List of auto parts

Last updated

This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many (not all) of these parts are also used on other motor vehicles such as trucks and buses.

Contents

Car body and main parts

Body components, including trim

Doors

Windows

Low voltage/auxiliary electrical system and electronics

Audio/video devices

Cameras

Low voltage electrical supply system

Gauges and meters

Ignition system

  • Sparking cable
  • Distributor
  • Distributor Cap
  • Electronic timing controller
  • Ignition box
  • Ignition coil
  • Ignition Coil Connector
  • Ignition coil parts
  • Ignition magneto
  • Spark plug
  • Glow Plug

Lighting and signaling system

Sensors

Starting system

Electrical switches

  • Battery
  • Door switch
  • Ignition switch
  • Power window switch
  • Steering column switch
  • Switch cover
  • Switch panel
  • Thermostat
  • Frame switch
  • Fan ditch
  • Parts and functions of starter system
  • Neutral Safety Switch

Wiring harnesses

(wiring loom or cable loom)
  • Air conditioning harness
  • Engine compartment harness
  • Interior harness
  • floor harness
  • Main harness
  • control harness

Miscellaneous

Interior

Floor components and parts

Other components

Car seat

Power-train and chassis

Braking system

Electrified powertrain components

Engine components and parts

Engine cooling system

Engine oil systems

Exhaust system

Fuel supply system

Suspension and steering systems

Transmission system

  • Adjustable pedal
  • Axle shaft
  • Bell housing
  • Universal joint
  • Carrier assembly
  • Chain wheel and sprocket
  • Clutch assembly
  • Clutch cable
  • Clutch disk
  • Clutch fan
  • Clutch fork
  • Clutch hose
  • Clutch lever
  • Clutch lining
    • Clutch pedal
    • Clutch pressure plate
    • Clutch shoe
    • Clutch spring
  • Differential
    • Differential case
      • Pinion bearing
      • Differential clutch
      • Spider gears
      • Differential casing
    • Differential flange
    • Differential gear
    • Differential seal
  • Flywheel
    • Flywheel ring gear
    • Flywheel clutch
  • Gear
    • Gear coupling
    • Gear pump
    • Gear ring
    • Gear stick (gear-stick, gear lever, selection lever, shift stick, gear shifter)
  • Gearbox
  • Idler gear
  • Knuckle
  • Master cylinder
  • Output shaft
  • Pinion
  • Planetary gear set
  • Prop shaft (drive shaft, propeller shaft)
  • Shift cable
  • Shift fork
  • Shift knob
  • Slave cylinder
  • Speed reducer
  • Speedometer gear
  • Steering gear
  • Torque converter
  • Trans-axle housing
  • Transfer case
  • Transmission gear
  • Transmission pan
  • Transmission seal and bonded piston
  • Transmission spring
  • Transmission yoke

Miscellaneous auto parts

Air conditioning system (A/C)

Bearings

Hose

Other miscellaneous parts

See also

Related Research Articles

<span class="mw-page-title-main">Ford Power Stroke engine</span> Reciprocating internal combustion engine

Power Stroke, also known as Powerstroke or PowerStroke, is the name used by a family of diesel engines for trucks produced by Ford Motor Company and Navistar International for Ford products since 1994. Along with its use in the Ford F-Series, applications include the Ford E-Series, Ford Excursion, and Ford LCF commercial truck. The name was also used for a diesel engine used in South American production of the Ford Ranger.

<span class="mw-page-title-main">Engine braking</span> Retarding forces within an engine used to slow a vehicle

Engine braking occurs when the retarding forces within an internal combustion engine are used to slow down a motor vehicle, as opposed to using additional external braking mechanisms such as friction brakes or magnetic brakes.

<span class="mw-page-title-main">Ferrari Mondial</span> Motor vehicle

The Ferrari Mondial is a mid-engined, V8, grand tourer manufactured and marketed by Ferrari between 1980 and 1993 – with styling by Pininfarina and bodywork by Carrozzeria Scaglietti.

<span class="mw-page-title-main">Hydraulic machinery</span> Type of machine that uses liquid fluid power to perform work

Hydraulic machines use liquid fluid power to perform work. Heavy construction vehicles are a common example. In this type of machine, hydraulic fluid is pumped to various hydraulic motors and hydraulic cylinders throughout the machine and becomes pressurized according to the resistance present. The fluid is controlled directly or automatically by control valves and distributed through hoses, tubes, or pipes.

<span class="mw-page-title-main">Learjet 25</span> Type of aircraft

The Learjet 25 is an American ten-seat, twin-engine, high-speed business jet aircraft manufactured by Learjet. It is a stretched version of the Learjet 24.

<span class="mw-page-title-main">Honda RVF750 RC45</span> Type of motorcycle

The Honda RVF750R RC45 was a fully faired racing motorcycle created for homologation purposes for the Superbike World Championship by Honda Racing Corporation. The RVF750R was the successor to the VFR750R RC30. Like its predecessor, the RVF750R featured a DOHC liquid-cooled V4 4-stroke engine with gear driven cams and a single-sided swingarm, but unlike the RC30 it utilized electronic fuel injection, in a setup very similar to the production 1992 NR750. The US spec engine had a 749.2cc capacity and was rated at 101 horsepower; the European version was rated at 118 horsepower. A simple rewire modification to the PGM-FI box increased power in the US engine up to the 118 hp. It was manufactured from 1994 until 1995 and sold in limited numbers, followed by the VTR1000R SP-1 RC51 in 2000. Unlike the VFR750R RC30 and VFR750F from which the engine was originally derived the gear drive for the cams was moved from the centre of the engine in between the cylinders to the one side allowing a slightly narrower engine.

