DVB-C

Last updated

Digital Video Broadcasting - Cable (DVB-C) is the DVB European consortium standard for the broadcast transmission of digital television over cable. This system transmits an MPEG-2 or MPEG-4 family digital audio/digital video stream, using a QAM modulation with channel coding. The standard was first published by the ETSI in 1994, and subsequently became the most widely used transmission system for digital cable television in Europe, Asia and South America. [1] It is deployed worldwide in systems ranging from the larger cable television networks (CATV) down to smaller satellite master antenna TV (SMATV) systems.

Contents

Technical description

DVB-C transmitter

Scheme of a DVB-C transmission system Dvbc tx scheme.svg
Scheme of a DVB-C transmission system

With reference to the figure, a short description of the single processing blocks follows.

Available bit rates for a DVB-C system (Mbit/s)
ModulationBandwidth (MHz)
246810
16-QAM6.4112.8219.2325.6432.05
32-QAM8.0116.0324.0432.0540.07
64-QAM9.6219.2328.8538.4748.08
128-QAM11.2222.4433.6644.8856.10
256-QAM12.8225.6438.4751.2964.11

DVB-C receiver

The receiving STB adopts techniques which are dual to those ones used in the transmission.

DVB-C2

On February 18, 2008 it was announced that a new standard – DVB-C2 – would be developed during 2008, and a "Call for Technologies" was issued. [2] Proposals including simulation programs and information on patent rights could be submitted until June 16, 2008.

"The results of the DVB-C2 Study Mission already provided clear indications that technologies are available allowing the performance of the second generation DVB cable transmission system to get so close to the theoretical Shannon Limit that any further improvements in the future would most likely not be able to justify the introduction of a disruptive third generation of cable transmission system." (DVB-C2 CfT)

By using state of the art coding and modulation techniques, DVB-C2 should offer greater than 30% higher spectrum efficiency under the same conditions, and the gains in downstream channel capacity will be greater than 60% for optimized HFC networks.

The final DVB-C2 specification was approved by the DVB Steering Board in April 2009.

DVB-C2 allows bit rates up to 83.1 Mbit/s on an 8 MHz channel bandwidth when using 4096-QAM modulation; future extensions will allow up to 97 Mbit/s and 110.8 Mbit/s per channel using 16384-QAM and 65536-AQAM modulation. [3]

Modes and features of DVB-C2 in comparison to DVB-C:

DVB-CDVB-C2
Input Interface Single Transport Stream (TS)Multiple Transport Stream and Generic Stream Encapsulation (GSE)
Modes Constant Coding & Modulation Variable Coding & Modulation and Adaptive Coding & Modulation
FEC Reed Solomon (RS) LDPC + BCH 1/2, 2/3, 3/4, 3/5, 4/5, 5/6, 6/7, 7/8, 8/9, 9/10 [4]
Modulation Single Carrier QAM absolute OFDM [5]
Modulation Schemes16- to 256-QAM 16- to 4096-QAM
Guard Interval Not Applicable1/64 or 1/128
Inverse Fast Fourier transform (IFFT) sizeNot Applicable4k [6]
Interleaving Bit-InterleavingBit- Time- and Frequency-Interleaving
Pilots Not ApplicableScattered and Continual Pilots

Countries that use DVB-C

See also

Related Research Articles

<span class="mw-page-title-main">Digital television</span> Television transmission using digital encoding

Digital television (DTV) is the transmission of television signals using digital encoding, in contrast to the earlier analog television technology which used analog signals. At the time of its development it was considered an innovative advancement and represented the first significant evolution in television technology since color television in the 1950s. Modern digital television is transmitted in high-definition television (HDTV) with greater resolution than analog TV. It typically uses a widescreen aspect ratio in contrast to the narrower format (4:3) of analog TV. It makes more economical use of scarce radio spectrum space; it can transmit up to seven channels in the same bandwidth as a single analog channel, and provides many new features that analog television cannot. A transition from analog to digital broadcasting began around 2000. Different digital television broadcasting standards have been adopted in different parts of the world; below are the more widely used standards:

<span class="mw-page-title-main">MPEG-2</span> Video encoding standard

MPEG-2 is a standard for "the generic coding of moving pictures and associated audio information". It describes a combination of lossy video compression and lossy audio data compression methods, which permit storage and transmission of movies using currently available storage media and transmission bandwidth. While MPEG-2 is not as efficient as newer standards such as H.264/AVC and H.265/HEVC, backwards compatibility with existing hardware and software means it is still widely used, for example in over-the-air digital television broadcasting and in the DVD-Video standard.

