Bell XP-52

Last updated

XP-52
Bell XP-59 wind tunnel model 060913-F-1234P-012.jpg
A wind tunnel model of the XP-59
RoleFighter
Manufacturer Bell Aircraft Corporation
StatusCanceled October 1940 (XP-52)
Canceled 25 November 1941 (XP-59)
Number builtNone

The Bell XP-52 and subsequent XP-59 were World War II fighter aircraft design projects by the American Bell Aircraft Corporation.

Contents

Both projects featured a twin-boom layout with a rear-mounted engine driving pusher contra-rotating propellers.

When the XP-59 project was canceled the designation XP-59A was used as a cover for a secret jet fighter prototype, which would enter production as the P-59 Airacomet.

XP-52

The intended engine - the Continental X-1430 in the National Museum of the United States Air Force Continental I-1430.jpg
The intended engine – the Continental X-1430 in the National Museum of the United States Air Force

The XP-52 design was begun by the Bell Company in 1940, separate from the R-40C competition, under the Air Material Command designator MX-3.

The short fuselage carried a piston engine in the rear, driving a pair of contra-rotating propellers in a pusher configuration. The wings were swept back at an angle of 20 degrees, with a horizontal stabilizer mounted behind the propeller on twin booms running back from the wings. The fuselage was unusually streamlined, being round and barrel-shaped, with the forward-located pilot's cockpit fully faired-in to its lines and the nose ending in a round air intake which was ducted back internally to the engine. [1] The undercarriage was a tricycle arrangement, with the main wheels retracting into the tailbooms. Propulsion was to be provided by the experimental Continental XIV-1430-3 inverted V-12 engine. [2]

The XP-52 was canceled in October 1940 because the XIV-1430 engine ran into technical difficulties. Bell submitted a similar design to the US Navy as the Model 19, but this too was never built. [3]

XP-59

Although generally similar in layout to the XP-52, the XP-59 was slightly larger and heavier, and was to be powered by a Pratt and Whitney R-2800-23 engine of 2,000 horsepower (1,500 kW). [1] Two prototypes were ordered in February 1941. [3]

On 3 October 1941 the contract for Bell's first jet fighter was signed. The prototype was designated the XP-59A and it would enter production as the P-59 Airacomet. The original XP-59 was canceled on November 25, 1941 because Bell itself was pre-occupied with development of the Bell P-63 Kingcobra. [1] [3]

See also

Aircraft of comparable role, configuration, and era

Related lists

Related Research Articles

Bell Aircraft American aircraft manufacturer

The Bell Aircraft Corporation was an American aircraft manufacturer, a builder of several types of fighter aircraft for World War II but most famous for the Bell X-1, the first supersonic aircraft, and for the development and production of many important civilian and military helicopters. Bell also developed the Reaction Control System for the Mercury Spacecraft, North American X-15, and Bell Rocket Belt. The company was purchased in 1960 by Textron, and lives on as Bell Textron.

Bell XP-83 Prototype escort fighter

The Bell XP-83 was a United States prototype escort fighter designed by Bell Aircraft during World War II. It first flew in 1945. As an early jet fighter, its limitations included a lack of power and it was soon eclipsed by more advanced designs.

Bell P-59 Airacomet 1942 fighter aircraft series by Bell

The Bell P-59 Airacomet was a single-seat, twin jet-engine fighter aircraft that was designed and built by Bell Aircraft during World War II, the first produced in the United States. As the British were further along in jet engine development, they donated an engine for the United States to copy in 1941 that became the basis for the General Electric jet used by the P-59 a year later. Because the plane was underpowered, the United States Army Air Forces (USAAF) was not impressed by its performance and canceled half of the original order for 100 fighters, using the completed aircraft as trainers. The USAAF would instead go on to select the Lockheed P-80 Shooting Star as its first operational jet fighter. Although no P-59s entered combat, the aircraft paved the way for later generations of U.S. turbojet-powered aircraft.

Curtiss-Wright XP-55 Ascender 1943 prototype fighter aircraft

The Curtiss-Wright XP-55 Ascender is a 1940s United States prototype fighter aircraft built by Curtiss-Wright. Along with the Vultee XP-54 and Northrop XP-56, it resulted from United States Army Air Corps proposal R-40C issued on 27 November 1939 for aircraft with improved performance, armament, and pilot visibility over existing fighters; it specifically allowed for unconventional aircraft designs. An unusual design for its time, it had a canard configuration, a rear-mounted engine, swept wings, and two vertical tails. Because of its pusher design, it was sarcastically referred to as the "Ass-ender". Like the XP-54, the Ascender was designed for the Pratt & Whitney X-1800 engine, but was re-designed after that engine project was canceled. It was also the first Curtiss fighter aircraft to use tricycle landing gear.

Pusher configuration Aircraft propellers behind their engine

In an aircraft with a pusher configuration, the propeller(s) are mounted behind their respective engine(s). According to British aviation author Bill Gunston, a "pusher propeller" is one mounted behind the engine, so that the drive shaft is in compression in normal operation.

Consolidated Vultee XP-81 Prototype fighter aircraft

The Consolidated Vultee XP-81 is a development of the Consolidated Vultee Aircraft Corporation to build a single seat, long range escort fighter that combined use of both turbojet and turboprop engines. Although promising, the lack of suitable engines combined with the end of World War II doomed the project.