<span class="mw-page-title-main">Chevrolet Engineering Research Vehicle</span>

The Chevrolet Engineering Research Vehicle (CERV) is a series of Chevrolet experimental cars. Chevrolet Staff engineer, designer, and race car driver Zora Arkus-Duntov started development of the CERV I in 1959, and began work on the CERV II in 1963. Chevrolet chief engineer Don Runkle and Lotus' Tony Rudd discussed creating a new show car to demonstrate their engineering expertise in 1985; It would become the CERV III. Corvette chief engineer Dave Hill unveiled the CERV IV in 1993, a test vehicle for the 1997 C5 Corvette.

<span class="mw-page-title-main">Riley Nine</span> Motor vehicle

The Riley Nine was one of the most successful light sporting cars produced by the British motor industry in the inter war period. It was made by the Riley company of Coventry, England with a wide range of body styles between 1926 and 1938.

The following outline is provided as an overview of and topical guide to automobiles:

<span class="mw-page-title-main">Meillerwagen</span> Motor vehicle

The Meillerwagen was a German World War II trailer used to transport a V-2 rocket from the 'transloading point' of the Technical Troop Area to the launching point, to erect the missile on the Brennstand, and to act as the service gantry for fuelling and launch preparation.

The Rover 8 was a small single-cylinder 8 hp 1327 cc car made by the British Rover car company. It was Rover's first production car. It was remarkable for being supported by a backbone chassis rather than a conventional ladder frame. The first model was manufactured from 1904 to 1912. A Daimler-Knight sleeve valve engine option was available on the original model in 1911 and 1912.

<span class="mw-page-title-main">Yamaha FZ750</span> Japanese motorcycle produced 1985 to 1991

The Yamaha FZ750 is a sports motorcycle produced by Yamaha Motor Corporation between 1985 and 1991. The FZ750 is notable for several reasons, perhaps the most radical being the 5-valve cylinder head with a radial arrangement. This became something of a Yamaha trademark. The FZ750 would be the first bike in the Genesis design concept.

<span class="mw-page-title-main">Talbot 14-45</span> Motor vehicle

The Talbot 14-45 also known as Talbot 65 is a luxury car designed by Georges Roesch and made by Clément Talbot Limited in their North Kensington factory and usually bodied by fellow subsidiary of S T D Limited, Darracq Motor Engineering in Fulham. The car made its first appearance at the London Motor Show in 1926.

<span class="mw-page-title-main">Austin 25/30</span> Car model

The Austin 25-30 is a motor car. It was the first automobile produced by newly established British car manufacturer Austin.

<span class="mw-page-title-main">Car controls</span> Car parts used to control the vehicle

Car controls are the components in automobiles and other powered road vehicles, such as trucks and buses, used for driving and parking.

<span class="mw-page-title-main">Vauxhall 20-60</span> Motor vehicle

The Vauxhall 20-60 is a four or five-seater saloon, limousine, tourer or coupé-cabriolet manufactured by Vauxhall of Luton. It was announced on 28 September 1927 with a six-cylinder engine and a four-speed gearbox. A cautious move downmarket. "The first time any six-cylinder Vauxhall has been sold under £1000!" "British & Vauxhall". The initial 2.7-litre engine was enlarged to 3-litres after twelve months.

<span class="mw-page-title-main">Daimler Twenty-Two</span> Motor vehicle

Their new Daimler 22 horsepower full-size luxury car was first displayed by Daimler in April 1902 at The Automobile Club’s Exhibition in London's Agricultural Hall. Daimler had elected to drop their multiple old low powered designs and restrict themselves to this 22 horsepower and a pair of 9 or 12 horsepower cars to the same design as the 22 but more lightly constructed. The King’s not quite finished new Daimler 22 was reported to be the chief attraction of the show.

<span class="mw-page-title-main">4 VD 14,5/12-1 SRW</span> Reciprocating internal combustion engine

The 4 VD 14,5/12-1 SRW is an inline four-cylinder diesel engine produced by the VEB IFA Motorenwerke Nordhausen from 1967 to 1990. The engine was one of the standard modular engines for agricultural and industrial use in the Comecon-countries. Approximately one million units were made.

The Hillman Straight Eight and its successor the Hillman Vortic were moderate priced mid-sized 20 tax-horsepower executive cars made by Hillman from 1929 to 1930. The lowest priced eight-cylinder car on the market the car was scarcely in full production when sales were hit by the onset of the Great Depression.

This glossary of automotive terms is a list of definitions of terms and concepts related to automobiles, including their parts, operation, and manufacture, as well as automotive engineering, auto repair, and the automotive industry in general. For more specific terminology regarding the design and classification of various automobile styles, see Glossary of automotive design; for terms related to transportation by road, see Glossary of road transport terms; for competitive auto racing, see Glossary of motorsport terms.

References