<span class="mw-page-title-main">Orthogonal frequency-division multiplexing</span> Method of encoding digital data on multiple carrier frequencies

In telecommunications, orthogonal frequency-division multiplexing (OFDM) is a type of digital transmission used in digital modulation for encoding digital (binary) data on multiple carrier frequencies. OFDM has developed into a popular scheme for wideband digital communication, used in applications such as digital television and audio broadcasting, DSL internet access, wireless networks, power line networks, and 4G/5G mobile communications.

<span class="mw-page-title-main">Multiplexing</span> Method of combining multiple signals into one signal over a shared medium

In telecommunications and computer networking, multiplexing is a method by which multiple analog or digital signals are combined into one signal over a shared medium. The aim is to share a scarce resource – a physical transmission medium. For example, in telecommunications, several telephone calls may be carried using one wire. Multiplexing originated in telegraphy in the 1870s, and is now widely applied in communications. In telephony, George Owen Squier is credited with the development of telephone carrier multiplexing in 1910.

8VSB is the modulation method used for broadcast in the ATSC digital television standard. ATSC and 8VSB modulation is used primarily in North America; in contrast, the DVB-T standard uses COFDM.

<span class="mw-page-title-main">DVB</span> Open standard for digital television broadcasting

Digital Video Broadcasting (DVB) is a set of international open standards for digital television. DVB standards are maintained by the DVB Project, an international industry consortium, and are published by a Joint Technical Committee (JTC) of the European Telecommunications Standards Institute (ETSI), European Committee for Electrotechnical Standardization (CENELEC) and European Broadcasting Union (EBU).

A satellite modem or satmodem is a modem used to establish data transfers using a communications satellite as a relay. A satellite modem's main function is to transform an input bitstream to a radio signal and vice versa.

DVB-T, short for Digital Video Broadcasting – Terrestrial, is the DVB European-based consortium standard for the broadcast transmission of digital terrestrial television that was first published in 1997 and first broadcast in Singapore in February, 1998. This system transmits compressed digital audio, digital video and other data in an MPEG transport stream, using coded orthogonal frequency-division multiplexing modulation. It is also the format widely used worldwide for Electronic News Gathering for transmission of video and audio from a mobile newsgathering vehicle to a central receive point. It is also used in the US by Amateur television operators.

In telecommunications and computing, bit rate is the number of bits that are conveyed or processed per unit of time.

<span class="mw-page-title-main">ATSC standards</span> Standards for digital television in the US

Advanced Television Systems Committee (ATSC) standards are an International set of standards for broadcast and digital television transmission over terrestrial, cable and satellite networks. It is largely a replacement for the analog NTSC standard and, like that standard, is used mostly in the United States, Mexico, Canada, South Korea and Trinidad & Tobago. Several former NTSC users, such as Japan, have not used ATSC during their digital television transition, because they adopted other systems such as ISDB developed by Japan, and DVB developed in Europe, for example.

<span class="mw-page-title-main">Digital Radio Mondiale</span> Digital radio broadcasting standard

Digital Radio Mondiale is a set of digital audio broadcasting technologies designed to work over the bands currently used for analogue radio broadcasting including AM broadcasting—particularly shortwave—and FM broadcasting. DRM is more spectrally efficient than AM and FM, allowing more stations, at higher quality, into a given amount of bandwidth, using xHE-AAC audio coding format. Various other MPEG-4 codecs and Opus are also compatible, but the standard now specifies xHE-AAC.