Curtiss P-60 1941 fighter aircraft family

The Curtiss P-60 was a 1940s American single-engine single-seat, low-wing monoplane fighter aircraft developed by the Curtiss-Wright company as a successor to their P-40. It went through a lengthy series of prototype versions, eventually evolving into a design that bore little resemblance to the P-40. None of these versions reached production.

Fisher P-75 Eagle 1943 fighter aircraft series by General Motors Fisher Body Division

The Fisher P-75 Eagle was an American fighter aircraft designed by the Fisher Body Division of General Motors. Development started in September 1942 in response to United States Army Air Forces requirement for a fighter possessing an extremely high rate of climb, using the most powerful liquid-cooled engine then available, the Allison V-3420. The program was cancelled after only a small number of prototypes and production aircraft had been completed, as it was no longer required in its original role, could not be quickly deployed, and possessed no significant advantages over aircraft already in production.

Grumman XF5F Skyrocket

The Grumman XF5F Skyrocket was a prototype twin-engined shipboard fighter interceptor. The United States Navy ordered one prototype, model number G-34, from Grumman Aircraft Engineering Corporation on 30 June 1938; its designation was XF5F-1. The aircraft had a unique appearance: The forward "nose" of the fuselage did not extend forward of the wing. Provisions were included for two 20 mm (0.906 in) Madsen cannon as armament.

McDonnell XP-67 Prototype fighter aircraft

The McDonnell XP-67 "Bat" or "Moonbat" was a prototype for a twin-engine, long-range, single-seat interceptor aircraft for the United States Army Air Forces. Although the design was conceptually advanced, it was beset by numerous problems and never approached its anticipated level of performance. The project was cancelled after the sole completed prototype was destroyed by an engine fire.

Republic XP-69 American fighter aircraft project

The Republic XP-69 was an American fighter aircraft proposed by Republic Aviation in 1941 in response to a requirement by the United States Army Air Corps for a high-speed fighter. Manufacturers were encouraged to consider unorthodox designs; although the design was ordered as a prototype it was canceled because of delays with the engine that was to power it.

Vultee XP-54 Prototype fighter aircraft

The Vultee XP-54 Swoose Goose was a prototype fighter built by the Vultee Aircraft Company for the United States Army Air Forces (USAAF).

Northrop XP-56 Black Bullet Experimental fighter intercepter aircraft by Northrop

The Northrop XP-56 Black Bullet was a unique prototype fighter interceptor built by the Northrop Corporation. It was one of the most radical of the experimental aircraft built during World War II. Ultimately, it was unsuccessful and did not enter production.

Curtiss XP-71 Twin-engined fighter aircraft proposal

The Curtiss XP-71 was a 1941 American proposal for an exceptionally large heavy fighter design. It was intended to serve as an extreme-range interceptor and escort fighter. While significant progress was made in the design phase, no prototypes were ever built, and the design was abandoned in 1943.

Vultee XP-68 Tornado Canceled fighter aircraft project

The Vultee XP-68 Tornado was proposed American high-altitude interceptor aircraft. It was based on the experimental XP-54 Swoose Goose and powered by the Wright R-2160 Tornado 42-cylinder radial engine driving a set of contra-rotating propellers in a twin-boom pusher configuration. When the engine was cancelled on 22 November 1941, the XP-68 was also cancelled.

SAAB 21

The SAAB 21 is a Swedish single-seat low-wing monoplane fighter and attack aircraft designed and manufactured by SAAB. It used a relatively unorthodox twin boom fuselage with a pusher engine, giving the aircraft an unusual appearance.

Ambrosini SS.4

The SAI-Ambrosini SS.4 was an Italian fighter prototype developed in the late 1930s, featuring a canard-style wing layout and a pusher propeller. Development of the SS.4 was abandoned after the prototype crashed on its second flight.

Powered aircraft Aircraft which uses some form of onboard propulsion to fly

A powered aircraft is an aircraft that uses onboard propulsion with mechanical power generated by an aircraft engine of some kind.

SNCASO SO.8000 Narval French carrier-based strike fighter designed by Sud-Ouest in the late 1940s

The SNCASO SO.8000 Narval was a French carrier-based strike fighter designed by Sud-Ouest in the late 1940s. The French Navy ordered two prototypes in 1946 and they made their maiden flights three years later. They were plagued by aerodynamic problems and unreliability issues with their piston engines. The aircraft proved to be slow, lacking in lateral and longitudinal stability and unsuitable for carrier operations; it did not enter production.

The P-47 Thunderbolt was a World War II fighter aircraft built by Republic Aviation from 1941 to 1945.

References

  1. 1 2 3 Jones, L.; US Fighters, Aero, 1975.
  2. Jenkins, Dennis R. and Tony R. Landis. Experimental & Prototype U.S. Air Force Jet Fighters. North Branch, Minnesota, USA: Specialty Press, 2008. ISBN   978-1-58007-111-6.
  3. 1 2 3 Buttler, Tony, and Griffith, Alan, 2015. American Secret Projects: Fighters, Bombers, and Attack Aircraft, 1937–1945. Manchester: Crecy Publishing. ISBN   978-1906537487.