This is a list of published [Note 1] International Organization for Standardization (ISO) standards and other deliverables. [Note 2] For a complete and up-to-date list of all the ISO standards, see the ISO catalogue. [1]
The standards are protected by copyright and most of them must be purchased. However, about 300 of the standards produced by ISO and IEC's Joint Technical Committee 1 (JTC 1) have been made freely and publicly available. [2]
ANSI C, ISO C, and Standard C are successive standards for the C programming language published by the American National Standards Institute (ANSI) and ISO/IEC JTC 1/SC 22/WG 14 of the International Organization for Standardization (ISO) and the International Electrotechnical Commission (IEC). Historically, the names referred specifically to the original and best-supported version of the standard. Software developers writing in C are encouraged to conform to the standards, as doing so helps portability between compilers.
IEC 61850 is an international standard defining communication protocols for intelligent electronic devices at electrical substations. It is a part of the International Electrotechnical Commission's (IEC) Technical Committee 57 reference architecture for electric power systems. The abstract data models defined in IEC 61850 can be mapped to a number of protocols. Current mappings in the standard are to Manufacturing Message Specification (MMS), GOOSE [see section 3, Terms and definitions, term 3.65 on page 14], SV or SMV, and soon to web services. In the previous version of the standard, GOOSE stood for "Generic Object Oriented Substation Event", but this old definition is still very common in IEC 61850 documentation. These protocols can run over TCP/IP networks or substation LANs using high speed switched Ethernet to obtain the necessary response times below four milliseconds for protective relaying.
ISO/TC 211 is a standard technical committee formed within ISO, tasked with covering the areas of digital geographic information and geomatics. It is responsible for preparation of a series of International Standards and Technical Specifications numbered in the number range starting at ISO-19101. The Chair of the committee was 1994-2016: Olaf Østensen; during 2017-2018: Christina Wasström; and from 2019 Agneta Gren Engberg.
ISO/IEC 20000 is the international standard for IT service management. It was developed in 2005 by ISO/IEC JTC1/SC7 and revised in 2011 and 2018. It was originally based on the earlier BS 15000 that was developed by BSI Group.
The ISO/IEC 27000-series comprises information security standards published jointly by the International Organization for Standardization (ISO) and the International Electrotechnical Commission (IEC).
ISO/IEC 19794 Information technology—Biometric data interchange formats—Part 5: Face image data, or ISO/IEC 19794-5 for short, is the fifth of 8 parts of the ISO/IEC standard ISO/IEC 19794, published in 2005, which describes interchange formats for several types of biometric data. ISO/IEC 19794-5 defines specifically a standard scheme for codifying data describing human faces within a CBEFF-compliant data structure, for use in facial recognition systems. Modern biometric passport photos should comply with this standard. Many organizations and have already started enforcing its directives, and several software applications have been created to automatically test compliance to the specifications.
ISO/IEC JTC 1/SC 37 Biometrics is a standardization subcommittee in the Joint Technical Committee ISO/IEC JTC 1 of the International Organization for Standardization (ISO) and the International Electrotechnical Commission (IEC), which develops and facilitates standards within the field of biometrics. The international secretariat of ISO/IEC JTC 1/SC 37 is the American National Standards Institute (ANSI), located in the United States.