Digital cable is the distribution of cable television using digital data and video compression. The technology was first developed by General Instrument. By 2000, most cable companies offered digital features, eventually replacing their previous analog-based cable by the mid 2010s. During the late 2000s, broadcast television converted to the digital HDTV standard, which was incompatible with existing analog cable systems.

Broadcasttelevision systems are the encoding or formatting systems for the transmission and reception of terrestrial television signals.

<span class="mw-page-title-main">DVB-S2</span> Digital satellite television standard

Digital Video Broadcasting - Satellite - Second Generation (DVB-S2) is a digital television broadcast standard that has been designed as a successor for the popular DVB-S system. It was developed in 2003 by the Digital Video Broadcasting Project, an international industry consortium, and ratified by ETSI in March 2005. The standard is based on, and improves upon DVB-S and the electronic news-gathering system, used by mobile units for sending sounds and images from remote locations worldwide back to their home television stations.

MPEG transport stream or simply transport stream (TS) is a standard digital container format for transmission and storage of audio, video, and Program and System Information Protocol (PSIP) data. It is used in broadcast systems such as DVB, ATSC and IPTV.

<span class="mw-page-title-main">Asynchronous serial interface</span> Standardised transport interface for the broadcast industry

Asynchronous Serial Interface, or ASI, is a method of carrying an MPEG Transport Stream (MPEG-TS) over 75-ohm copper coaxial cable or optical fiber. It is popular in the television industry as a means of transporting broadcast programs from the studio to the final transmission equipment before it reaches viewers sitting at home.

In computing, telecommunication, information theory, and coding theory, forward error correction (FEC) or channel coding is a technique used for controlling errors in data transmission over unreliable or noisy communication channels.

<span class="mw-page-title-main">Digital television adapter</span> Type of television tuner to display digital signals on analog sets

A digital television adapter (DTA), commonly known as a converter box or decoder box, is a television tuner that receives a digital television (DTV) transmission, and converts the digital signal into an analog signal that can be received and displayed on an analog television set. Some also have an HDMI output since some TVs with HDMI do not have a digital tuner. The input digital signal may be over-the-air terrestrial television signals received by a television antenna, or signals from a digital cable system. It normally does not refer to satellite TV, which has always required a set-top box either to operate the big satellite dish, or to be the integrated receiver/decoder (IRD) in the case of direct-broadcast satellites (DBS).

DVB-T2 is an abbreviation for "Digital Video Broadcasting – Second Generation Terrestrial"; it is the extension of the television standard DVB-T, issued by the consortium DVB, devised for the broadcast transmission of digital terrestrial television. DVB has been standardized by ETSI.

ATSC-M/H is a U.S. standard for mobile digital TV that allows TV broadcasts to be received by mobile devices.

References

  1. "DVB-C will surpass US´ cable technologies in 2013 in Latin America". NexTV Latam. 2019-02-22. Archived from the original on 2019-02-23. Retrieved 2019-02-22.
  2. "Second Generation Transmission Technologies for Cable Networks. Call for Technologies" (PDF). www.dvb.org. Archived from the original (PDF) on 2009-02-19. Retrieved 2009-02-19.
  3. Dr. Dirk Jaeger (2010-09-02). "DVB-C2 Gets Reality - Facts and Figures on a New Transmission Approach". 8th Broadband Technology Conference, Gdynia. ReDeSign Project. Archived from the original on 2011-07-20.
  4. "ETSI EN 302 769 V1.3.1. Digital Video Broadcasting (DVB); Frame structure channel coding and modulation for a second generation digital transmission system for cable systems (DVB-C2)" (PDF). DVB consortium. 2015-10-01.
  5. "ETSI TS 102 991 V1.3.1. Digital Video Broadcasting (DVB); Implementation Guidelines for a second generation digital cable transmission system (DVB-C2)" (PDF). DVB consortium. 2016-01-01.
  6. "DVB-C2 The second generation transmission technology for broadband cable" (PDF). Dirk Jaeger, Philipp Hasse, Joerg Robert, Institut fuer Nachrichtentechnik at Technische Universitaet Braunschweig. 2009-04-08. Archived from the original (PDF) on 2012-04-02. Retrieved 2013-01-24.