Aircraft.
The Gee Bee Model A was an American two-seat open cockpit single-bay biplane developed by the Granville Brothers that first flew in 1929.